Employee attempted to replace starter on Hyster H50XM forklift, jacked forklift up with a 10 ton hydraulic floor jack. He did not put any blocks or shorwings under forklift to prevent it from falling. He then got under forklift to repair starter and forlift then fell off jack causing major head injuries. Employee died.
Drowning Creek Dredge & Plant Metal/Non-Metal
Seguir esta mina
Avísenme cuando se presente un nuevo incidente de la MSHA en Drowning Creek Dredge & Plant.
- Muertes
- 1
- Incidentes totales
- 11
- Años en registro
- 2001–2023
- Último incidente
- Apr 2023
Muertes en esta mina
1 registradasIncidentes reportables
10 en archivo (excluyendo las muertes anteriores)2023 · 1 incidente
2 miners were removing a dolly from a storage silo, when the last bolt was cut, the dolly rolled striking 1 miner in the torso. EMS was called, but said it would be 25 minutes ETA, miner was transported to ER via work truck.
2022 · 1 incidente
A MECHANIC WAS INFLATING A TRUCK TIRE WITH A STANDOFF DEVICE INSIDE THE MAINTENANCE SHOP. THE SIDEWALL OF THE TIRE BLEW OUT AT 60-70 PSI, KNOWN AS A ZIPPER FAILURE. DEBRIS STRUCK THE MINER IN THE FACE. WE TRANSPORTED EE TO THE ER WHERE EE WAS RELEASED AND ASKED TO RETURN THE NEXT DAY. EE RECEIVED SURGERY ON 11FEB2022.
2013 · 1 incidente
EE was getting out of truck and there was some ice on the step of the truck and he stepped down on step, foot slipped, EE fell on left knee. His left knee was bruised.
2008 · 2 incidentes
EE was changing screen on motor on classifer, when coming down steps, foot slipped because he had mud on shoes. EE slid down 5 steps and right arm got caught or hung on stair rail, causing him to pull his right shoulder. He was also holding his tool box in right arm at time of fall. He however, landed on his feet.
EE was loading sand on out dump truck , when he was getting out of the truck, he jumped from the drivers compartment to the ground, spraining his lower back.
2007 · 1 incidente
The lifting lug was only welded in one spot of the 6' X 12' X 1/4" plate steel. This caused the plate steel to be too weak and unbalanced, therefore, it fell on EE when the forklift tried to move it. EE should have welded both sides of the plate steel. The steel plate weighed approx 500-700 lbs, causing EE lower back trauma.
2004 · 1 incidente
He was hauling mud to reclamation site, ran over nerm and off into ditch full of water and mud. The tractor part stuck in mud, the trailer was standing upright and rolled over in mud also.
2002 · 2 incidentes
EMPLOYEE WAS SHOVELING ROCK BACK INTO GRAVEL WASHER, EE WAS BENDING OVER AND STRAINED LOWER MIDDLE BACK.
EE WAS WORKING ON DUMP TRUCK OUTSIDE & SOME SAND FLEW INTO HIS LEFT EYE BECAUSE OF STRONG, HEAVY WINDS. HIS EYE BECAME INFECTED AFTER GOING TO URGENT CARE ON 2/6/02. ON 2/14/02 HE WENT TO CARO LINA EYE FOR MINOR SURGERY ON HIS UPPER & LOWER LID ON THE LEFT EYE.
2001 · 1 incidente
EE PULLED THREE DRAWERS OF TOOL BOX OPENED AT SAME TIME CAUSING AN OUT OF BALANCE SITUATION. TOOL BOX WEIGHS 1000 LB.