Mc Dermitt Mine Jv: 16 incidentes reportables Metal/Non-Metal

UNKNOWN CAUSE. HE WAS PERFORMING TYPICAL ELECTRICAL DUTIES , TROUBLE-SHOOTING AND WIRING A MOTOR. HE NOTICED DISCOMFORT IN EYE AFTER WORK, ABOUT 11:00 PM AND 4:30 AM THE NEXT DAY.

I.NAME WAS HOLDING A PUNCH & I.NAME WAS SWINGING A HAMMER TO DRIVE OUT LINER BOLTS ON BALL MILL I.NAME WAS HOLDING PUNCH WITH HIS RT.HAND & GUIDING IT WITH HIS LEFT WHEN I.NAME MISSED PUNCH & STRUCK I.NAME LEFT HAND

WHILE INSTALLING CUTOUTS ON THE ON THE FLOT CELL MANWAY FOR A NEW VENTILATION SYSTEM ON THE FLOTATION CELLS, HE STEPPED IN A 7"X21" CUTOUT ON THE FLOOR GRATING. AT THE TIME HE WAS LEANING OVER TO PASS A DRILL TO ANOTHER WORKER. BECAUSE HIS HANDS WERE FULL AT THE TIME HE LOST HIS BALANCE. HE WAS UNABLE TO STOP FALLING AGAINST THE SHEAVE AND AIR MANIFOLD ASSEMBLY. THIS RESULTED IN 2

LOST HIS BALANCE ON UNSTABLE SLOPE MATERIAL.

I NAME WAS GRIN8ING ON THE UNDER SIDE OF THE CIRCLE WITH A HAND GRINDER WHEN THE ACCIDENT ACCRUED.WORKING OVERHEAD IN UNBALANCED POSITION THE GRINDER KICKED BACK.THE ROTATING GRINDING DISC HIT HIM IN THE LOWE9 LEFT ARM.

WHILE FILLING U1 A 3 GALLON BUCKET OF PEBBLE QUICKLIME SHE TWISTED OR OVER EXTENDED HER LOWER BACK. SHE WAS IN A REACH STRECH OUT PULL IN SORT OF BUCKET REFILL OPERATION. NEXT TIME A SHOVE L SHOULD BE USE8.

I,NAME HAD STOPPED FOR HIS BREAK. HE WAS SEATED IN SCRAPER 616. OTHER EMPLOYEE WAS ANNOYED BY I,NAME LEAVING HIS SCRAPER IN REVERSE AND ALLOWING THE BACKUP ALARM TO CONTINUALLY OPERATE. I,NAME HAD A CUP OF COFFEE IN HIS HAND AND HIS LEFT FOOT UP ON THE DASHBOARD. OTHER EMPLOYEE STRUCK THE STINGER OF I,NAME\S SCRAPER WITH THE BLADE OF HIS DOZER CAUSING I,NAME TO STRAIN HIS BACK, ALT

SHARP EDGE OF STEEL CUT THROUGH EMPLOYEE GLOVE AND HAND WHILE HE WAS IN THE PROCESS OF SETTING PART ON TROLLEY HAD HE PUSHED ON VERY END OF THE PART IT PROBABLY WOULD NOT HAVE CUT HIM.

I.NAME ALONG WITH BELOW WITNESSISS, WAS STANDING NEXT TO A TABLE WHERE I.NAME & I.NAME WERE WORKING ON 5-HP MOTOR AND SWAMP COOLER PARTS WHEN THE ROTOR OUT OF THE 5-HP ELECTRIC MOTOR STARTED TO ROLL OFF OF THE TABLE. I HAD JUST WALKED UP TO THE TABLE, REACHED OUT TO STOP IT, BUT IT FELL OFF THE TABLE SO I LET IT GO. I.NAME ALSO REACHED OUT TO STOP IT AND TRIED TO STOP IT BEFORE I

JOHN WAS DISCONNECTING THE CABLES FROM THE GROUND BY JERKING ON THE CABLES WHICHCAME OUT OF THE SOCKET ON 618 HITTING JOHN IN THE MOUTH CUTTING HIS LIP AND KNOCKING ONE FRONT TOOTH LOOSE.

CLIFF WAS CLEANING OUT THE MILL TROMMEL OF CLEANOVERSIZE MATERIAL ROCK THE MILL WAS TURNING AT THE TIME AS THE SHOVEL WAS FULL AND EXTENDED FROM HIS BODY HIS LOWER BACK WAS STRAINED WHEN HE WE NT TO DUMP THE SHOVEL

GARFIELD STRUCK A FRONT END LOADER BUCKET TOOTH WITH A HAMMER TO DISLODGE IT. A SMALL PIECE OF METAL SPALLED OFF AND STRUCK HIM IN THE FOREARM CAUSING THE INJURY.

WORKING ON CYCLONE FEED PUMP BEARING BARREL AND SHAFT-225 LBS. OTHER EMPL USING DEAD BLOW HAMMER,EMPL USING BRASS DRIFT,DRIVING BEARINGS IN PLACE.BOTH WORKING TOWARD TOP OF BEARING WHEN HAMMER HIT RIGHT INDEX FINGER CATCHING IT BETWEEN HAMMER AND BRASS DRIFT.

BROWN WAS OPERATING SCRAPER 617 WITH THE DOOR OPEN THE ROADS WERE GETTING DUSTY AND HE CLOSED THE DOOR SMASHING H-IS THUMB BETWEEENTHE JAMB AND THE DOOR ITSELF

INJURY WAS CAUSED BY CHAINHOOK-SCREEN ASSEMBLY ON TAILINGS POND DECANT TOWER INADVERTENTLY DISLODGING, PINCHING FINGER AGAINST THE TOWER.