Norris Aggregate Products Co.- E: 8 citaciones de la MSHA Metal/Non-Metal

Employee was using a garden hose to water down the area around the scales to keep the dust down. She stepped down a slight incline and slipped. She fractured her ankle when she slipped.

Employee was preparing to mount a cutting edge on a FEL. The cutting edges were shipped on a palet stacked three high. Employee was sliding the top cutting edge off of the stack. His finger was caught between the two cutting edges. The cutting edges weigh approx. 350 lbs. apiece. Employee sustained a cut that required stitched and a broken finger. Both were to the same finger.

EE WAS UNHOOKING A CHAIN FOR A PUSH ARM FOR DOZER THAT WAS TORE DOWN TO MOVE. WHEN HE UNHOOKED THE CHAIN THE PUSH ARM ROLLED OVER ONTO HIS FEET& CHIPPED A BONE IN HIS FOOT RESULTING IN RESTRI CTED DUTY.

EE WAS CHANGING A SCREEN. WHILE LOOSENING THE NUT ON ONE OF THE BOLTS HIS FINGER WAS PINCHED BETWEEN THE WRENCH AND ANOTHER BOLT CAUSING A LACERATION TO HIS FINGER REQUIRING STITCHES.

IMPACT PLUGGED UP, AS THE EE WAS CLEANING IT OUT A ROCK ROLLED AND HIT HIS LITTLE FINGER CAUSING A LACERATION REQUIRING THREE STITCHES.

EE'S WERE REPLACING SKIRT BOARD, WHEN HANDING ITDOWN TO ANOTHER EE ON THE GROUND IT SLIPPED OUT OF EE'S HAND AND HIT EE ON THE GROUND KNOCKING HIS HARD HAT OFF AND CAUSING A LACERATION TO BAC K OF HEAD REQURING 6 STITCHES.

EMPLOYEE WAS SHOVELING ROCK OFF OF A CONVEYOR WHEN HE ENCOUNTERED LOWER BACK PAIN

EE WAS KNEELING ON GROUND CUTTING A 1" HOSE SHE MADE THE FIRST CUT AWAY FROM HERSELF. SHE THEN TURNED THE KNIFE AROUND AND FINISHED CUTTING PULLING THE KNIFE TOWARDS HERSELF WHEN IT SLIPPED AN D POKED HER IN THE LEG CAUSING A CUT REQUIRING 2STITCHES.

EMPLOYEE WAS SIMPLY WALKING ACROSS QUARRY GROUND AND HURT HIS BACK.

EMPLOYEE WAS SCOOPING CONCRETE AROUND IN A FORM. THE CONCRETE GOT OVER HIS BOOTS, CAUSING BURNS TO BOTH ANKLES.

EMPLOYEE GOT INTO HIS TRUCK & FELT A PAIN IN HIS GROIN AREA WHILE SITTING DOWN APPARENTLY HE RUPTURED HIS LEFT TESTICLE

EMPL PICKED UP WOODEN BLOCK. INSTEAD OF MOVING FEET AROUND TO SET IT DOWN HE ROTATED BACK WHICH RESULTED IN PULLED MUSCLE IN BACK.

EMPLOYEE WAS CHANGING BROKER STRIKING BAR.THE HAMMER CAME DOWN PINCHING HIS THUMB BETWEEN IT AND THE STRIKER BAR,BREAKING THE DISTAL PHALANGE ON HIS LEFT THUMB.

EMPLOYEE WAS BLOWING OFF SCREEN PLANT TO CLEAN IT UP. WHILE CLIMBING OFF PLANT HE STEPPED OVER AN AIR TRACK. HE SLIPPED STRIKING HIS KNEE ON THE TRACK CUTTING HIS KNEE REQUIRING 5 STITCHES.

EMPLOYEE WAS OPERATING SCRAPPER. HIS BACK STARTED HURTING ON 1/9/91 IT CONTINUED TO GET WORSE. HE FINALLY REPORTED THIS TO HIS SUPERVISOR ON 1/15/90. EMPLOYEE HAS SUFFERED A DISK INJURY.

EMPL FELL FROM TRUCK LADDER WHILE ENTERING CAB.

WHILE DRAWING HYDRAULIC LEGS UP ON A SURGE BIN, EMPLOYEE GOT FINGER CAUGHT BETWEEN LEG AND TUBE.

EMPL HAD GREASE & DIRT ON HANDS. EMPL RUBBED EYE GETTING GREASE & DIRT IN LEFT EYE.

WHILE BEING LOADED IN THE PIT A ROCK APPROX 6" FELL THROUGH THE WINDOW HITTING THE SIDE OF THE DOOR BOUNCING OFF AND STRIKING THE SIDE OF HIS FACE

EMPLOYEE WAS CLEANING OFF THE OVERHEAD BELT AND WHILE CLIMBING DOWN HE SLIPPED AND HIT HIS KNEE ON THE WALKWAY. EMPLOYEE CRACKED A PIECE OF KNEE CAP.

EMPLOYEE WAS RUNNING THE PLANT BY THE IMPACT CRUSHER HE STEPPED OUT OF THE BOOTH TO WATCH SOME LARGE ROCKS FEED INTO THE CRUSHER AND WAS HIT IN THE LIP BY A SMALL ROCK THAT FLEW UP FROM THE CRUSHER

EMPLOYEE TWISTED ANKLE WHILE CLIMBING OUT OF FRONT END LOADER.

EMPL WAS CHANGING CUTTING BITS ON A DOZER THEY WERE REMOVING THE OLD BIT AND AS HE MOVED IT THE BACK OF HIS L HAND CAUGHT A BURR ON THE MOLE BOARD CAUSING A LACERATION

EMPLOYE WAS HELPING CHANGE HAMMER TIPS. HE REACHED INTO THE MILL AS ANOTHER EMPLOYEE WAS TRYING TO DRIVE A HAMMER OUT; A HAMMER TIP THEN FELL ON HIS FINGER RESULTING IN A LACERATION.