MAYVILLE LIMESTONE, INC. Metal/Non-Metal

Employee was cutting a rubber replacement piece when the knife slipped and cut EE's right thigh open.

Person was reloading staple gun. When returning to operations they pressed the trigger and put a staple into hand.

Cleaning out rail car and tripped on a piece of bent metal and twisted ankle/foot

Cutting rubber for screen. Knife slipped and cut leg.

At the bottom of the steps going down from the V screens, missed the last step and rolled an ankle.

Scraping the screen and scraper hit a stone and stopped and EE jammed wrist.

EE was working on the bulldozer when EE lost EE's footing and bumped EE's leg on a metal object. EE started having swelling & redness in that area of EE's shin a couple weeks later. EE seeked medical attention & it is an infection and doctor prescribed an antibiotic & at least 3 days off work.

Employee was cleaning up some scrap metal and he was lifting a metal cabinet when the cabinet fell and it fell on his finger. When the cabinet fell it put a deep cut in his finger.

Reassembling V-screen driveshaft. While adjusting tension on a lift plate using overhead crane, lift plate unexpectedly shifted and pinched tip of thumb under a large nut used to hold lifting plate.

Employee was measuring the depths of the holes for blasting. The ground was wet & muddy, so when the loader backed up a stone flew out from under the tire and hit Employee in the left leg(shin). He fell to the ground scraping up his right leg & knee.

Employee was driving the loader when he drifted off the road when he was hanging up his microphone for the CB and when he drifted off the road he hit a rut in the road and hit his head on the rops cage in the loader.

Employee was removing boards with hammer/pry bar when the board broke loose and he slipped and fell into the wall onto his shoulder. Had an MRI done a few weeks later and found out he has a detached rotator cuff which he has a surgery scheduled for May 20th. Employee and employer did not find out extent of injury till 4/22/13.

He was hooking chain up to loader to pull stone out of crusher, he slipped and bumped his right shoulder on loader bucket.

Working on Kawasaki loader. Pinched thumb in battery box area of loader. Finger bled due to minor laceration which required stitches provided at local medical clinic by attending physician.

CHANGING SIZE ON CRUSHER. PINCHED TIP OF RING FINGER ON LEFT HAND BETWEEN CONTROL & CRUSHER.

BENOVER TO LIFT A CHUTE & STRAINED HIS BACK.

DROPPED A BEARING RING AN DIT HIT IN THE BACK OF EE.

WHILE MOVING A SHEET OF STEEL IT TIPPED KNOCKING EMPLOYEE DOWN AND FALLING ON HIS LEGS.

WAS CLEANING FROZEN MATERIAL WITH A SHOVEL WHEN HE SLIPPED AND IT CAME BACK AND HIT HIM ABOVE RIGHT EYE. THE CUT REQUIRED STITCHES TO CLOSE.

WIND BLEW METAL AND RUST CHIPS IN RIGHT EYE.

PULLED MUSCLE IN GROIN AEA WHILE TIGHTENING A BRAKE ON A GONDOLA

HURT BACK WHILE LIFTING A BUNDLE OF PAPER BAGS.

PUTTING A PLATE3INTO A CHUTE CUT A FINGER ON THE RIGHT HAND REQUIRING STITCHES

PUTTING A PLTE 3N A CHUTE SCRAPED SKIN ON THREE FINGERS ON LEFT HAND & BROKE ONE OF THE FINGERS

STRAINED BACK WHILE REPAIRING TRUCK

STRAINED BACK WHILE LIFTING SCREW CONVEYOR.