Equality Coal

The employee was assisting a contract mechanic install a track on a dozer, the contract mechanic hit the alligator link on the track with a sledge hammer and a piece of the hammer splintered off and hit the employee in the arm.

The employee was dismounting a Cat skidder when he slipped and fell on the last step causing an injury to his back.

The employee fell on snow covered and frozen ground injuring his lower back.

using a ladder to change oil filter - while reaching for filter the ladder tipped over sprained right ankle

Employee was traveling from the parking area to the PC800 Track hoe that he was going to operate, when he reached his destination he stepped out of the F-350 man trip van and stepped into a hole or on a rock and turned his right ankle.

Slipped in mud twisted back.

EE was removing grease in the tub of Unit #347 dragline when he started feeling light headed, ee and another ee exited the tub of the dragline to get some water upon getting the water ee collapsed and struck his chin on the floor of the dragline causing a laceration. he was transported by ambulance to O.C.H. where he received eleven stitches

Employee was in the process of replacing the drag ropes on Dragline, he was removing the u-bolts that attach the new cable to a wooden spool. As he pried the u-bolt out, the cable spun on the spool and the end of the cable hit him on left shoulder resulting in a fractured shoulder blade. As he fell he sprained his left wrist also.

Employee was operating a 773F haul truck and stated the bed was bouncing up and down when empty, causing him to injure his lower back. Employee did not Communicate to anyone that he was injured until 04/29/2014.

Employee was operating a 777F Haul Truck, and sometime during the shift employee injured his back, employee did not report the incident until 3/1/14. Employee stated the incident actually occurred on 2/14/14.

Employee's truck was in the maint. area, his truck had just been in for repair. He proceeded to do his pre-op check on the truck when he lost his footing and sprained his knee.

employee stepped on an uneven surface and dislocated his left knee.

truck traveling up ramp front end came up turning over on its side

A mechanic was installing brakes on a piece of equipment using a pry bar to hold tension on brake shoes while he inserted the rollers when the bar slipped catching his finger causing a small cut on it.