Buscar en el registro

A haul truck was backing into the crusher dump pocket and did not notice a loader already in the dump pocket. The truck's rear tire came into contact with the rear of the loader, jarring the operator in the cab of the loader.

EE was pulling under the lime silo at the final loadout. When the operator pulled under the lime silo, the front of the truck bed contacted the dispensing sock creating a cloud of lime in the air. The operator had their window down about 6 inches, and the lime blew into the cab, onto the operator's face, and into the left eye. antibiotic ointment was prescribed

The employee was performing general labor near a conveyor structure. The employee's left hand was on the structure. The employee's left hand slipped and was pinched between the conveyor belt and roller.

An employee cut his middle left finger on the blower fan in the ceiling vent of a 992 D loader when the vent fell off, requiring stitches.

An employee ran a stop sign and drove his pickup truck into a steel structure support on a crusher structure.

The operator of 436 haul truck was in the process of dumping on a waste dump berm when his truck went through the berm rolling twice approximately 70 feet in distance before landing on all four tires. The employee was complaining of pain in the right ribs spreading lateraly to the back. Also a contusion to the right eye and minor cuts and scrapes on the upper extremities.

Employee was cleaning up rock by A-belt when a rock fell off the A belt convyer and struck the employee on the right side of his back.

LOADING A 777 HAUL TRUCK, LOADER OPERATOR WAS PULLING AWAY FROM THE FACE WITH THE LOADER WHEN SOME MATERIAL FELL OFF OF THE FRONT OF THE BUCKET.

PIPE WRENCH WAS USED TO TURN CONVEYOR SHAFT. OPERATIOR TURNED ON CONVEYOR, WHEN IT STARTED TOSSED PIPE WRENCH INTO HELPER'S FACAE CUTTING HIS CHIN.

THE EE WAS BACKING UNDER A LOADER WITH AN 85 TONHAULTRUCK TO BE LOADED. HE WAS LOOKING BACK TO HIS LEFT SIDE WHEN THE LOADER STARTED TO PUT MATERIAL INTO THE TRUCK. A LARGE ROCK JARRED THE TRU CAUSING STRAINED MUSCLES TO THE TRUCK DRIVER'S NECK & SHOULDERS. AFTER A MRI SCAN ON 1/4/96, WE LEARNED ON 1/25/96 THAT THE EE HAS A BULDGING DISC & A HERNIATED DISC.

EMPLOYEE STATES: AS SHE WAS BACKING UNDER THE LOADER SHE THOUGHT THE BUCKET WAS ALL THE WAY UP. THE TRUCK BED HIT THE BUCKET. EMPLOYEE COMPLAINED OF NECK PAIN & WAS MEDICALLY EVAUATED ON 12/5/ 94, WITH CERVICAL SPRAIN/STRAIN.

EE LEANED AGAINST THE BACK OF A PARKED COMPANY TRUCK WHEN IT POPED OUT OF AREA & STARTED TO ROLL HE TRIED TO GET IN TO STOP IT & SLIPPED HIS RT LEG GOT CAUGHT UNDER THE REAR BUMPER SMASHED H IS RT HIP & THIGH

OPERATING A BOB CAT UNDER 3 BELT DIRT FELL OFF GETTING IN EE RIGHT EYE.

EE WAS INJURED WHEN THE HAUL TRUCK HE WAS DRIVING OVER TURNED AFTER HITTING AN ICY PATCH ON THE SOUTH WEST DUMP. WEATHER CONDITIONS WERE THE MAIN CAUSE OF THE ACCIDENT. APPROX. 3 INCHES OF SNO W HAD FALLEN IN AN 8 HOUR PERIOD PRECEDING THIS ACCIDENT, ALONG WITH POOR VISIBILITY DUE TO BLOWING SNOW AND FOG. ALL OPERATORS AND DRIVERS HAD BEEN WARNED ABOUT ICY ROADS EARLIER IN THE SHIF

IT IS ALLEDGED THAT INJURED, TRUCK DRIVER, UNIT NO. 407, HIT A SOFT SPOT IN HAUL ROAD TO LEACH PAD CAUSING THE TRUCK TO BOUNCE AND INJURED HIS BACK.

WHILE TRYING TO SHOUT A WARNING TO OTHER NEARBY BY VEHICLE THE CRANE OPERATOR ACCIDENTALLY HIT THE RELEASE PART OF LEVER THAT KEPT TOP WINDOW IN VERTICAL POSITION ALLOWING WINDOW TO FALL ON LE FT HAND BREAKING LEFT LITTLE FINGER BETWEEN 1SR AND 2ND JOINTS.

WHILE DRIVING TRUCK ON THE HAUL ROAD THE BOUNCING MADE MY BACK START TO HURT.THE ROAD HAD A LOT OF HOLES AND WAS VERY ROUGH.INJURY WAS NOT REPORTED TO SHIFT SUPERVISOR.

EMPLOYEE WAS OPERATING HAUL TRUCK AT THE TERTIARY LOAD-OUT.SHE ALLEGED SHE HAD TO PULL THE TRUCK ONTO A SPILL IN ORDER TO GET IT UNDER THE BELT.IN DOING SO THE HEAD-ACHE RACK OF THE TRUCK STRU CK LOAD-OUT.THE EMPLOYEE HAS NOT RETURNED AS OF YET SO THE FINAL DETERMINATION ON ACCIDENT CAN BE MADE.THIS IS UNDER INVESTIGATION.

EMPL USING HAMMER TO ADJUST RETURN IDLER ON A-BELT.MISSED IDLER CAUSING HAMMER TO COME IN CONTACT WITH MOVING BELT.HAND AND HAMMER PULLED INTO FRAME CAUSING INJURY.

WHILE DIGGING OUT TAIL PULLEY ON UNDERSIZE BELT SHVEL GOT CAUGHT IN THE BELT AND EMPLOYEE HIT HIS LEFT HAND ON THE FRAMEWORK BETWEEN INDEX J MIDDLE FINGER INFECTION HAS IEVELPED AND THIS HAS B ECOME A LOST TIME CASE AEM.

WHILE GREASING 6EARING EMPLOYEE LOST HIS FOOTING AND REACHED INTO V-BELT WHILE WAS IN OPERATION.

EMPLOYEE ALLEGE8 USING TOO SHORT A BAR WHILE PRYING ROCK FROM JAW OF PRIMARY CRUSHER.LOOSE ROCK FROM FELL FROM CONVEYOR STRIKING LT FOREARM,RESULTING IN SMALL LACERATION TO LT FOREARM REQUIRIN G THREE STITCHE8.

THE EMPLOYEE TO2K THE FUEL TRUCK INTO AN AREA THAT WASTO NARROW AND STEEP TO BE OPERATED SAFETY IN ORDER FUEL UP A DRILL. HE FUELED THE DRILL THEN HAD TO BACK DOWN THE NARROW ROAD WHERE HE LOS T CONTROL OF TH9 TRUCK CAUSING IT TO GO OVER THE EDGE OF THE ROAD. THE EMPLOYEE JUMPED FROM THE TRUCK AND BROKE HIS LEFT FOOT. THE FUEL TRUCK WAS NOT TO BE OPERATED ON THAT ROAD.

I,NAME WAS OPER5TING FORKLIFT WHEN HE DISEMBARITED TO ASSIST OTHER EMPLOYEE MOVE 3 IN X 3 IN X 2-6 SQUARE STUCK ONTO FORKS. IN SLIDING SQUARE STUCK ONTO FORKS A PIECE OF OLD BANDIAY MATERIAL L YLING UNDER SQU5RE STUCK SPRUNG & CUT JACKS LEFT ARM. DAMAGE WAS CUT ARTEY, NERVE & 2 TENDONS.