Buscar en el registro

Backing over a berm while dumping

Dumping the truck when the load shifted to the back causing truck to roll over.

Back dragging the ramp with the loader. Loader came to a sudden stop causing miner to hit head on the side window.

Was sitting in truck while being loaded and struck head on the steering wheel.

Employee said the Haul truck seat bottomed out going over a bump. The office was notified of the injury on 4/23/2018.

Employee was working in the hopper of the breaker when the skid loader approached with a drag attachment on the front, the attachment dropped off and struck him.

Loader was backing away from pile. While he was preparing to turn and move forward, a pickup drove in front of him. Person in pickup was taken to hospital for back pain and released. Missed 3 days of work, released with no restrictions.

Employee was walking up side bank to get to upper level. 980F loader bucket came into contact with employee. No visible life threatening injuries, called 911 per company policy. Employee was taken to hospital where they found a small puncture in lung, broken ribs, and bruising on chest and back.

Loader/scale operator running loader experienced pain in lower back. Did not report to office untill 3/30/2009. Went to doctor on 3/31/09, was released back to work with a 25 lb weight restriction.

Door slammed shut on hand. Fractured left ring finger. He was loading truck on trailer, truck shifted and door slammed shut.

Greasing stacker belt while it was moving. Standing between drive tires and transport tires. Fell and was run over, probably by drive tires. Left foot was crushed, right knee was lacerated.

He is a loader operator and has had problems with his back before. On July 26, 2007 he had back pain from using levers in loader. Missed work July 27th for Dr appointment. Returned July 30th for an hour and a half, then went home because of pain. Has not been released to full duty yet.

Operating loader, extending back to reach levers and steering, and noticed a sharp pain in his lower back. He missed 11 days of work and was released to come back 5/8/07 with 30 lbs. Lifting restriction. He had elective non-work related surgery on 5/8/07 and did not return to work until 5/15/07. He was released from lifting restrictions on 5/18/07.

EMPLOYEE WAS REHANGING A POWER CABLE TO PREVENT IT FROM RUBBING ON FRAME. A ROCK (APPROX 8") CAME OFF OF THE BELT AND STRUCK HIM ON THE HEAD. EMPLOYEE RECEIVED A MILD CONCUSSION. EMPLOYEE WAS WEARING A HARD HAT.

EE WAS WORKING ON A HEATER FAN. HE STUCK HIS HAND IN THE HOT AIR DISCHARGE CHANNEL AND CONTACTED THE ROTATING BLADE, CUTTING HIS RIGHT MIDDLE FINGERTIP.

EE WAS HAULING ROCK FROM QUARRY TO BREAKER AND REPORTEDLY NOTICED THAT HE HAD BACK PAIN & TROUBLE STANDING AND WALKING DUE TO ROUGH ROAD AND BOUNCING IN VEHICLE.

REPORTEDLY THE EMPLOYEE WHILE OPERATING A LOADER, BACK OVER A LARGE BOULDER. WHEN THE LOADER DROPPED FROM THE BOULDER THE EMPLOYEE WAS SEVERELY SHAKEN AND COULD NOT MOVE HIS RIGHT ARM.

EE DEVELOPED LOWER BACK PAIN FROM OPERATING LOADER, LOADING TRUCKS IN QUARRY PIT.

EE WAS ENTERING #3 TUNNEL TO THE UNDERGROUND AND HIT A CHUCK HOLE. THE TRUCK BOUNCED AND THE DRIVER'S SEAT BOTTOMED OUT JARRING HIS BACK, RESULTING IN A PINCHED NERVE AND A PULLED MUSCLE IN BA CK.

EE WAS FUELING DOZER AND WHILE ROLLING HOSE BACK ON TO THE FUEL TRUCK REEL THE CELENAID ON THE SWITCH STREET AND THE HOSE CONTINUED TO ROLL CATCHING THE EE LEFT RING FINGER AND BREAKING THE ON E AT THE TIP.

ANOTHER DRIVER FAILED TO SET THE BRAKES ON HIS TRUCK AND IT BEGAN TO ROLL AWAY TOWARD THE HAMMERMILL. EE RAN AND JUMPED THROUGH THE WINDOW, BANGING HIS RIGHT KNEE ON THE DOOR BEFORE STOPPING T HE VEHICLE.

EE OPERATES A SMALL 4UB TRUCK (EUCLID) EE WAS UNLOADING HIS TRUCK& WAS BACKED UNDER THE SMALL BIN. HE STARTED THE CONVEYOR & WAS WATCHING THE TRUCK GET LOADED. THE START-STOP BUTTON IS LOCATED CLOSE TOT HE TONGUE OF THE BIN. EE WAS STANDING IN THIS LOCATION WHENT HE BIN VIBRATED OFF THE SUPPORT THIS CAUSED TONGUE TO SWING AROUND

EE WAS LOADING OUT SHOT ROCK IN THE PIT AT CRESCENT QUARRY. HE WAS CLEANING UP THE ROCK IN FRONT OF THE LEDGE. HE SUDDENLY HIT THE LIMESTONE MATERIAL THAT WAS NOT LOOSE CAUSING HIM TO STOP ABR UPTLY HE INDICATED HIS NECK WAS SORE SO WAS TAKEN TO HOSPITAL JUST TO BE SURE HE WAS OK. EVERYTHING CHECKED OUT OK AND HE RETURNED BACK TO WORK.

EE WAS OPERATING HIS SCRAPER AT BEDFORD QUARRY. THE CONDITIONS AT THE QUARRY WERE SOMEWHAT DAMP. EE BOUNCED ACROSS SOME ROCKS AND AT THE SAME TIME COUGHED. WHEN HE DID THIS HIS BACK MUSCLES ST ARTED TO SPASM OR CONTRACT. EE WENT TO THE DR. AND WAS DIAGNOSED. EE MISSED 2 DAYS OF WORK.

EE WAS CLEANING UP MUD ON FLOOR OF POT. RAIN HAD WASH MUD DOWN AROUND AREA WHERE A SMALL SUMP WAS USED. AS EE RAN LOADER ACROSS FLOOR. THE BUCKET TIP CAUGHT EDGE OF SUMP. THE STOPPED HE ALMOST IMMEDIATELY. IT WAS DETERMINED THAT HE HAD HIS RIGHT HAND ON THE HOIST CONTROL LEVER WHICH JARRED HIS RIGHT SHOULDER.

EE WAS BACKING HIS EUCLID 4UD ON 1 1/2 CLEAN STOCKPILE. THE STOCKPILE WAS SMALL IN SIZE & WAS NOT PACKED AT EDGES. AS EE WAS BACKING HE GOT OVER TO FAR INTO THE BERN BEFORE HE STOPPED. ON STOP PING THE TRUCK HIS R REAR WHEELS SANK DOWN CAUSING THE WEIGHT OF THE TRUCK TO SHIFT. THE EDGE GAVE WAY & HE WENT OVER EDGE. SEAT BELT WAS ON. EE BRUSIED HIS SHOULDER.

SEE ATTACHMENT: INJURY APPROX 11/17/97? EE FIRST KNEW OF CONDITION 12/8/97. OFF WORK 12/17/97 THROUGH 1/21/98. * THIS INJURY HAS NOT YET DETERMINED TO BE WORK RELATED.

HAUL ROAD WAS QUITE SOFT. INJURED WAS DRIVING TO PIT TO BE LOADED. HE TOOK A WIDER THAN USUAL LINE & SOFT ROAD CAUSED TRUCK TO PULL. HE TRIED TO CORRECT BUT CONTINUED TO PULL. AS HE CONTINUED TO CORRECT ANOTHER TRUCK CAME IN OPPOSITE DIRECTION. WHEN TIRES TOOK HOLD TRUCK WAS SENT INTO PATH OF THE OTHER (LOADED) TRUCK. COLLISION CAUSED EMPLOYEE TO SUFFER CUTS/BUMPS. OTHER DRIVER OK.

EE WAS UNLOADING A LOAD OF PIT ROCK OUT OF HIS TRUCK BOX. HE HAD RAISED THE BOX A LITTLE TOO HIGH CUASING A LARGE AMOUNT OF THE LOAD TO SLIDE OUT. TO CORRECT THIS SITUATION, EE HE QUICKLY WENT TO MOVE THE HOISE CONTROL LEVER FORWARD, HE CAUGHT FORWARD TO SLOW THE FLOW RATE OF THE ROCK. ASHE WAS MOVING THE LEVER FORWARD HE CAUGHT THE SMALL FINGER ON HIS RIGHT HAND ON THE MIDDLE PUP

EE WAS ATTEMPTING TO REMOVE A 4 IN ROCK THAT WAS CAUGHT IN A SELF CLEANING TAIL PULLEY ON A HIGH SHAKER. THE ROCK WAS WEDGED BETWEEN THE PULLEY AND CONVEYOR BELT. EE GRABBED THE ROCK, PULLED I ON IT, THE ROCK TWISTED LOOSE AND HIS HAND WAS CAUGHT BETWEEN THE ROCK AND PULLEY. THIS RESULTED IN A LACERATION AND BRUISED FINGER.

THE INJURED PERSON WAS OPERATING AN ENDLOADER, LOADING TRUCKS WITH SHOT ROCK AND SPOIL SHALE IN A STRIPPING OPERATION. THE CONSTANT JARRING AND RUNNING ON ROUGH TERRAIN CAUSED A STIFF NECK ADN SORE SHOULDER.

THE INJURED PERSON WAS REMOVING SHOT ROCK OFF OF SHALE LOADING TRUCKS WITH AN ENDLOADER. THE JARRING AND TWISTING OF THE LOADER CAUSED STRESS TO HIS BACK.

THE INJURED PERSON WAS UP ON THE SCREENING PLANT TO SHUT DOWN AND CHANGE SCREENS. HE CAME DOWN OFF THE PLANT AND WALKED OUT FROM BEHIND THE LIME BIN INTO THE PATH OF A STOCK-PILE TRUCK RETURNI NG FROM DUMPING HIS LOAD. THE TRUCK WAS ESTIMATED AT GOING AT A SLOW RATE OF SPEED, LESS THAN 5 M.P.H. THE TRUCK STRUCK HIM WITH THE LEFT FRONT BUMPER, KNOCKING HIM DOWN, THEN THE LEFT FRONT

WHILE DRIVING A3TRUCK FROM MILL TO THE STOCKPILE AREA, THE DRIVER BECAME ILL WITH HEAD-ACHES FROM INHALING EXHAUST FUMES.

DISMANTNLING RI1-RAP SCREENING PLANT.INJ LIFTING ONE END OF 12'' X 12'' X 5'.TO MOVE IT OUT OF THE WAY OF FRONT LOADER WHICHWAS GOING TO LIFT PIECE OF EQUIP.LOADER STOPPED AT THE TIME.OPERATY OR MIS-INTERPRE7ED HANDSIGNAL AND MOVED LOADER HAHEAD HITTING BLOCK OF WOOD AND PUSHING T INTO CONVEYOR PINNING INJ PERSONS HAND BETWEEN BLOCK AND WOOD AND CONVEYOR.

INJURED WAS CARRYING FINISHED PRODUCT-CRUSHED STONE- FROM PLANT TO STOCKPILE AREA WHEN DUMP TRUCK COLLIDED WITH ANOTHER STOCKPILE TRUCK.