Buscar en el registro

HE WAS LIFTING ON BELT WHILE BELT SET UP WAS BEING MADE. HURT HIS BACK.

INJURED WAS OPERATING SCOOP ON HAULWAY SAID SCOOP BOUNCED AND HURT HIP AND BACK DID NOT REPORT INJURY UNTIL 11-3-89

I,NAME WAS BOLTING FIRST CUT OUT OF #3 ENTRY THE FIRST BOLT WHEN BOLT DRILL STEEL AND UP PRESSURE HIT A CRACK IN ROOF ROCK CAUSING ROCK TO SLIP OFF ON ATRS AND APRON AND THEN ONTO OPERATOR PIN NING HIM UNDER ROCK & AGAINST THE BOLTER BREAKING HIS RIGHT FOREARM & BRUISING HIS LEFT SHOULDER.

AREA OF THIS MINE IS 15 YRS OLD TOP WAS BOLTED WITH WOODEN HALF HEADER THERE WAS SEAM PRESENT THESE WAS THE CONDITIONS THAT CONTRIBUTING FACT TO THE ROOF FALL

ROOF FALL

ROOF FALL

ACCIDENT VICTIM WAS PREPARING TO INSTALL ROOF BOLTS WHEN KETTLE BOTTOM FELL STRIKING VICTIM AND CAUSING SERIOUS FACIAL AND SCALP LACERATIONS.UNDETECTED KETTLEBOTTOM MEASURED 66" LONG,52" WIDE, FROM 0" TO 16" THICK.

WALKING BELT FELT MUSCLE CRAMPS IN SHOULDER.

HE WAS TRAMMING HIS CAR IN A BREAK OUTBY FACE LOST CONTROL AND HIT RIB.

EMPLOYEE STATED THAT HE WAS SHOVELING ROCK ON THE BELTLINE WHEN A PIECE OF ROCK FELL STRIKING HIM FROM HIS KNEES TO HIS CHEST.

HE WAS BOLTING TOP, DRILLING TEST HOLE, WHEN DRAW SLATE FELL ABOUT 3' BY 5' HITTING HIM ON SHOULDER, KNOCKING HIM INTO BOLTER HEAD.

EMP WAS BOLTING TOP AND WAS PRESSING ON A BOLT WITH HIS LEFT FOT TRYING TO GET BOLT STARTED IN DRILLED HOLE AND SOMETHING HAPPEDNED TO HIS BACK CAUSING SEVERE PAIN.

EMPLOYEE STATED THAT HE WAS ROCKDUSTING AT THE FENCE LOCATED AROUND THE BELTHEAD AND GOT HIS LEFT ARM CAUGHT IN THE WIRE IN THE FENCE THAT GOT CAUGHT IN THE BELTHEAD CUTTING HIS LEFT EAR AND C RUSHING HIS LEFT ARM

EMPL WAS LOADING ONSIDE SHUTTLE CAR PREPARING TO LEAVE FACE AREA OF #4 HEADING WHEN LOOSE DRAW SLATE FELL ON LEFT SHOULDER & NECK.

EMPLOYEE WAS OPERATING ROOF BOLTER WHEN A PIECE OF ROCK FELL STRIKING EMPLOYEE IN THE TOP OF THE HEAD HURTING HIS NECK AND BACK

EMPLOYEE STATED3THAT HE WAS SHOVELING THE BELT LINE AND GOT HIS SHOVEL CAUGHT IN THE BELT, CATCHING HIS LEFT ARM AND LEFT HAND BETWEEN THE BELT AND BOTTOM ROLLER. BREAKING 2 FINGERS ON HIS LEF T HAND. 3

I.NAME WAS UNDE9F #1 BELT BOOM WENT BELT ROLLER WAS BEING REPLACED ROLL SLIPED OFF BOOM & STRUCK I.NAME ON RT.SIDE OF HEAD THIS ACCIDENT HAPPEN ON THE OUTSIDE

AT START OF SHI0T WENT TO CHECK FAN AND READ WATER GAUGE FOUND THAT WATER GAUGE HAD WENT UP 1/10 UPON INVESTINGION FOUND ROOF FALL AT SPAD #1706 20' BY 20' BY 2 1/2' ON RETURN AIRWAY.

EMPLOYEE STATED3THAT HE WAS PULLING ROOF BOLTING CABLE AND PULLED SOMETHING IN HIS BACK.

70'OUTBY SPAD #1590 ROOF FALL 4'THICK X 30'LONG X 18'WIDE.

HE WAS TRAMMING3LOADER FROM #5 HEADING TO #4 HEADING AND GOT LOADER TOO CLOSE TO RIB.

EMP WAS GETTING3OFF RAM CAR HE WAS OPERATING AND SLIPPED AND FELL AGAINST IT HURTING HIS RIBS

EMPLOYEE WAS GE7TING READY TO CROSS OVER TAILPIECE WHEN HE TRIPPED AND FELL ON A BOLT THAT WAS STICKING OUT OF THE TAIL PIECE CAUSING INJURY TO HIS LEFT KNEE.

WE WERE POURING3CONCRETE IN HOLE IN HOUL ROAD AND SMOOTHING IT DOWN WITH SHOVELS I NAME GOT THROUGH A HOLE IN ONE BOOTH CAUSING A RAW SPOT & SWELLING OF FOOT.

I NAME, THE ROO0 BOLTER OPERATOR, WAS DRILLING THE ROOF WHEN A SMALL PIECE OF ROCK JARRED LOOSE AND FELL AND CUT HIS LITLE FINGER ON LEFT HAND REQUIRING STITCHES TO FIX IT

ROOF FALL IN #43ENTRY OUTBY 4TH OPEN BREAK IN INTERSECTION ABOUT 3' X 16' SQUARE

LIFTING BELT ST9UCTURE OUT OF TRACTOR CAR AND PULLED BACK SHOULDER MUSCLE.

WHILE CHANGING A FLAT TIRE ON THE CX1 SS SCOOP. HE HURT HIS BACK WHILE LIFTING ON THE WHEEL HE HURT HIS BACK.