OPEN CUT - LEAD Metal/Non-Metal

INJURED PARTY TWISTED NECK CLIMBING DOWN FROM LOADER.

WALL FAILURE AT 4640 BENCH. APPROXIMATELY 300 FT. IN LENGTH TO A DEPTH OF 30 FEET. ESTIMATED MASS OF 250,00 TONS. WORK HAD BEEN STOPPED PRIOR TOFALL DUE TO INDICATIONS OF GROUND MOVEMENT PICKE D UP BY MONTORING SYSTEMS AND VISUAL INSPECTIONS. MINING ACTIVITIES HAVE BEEN SUSPENDED.

SUBJECT FELL FROM DECK ON D-10 DOZER WHILE WORKING ON IT IN SHOP.

EE PULLED MUSCLE IN SHOULDER WHILE TENSIONING ROCK BOLT CABLES.

EMP FELL, CUT HAND.

FELL GETTING OFF SCRAPER, HIT CHEST ON BUMPER & LANDED FLAT ON HIS BACK, EQUIPMENT WAS SLICK WITH ICE, MUD & SNOW.

EE STEPPED DOWN OFF OF A CONVEYOR AND TWISTED HIS ANKLE.

EMPLOYEE STATES HE WAS WALKING UP AN INCLINE TOWARD HIS DOZER. HE STEPPED ON A ROCK AND INJURED HIS BACK.

CHANGING CUTTING EDGE ON LOADER BUCKET CUT HIS HAND.LATER HE WENT INTO GET STITCHES.WE WERE NOTIFIED OF THIS ON 09-13-96.

3 EMP'S WERE SCALING A PREVIOUSLY BLASTED AREA. EMP WAS POSITIONED TO THE RIGHT SIDE OF A LARGE ROCK. THE 3 WORKERS HAD ATTEMPTED TO PRY THE RODK LOOSE, HOWEVER IT WOULD NOT MOVE. EMP MOVED TO THE RIHGT AND LOWER SIDE WHEN THE ROCK FELL STRIKING HIS LEFT LEG.

A PIECE OF STEEL HIT EE BETWEEN RING FINGER AND MIDDLE FINGER WHITE TAKING OFF A PIECE OF BROKEN PLATFORM ON 9L DOZER #917.

SORE LOWER BACK FROM RUNNING EQUIPMENT OVER THE YEARS.

EE WAS CLEANING ON WELD, GOT UP AND WALKED AWAY, AND FELT SOMETHING IN LT. EYE, FOREIGN MATERIAL IN EYE.

CLIMBING ON #2 BELT TO REMOVE WOOD, HIT MIDDLE OF BACK ON DUST CONTROL PIPING.

LIFTING 80 LB. D-10 TRACK PAD FROM TIRE TRUCK, GETTING A HERNIA ON RT. SIDE.

CUTTING A PIECE OF RED RUBBER, RAN BELT KNIFE ACROSS RIGHT LEG.

PULLED MUSCLE IN LOWER BACK AND RT. KNEE WHILE LOADING PLASTIC PIPE OR PUSHING CABLE BOLTS IN WEST WALL.

HE WAS REPLACING HOSE ON TIRE TRUCK, GOT A PIECE OF DIRT OR RUST IN RIGHT EYE.

GRINDING, WELDING ON DEMAG IN RT. WHILE GRINDING, THE WIND BLOWED, DUST OR SMALL GRINDING IN EYE.

PAIN IN RIGHT SHOULDER- WAIST- ARM FROM OPERATING HEAVY EQUIPMENT OVER THE YEARS.

BRUISED LT. HAND, WAS HOLDING PUNCH TO TAKE OUT BRUSHING ON SHOVEL, WHILE COWORKER WAS SWINGING SLEDGE HAMMER.

WHILE OPERATING A DOZER, THE DOZER SLIPPED OFF A ROCK, PULLING A MUSCLE IN EE'S LOWER BACK.

ADDING RODS TO IN HOLE ROD STRINGS. ROD SLIPPED OUT OF ARM, LANDING ON EE'S FOOT.

BRUISED, MAYBE A BROKEN BLOOD VESSEL, INDEX FINGER COLD, BLUE, BLACK, WENT TO DR.

INSTALLING WHEELS ON LUBE TRUCK, USED AIR WRENCH& SOME AIR BORN FORIGN MATTER GOT INTO RIGHT EYE.

BOUNCING IN BLADE OVER ROUGH HAUL ROADS AND BLADING ROCK IN PAD AREA IN PIT.

BOTH WRIST SORE FROM CONTROLS ON DEMAG SHOVEL. OPERATING SHOVEL LAST WEEK, WRIST DIDN'T GET ANY BETTER.

WELDING ON CAB OF TRUCK, GRINDING AREA, AND FOREIGN MATERIAL (METAL), GOT INTO RT EYE.

PULLED MUSCLE IN BACK BETWEEN SHOULDER BLADES. DID THIS PULLING LADDER UP ON DEMAG SHOVEL. WARMING UP EQUIPMENT BEFORE SHIFT STARTED.

OPERATING DID DOZER IN ROCKY AREA, BOUNCING AROUND, SORE NECK, LEFT SHOULDER, WENT TO DR ON 3-15-95.

EE WAS BARRING ON RT. FENDER THAT THEY WAS REMOVING FROM 777 HAUL TRUCK UNIT 601 THE FENDER CAME DOWN ON RT FOOT. SMASHING CUTTING BREAKING TWO TOES ON RT FOOT.

EE GOT A PIECE OF FOREIGN MATERIAL IN RT EYE WASHED & HE RUBBED HIS EYE HAD ABRASION IN RT EYE

A SMALL PIECE OF FOREIGN MATERIAL IN EE RT EYE, FROM A GRINDER.

SUDDEN MASSIVE UNPREDICTABLE FAILURE OF EAST HIGHWALL RESULTED IN THE ACCIDENT.THE FALLING SLIDING ROCK CRUSHED THE 5130 SHOVEL KILLING THE OPERATOR.IT ALSO SERIOUSLY IMPACTED THE 85 TON TRUCK BEING LOADED WITH RESULTING HEAD AND LEG WOUNDSTO THE DRIVER.

INPSECTING PIPE ROLLERS WITH PIN BAR, HIS ARM WAS SUCKED INTO THE ROLLERS. THIS INCIDENT WAS ORIGINALLY A MINOR INJURY, BUT HE HAD SKIN GRAPHTING DONE 8-3-94 AND IS NOW OFF WORK.

EMPLOYEE WAS DOWN INSIDE A MANHOLE DIGGING OUT SOME DIRT AND ROCK THAT GOT PUSHED INTO MANHOLE, TWISTED WRONG AND STRAINED BACK.

EE WAS GETTING PARTS AT BUTLER MACHINERY AND THE WIND WAS BLOWING BLOWED SOME DIRT INTO EE S LETFT EYE.

OPERATING FUEL TRUCK COMING DOWN RAMP FROM DRILLS HIT A BUMP GOT LOWER SORE BACK

KNOCKING A PIECE OF STEEL FROM TRUCK BOX (A DOG). THE STEEL FLIPPED INTO THE AIR, KNOCK HIS HARD HAT OFF, AND HITTING HIM IN THE HEAD.

UNLOADING PANEL FROM TRUCK, PUTTING IN A PILE, THE TOP ONE SLIPPED OFF HITTING DAVE IN LEG.

EE WAS WALKING BACK WANDS AND FELL OVER A 4' HIGH WING WALL OF TUNNEL. PUTTING BACKFILL IN BEHIND WALL.

LIFTING REBAR GOT MUSCLE SPASM.

SPRAINED LOWER BACK PUTTING ON CUTTING EDGES.

LIFTING CONVEYOR BELTING TO GO INSIDE TUNNEL.

LOW BERM TO CHOSE TO OUTEDGE AT ORE DUMP THE 85 TON HAUL TRUCK WENT BACKWARD OVER THE EDGE AND LANDED ON ITS FOR ABOUT 25 FT BANK. EE WAS OPERATOR AND HE JUST HAD COUPLE OF BRUISES WAS USING A SPUTTER.

LOADING LUMBER ON LFAT BED TRUCK, GOT DUST OR PIECE OF CONCRETE IN RIGHT EYE. WAS EYE OUT, DR. FOUND NOTHING IN EMPLS. EYE.

EMPLOYEE WAS REMOVING THE BELLY PAN FROM THE LOADER WHEN IT SLIPPED EMPLOYEE TRIED TO CATCH PAN & JAMMED HIS WRIST RESULTING IN A BROKEN RT WRIST

EMPLOYEE WAS WALKING ON UNEVEN GROUND AND HYPEREXTENDED HIS LEG.

EE WAS ROLLING A ROCK OUT OF THE WAY, AND PUTTED LOWER PELVIS OUT.

SOMETHING POPPED IN LT KNEE LIGAMENT SPRAIN 05-24-93 SURGERY LT KNEE

PUTTING PIN IN CURL CYL. PIECE OF HAMMER CAME OFF, AND HIT LEFT ARM. SMALL LACERATION, FOUR STITCHES.

LIFTING STEEL PLATES, ABOUT 50 LBS, PULLED A MUSCLE IN LOWER BACK. STRAINED MUSCLE.

BURNED POLE COMING DOWN, HOOKS HIT SOFT PART OF POLE & THEN I SLID DOWN THE POLE SCRAPING POLE WITH MY FACE.

WHILE WELDING AND CHIPPING GOT FOREIGN MATERIAL IN LT EYE. HE WAS WEARING EYE PROTECTION.

EMPL WITH 3 MOS EXPERIENCE PARKED VEHICLE LEAVING IT RUNNING BECAUSE OF COLD WEATHER. DIDNT CHOCK WHEELS OR SHUT OFF AND SET HAND BRAKE. VEHICLE ROLLED ABOUT 1' BACKWARDS PINNING EMPL BETWEEN STATIONARY DOOR AND THE BUMPER OF TRUCK. EMPL BRUISED LEG ABOVE KNEE.

EE SLIPPED ON SOME ICE, AND LANDED ON HIS RT SHOULDER. WENT TO SEE A DOCTOR ON 1/6/93.

EMPLOYEE WAS WORKING ON THE EDGE OF A PILE AND A ROCK ROLLED DOWN THE PILE AND STRUCK THE EMPLOYEE IN THE ANKLE RESULTING IN A SEVERE SPRAIN.

STEPPED INTO A DOOR OPENING ON DECK OF A DRILL WHERE SAMPLE PAN GOES. WHILE HE WAS WASHING THE DRILL, HE STEPPED INTO THE HOLE.

GETTING READY TO LOAD A DRILL STEEL ONTO ANOTHER TRUCK AND WHEN OTHER TRUCK CAME ALONG SIDE OF HIS SERVICE TRUCK.THEY RAN OVER THE END OF DRILL STEEL AND POPPED IT UP HITTING INJURED IN THE SH

ARTHRITIS OF THE SHOULDERS FROM HEAVY LIFTING OVER THE YEAR'S SHOULDER JOINTS.

WORKING ON A CONVEYOR BELT BETWEEN TWO PILES OF GRAVEL AND THE WIND WAS BLOWING AND I.NAME GOT SOME DIRT OR SMALL PIECE OF GRAVEL IN HIS RT EYE.

INJURED WAS REMOVING A FILTER WHEN HIS WRENCH SLIPPED HITTING HIM IN THE MOUTH.THIS CAUSED LACERATION INSIDE HIS MOUTH AND ONE BROKEN TOOTH.THEY STITCHED HIS MOUTH INSIDE.

SLIPPED ON ICE AND STRAINING MUSCLES IN NECK WHEN LOADING A DRILL BIT INTO BACK OF SERVICE TRUCK.

REPLACING BEARING CAP.HE DROPPED THE BEARING CAP ON RIGHT RING FINGER.SMASHING HIS FINGERS AND HAD FOUT STITCHES IN HIS RIGHT RING FINGER.

OPERATING A DN CAT IN A ROCKY AREA AND BOUNCING AROUND IN THE ROCKS PUT INJUREDS NECK AND LOWER BACK OUT OF PLACE HAD TO GO TO A CHIROPRACTOR TO GET PUT BACK INTO PLACE.HIS NECK AND LOWER BACK .

HELPING TO PUT A TRACK BACK ON A D9L CONT.PULLED A MUSCLES IN LOWER PART OF HIS BACK.WENT TO DR ON 03-12-90.

PUTTING A TURBO IN UNIT #950 CART LIFTING TURBO INTO PLACE INJURED HURT HIS BACK ABD PAIN WENT DOWN HIS RIGHT LEG.

SLIPPED ON A SMALL ROCK LAYING ON THE SLOPE ON CONCRETE GOING INTO CARREL WITH AIR TRACK DRILL.PULLED MUSCLE IN LOWER BACK JUST ABOVE TAILBONE.

SHUTTING OFF A WATER VALVE FILLING WABCO WATER TRUCK TO WATER HAUL ROADS FOR DUST CONTROL

GETTING DOWN FROM SHOVEL MISSED STEP AND FELL 12' CRACKED 2 RIBS ON LEFT SIDE.

CHIPPED A TOOTH WHILE ROLLING A GAS CYLINDER TO PUT IN RACK. SLIPPED IN SNOW.

HELPING TO CHANGE SKID PLATE ON BUCKET OF LOADER. LIFTING WRONG, PULLED MUSCLES IN LOWER BACK AND UPPER PART OF RT. LEG.

KNEELING DOWN TO WORK ON A PIECE OF EQUIPMENT & A SMALL PIECE OF METAL WORKED INTO XXLT KNEE & GOT INFECTED

THE INJURED AND HIS PARTNER WERE CUTTING LINTEX RUBBER FOR USE IN A CHUTE.THEY WERE USING A ULITITY KNIFE WHICH SLIPPED AND CUT HIS RIGHT KNEE.

CUT OFF THE END OF INDEX FINGER ON LEFT HAND, WHILE CHANGING DOZER BLADE.

BRUISED FOOT FROM ROCK DROPPING.

PRESSING A PIN INTO THE BOGGIE OF A CAT, THE PIN BROKE ON THE PRESS AND HIT VICTIM JUST BELOW, THE RIGHT EYE FRACTURED THE BONE ON THE RIGHT SIDE OF FACE.

A OLD DRAW HOLE OPENED UP UNDER THE CAT LETTING THE CAT DROP DOWN BOUNCING I.NAME AROUND

STEPPING DOWN FROM TRUCK, EMPOYEEE STEPPED ON A ROCK TWISTING HIS BACK.

WHILE LIFTING A 5 FT DRILL STEM,RUBBED HIS STOMACH MUSCLES.

WHILE GETTING LOADED A LARGE ROCK HIT THE INSIDE OF THE TRUCK BOX BOUNCING THE TRUCK THE BOLT PULLED THE MUSCLE IN HIS LOWER BACK.

CLEANING OFF CONVEYOR BELT AND POPPED HIS NECK OUT OF PLACE.

CHANGING BUCKET8 AND WEAR PLATES ON 992 LOAD.

I.NAME WAS STAN8ING BETWEEN THE STEPS OF A ST A IR SECTION THAT WAS LAYING HORZ., ON A RECEIVING PLATFORM, PROCEEDED TO RIB THE SECTION FOR HOISTING INTO POSITION WHEN THE STAIR SECTION SHIFTE D PINNING HIS L9G BETWEEN THE STEPS & THE RECEIVING DOCK, BREAKING HIS L LEG

CHANGING WEAR P5ATE ON 992 LOADER BUCKET LIFTING THE NEW WEAR PLATE INTO PLACE.

EMPLOYEE WAS GR3NDING STEEL WHEN GRINDER SLIPPED OUT OF HIS HAND AND RAN ACROSS HIS GLOVED HAND GIVING HIM A MINOR CUT ON HIS KNUCKLE OF HIS LEFT HAND.

INSTALLING REVE9SE CIRCULATION ONTO DRILL.RT. FOOT PINNED BETWEEN PIPE WRENCH ANPLATFORM.

WHILE WORKING O3 BLADE IN ONE BAY,I.NAME WAS GRINDING ON D9L IN NEXT BAY AND PIECE OF STEEL FROM GRINDING HIT IN LEFT EYE.

JUMPED IN HOLE 7WISTED KNEE

WHILE GREASING 2N A DRILL, I,NAME SLIPPED ON WET STEEL, STRAINING HIS BACK.

DRIVING A DUMP 7RUCK UP ELLISON HILL THE BROWNIE POPPED OUT OF GEAR AND BROKE AN AXLE AND BRAKES WOULD NOT HOLD THE LOADED TRUCK. CAME DOWN THE HILL HITTING A STEEL GATE POST

ON COMMPRESSING3THE SPRING SEGMENT FOR THE ST CONE THE COMPRESSION BAR SLIPPED OUT TOWARDS JACK I.NAME JUMPED BACK TO AVOID BEING HIT AND BUMPED AGAINST THE MOTOR WITH HIS TAIL BONE

PULLING WATERR 5INE DOWN HILL ,HE SLIPPED ON SOME ROCKS AND HURT HIS RT. KNEE.

SMASHED HIS HAN8 WHILE PULLING ON A TORQUE WRENCH THAT WAS ATTACHED TO A TOURQUE MULTIPLIER THE TORQUE SLIPPED OFF THE BOLT CAUSING HIM TO SMASH HIS HAND BETWEEN WRENCH AND THE STEEL COMPONATE