Shawnee Quarry Metal/Non-Metal

WHILE TIGHTENING WEDGES IN A SYMONS 5 1/2 FT STANDARD CONE CRUSHER EE USED A 20 BLS SLEDGE HAMMER. UPPER MUSCLES WERE SORE THE NEXT DAY.

EE WAS CLOSING DOOR ON HAUL TRK WITH HIS RIGHT HAND ON FRAME OF DOOR. AS HE CLOSED THE DOOR HE CAUGHT RIGHT RING FINGER IN DOOR WHICH CUT TIP OF FINGER

WHILE LINING BEARING BOLT HOLES ON A CONVEYOR WITH A DRIFT PUNCH EE WAS STANDING BY COWORKER TO PUT BOLT IN HOLE. COWORKER HAD THE DRIFT PUNCH IN ONE OF THE BOLT HOLES. THE DRIFT PUNCH SLIPPED OFF OF THE BOLT HOLE AND STRUCK EE UNDER HIS RIGHT NOSTRIL OF HIS NOSE.

EE WAS CUTTING SOME SKIRT RUBBER WHEN KNIFE SLIPPED AND CUT HIS THUMB. THUMB REQUIRED TWO STITCHES.

EMPLOYEE WAS HEAT DRYED GREASE ON THREAD OF A 5 1/2 SHORTHREAD CRUSHER WITH A PROPANE TORCH. HE START SCRAPING THE GREASE WITH A SMALL SCRAPPER THE SCRAPPER HIT A BOLT AND THE GREASE SPLASH UP ONTO HIS RIGHT HAND. THIS RESULTED IN 2ND DEGREE BURN.

EE WAS WASHING OUT THE TAILPULLY OF A CONV. HE LIFTED THE SWING UP TAILPULLY GUARD WHILE THE CONV WAS STOPED TO WASH IT OUT. APPROX. 30 MINS. LATER HE FELT PAIN IN RIGHT SHOULDER.

EE WAS CLEANING THE INSIDE OF THE BOWL WITH A AIR SANDER PREPARING IT FOR THE REPLACEMENT OF THE BOWL LINER. WHEN HE FINISHED HE FELT SOMETHING IN HIS RIGHT EYE. HE WENT TO THE DR. TO HAVE THE EYE CHECKED. THE DR. REMOVED A SMALL PIECE OF METAL.

EE WAS WALKING FROM PARKING AREA TO THE SHOP BEFORE SHIFT STARTING TIME, SLIPPED ON SNOW AND ICE FELL ON HIS BACK.

EMPLOYEE WAS STARTING TO OPERATE THE KOMATSU GRADER HE PLACED HIS LEFT ARM ON THE ARM REST WHICH HAD A BEE ON IT THE BEE STUNG HIS LEFT ARM BETWEEN THE ELBOW & WRIST

EMPLOYEE WAS DRIVING A ;1990 CHEVY 1/2 TON PICKUP TRUCK ON THE MINE PROPERTY WHEN AN INSECT STUNG OR BIT HIM ON THE BACK THIS HAPPENED AT APP 10:00AM IN THE MORNING HE START FELL HOT DIZZY & V ERE SICK TO HIS STOMACH HE WAS TAKEN TO RIVERSIDE HOSPITAL

EMPLOYEE WAS FINISHING JOB OF CHANGING SCREENS ON #4 SCREEN. HE AND ANOTHER EMPLOYEE WRE PUSHINGON A STEEL PLATE TO SWING IT SHUT. EMPLOYEE LOST HISFOOTING AND WITNESS COULDN'T HOLD IT BY HI MSELF. THE PLATE FELL OPEN HITTING INJURED'S LEFT FINGER. THE FINGER GOT SMASHED BETWEEN THE PLATE AND A HAND RAIL.

EMPLOYEE WAS CUTTING A PIECE OF SKIRT RUBBER WITH A UTILITY KNIFE. HE WAS HOLDING SKIFT RUBBE RWITH HIS LEFT. HE HAD CUT TO DEEP THE BLADE WNE THROUGH THE RUBBER AND CUT HIS LEFT HAND BETWEEN THUMB AND 1ST FINGER.

CRUSHER WAS PLUGGED. EMPLOYEE WAS USING A BAR TO PUSH STONE OUT OF THE CRUSHER. HE JAMMED HIS LEFT THUMB INTO THE EDGE OF MANTLE.

EMPLOYEE WAS HAULING SAND FROM YARD TO STOCK PILE DOWN IN PIT. WHILE TRAVELING DOWN HAUL RAMP, TRUCK BEGAN TO SLIDE. EMPLOYEE LOST CONTROL OF TRUCK WHILE IT WAS SLIDING AND THE TRUCK ROLLED OV ER ON ITS RIGHT SIDE. HAUL RAMP HAD BEEN WET DOWN TO CONTROL DUST. TRAVELING SPEED OF HAUL TRUCK MAY HAVE BEEN A CONTRIBUTING FACTOR.

PIT LOADER WAS RAISING BUCKET TO LOAD PIT TRUCK. FRONT WHEEL RAN UP ON A ROCK. TIRE SLID OFF ROCK JERKING LOADER TO SIDE. THE OPERATOR WAS TWISTED IN SEAT. HE HAS A BACK STRAIN. WAS WEARING SE AT BELT.

EE WAS TAKING ANGLES OF WELDING TRUCK TO PUT IN SHOP CAUGHT FINGER BETWEEN ANGLE AND WELDER CUTTING LEFT INDEX FINGER.

EMPLOYEE WAS WORKING INSTALLING NEW CHUTES AT #1 SCREEN LIFTING BENDING, TURNING, HURT HIS BACK. REOCCURRENCE OF INJURIE DATED 9-11-89 10:15AM.

GET OUT OF BED OF FORD PICK UP HIS FOOT SLIPPED OFF BUMPER AND HE FAIL INJURING HIS KNEE.

EMPLOYEE USING A PRY BAR TO PRY ROCKS OUT OF OVERLOADED SCREEN,WHEN BAR SLIPPED AND EMPLOYEE CUT HIS FINGER ON SCREEN,REQUIRING STTICHES TO CLOSE CUT.

USING CRANE TO SET MANTLE BACK IN PLACE WHILE IT WAS CENTERING ITSELF IN ECCENTRIC BUSHING EMPL WAS HELPING TO GUIDE IT IN. MANTLE STOPPED & COCKED. CRANE WENT TO PICK UP ON MANTLE. EMPL HAD H OLD OF IT IT TWISTED & SHIFTED AGAINST STONE SHIELD EXERTING PRESSURE ON FINGERS. EMPL HAD ON GLOVES & PULLED BACK.

EMPLOYEE WAS IN THE PROCESS OF CHECKING THE CRUSHER. HE WENT TO PULL THE DOOR OF THE CRUSHER OPEN. THE HANDLE ON THE DOOR BROKE LOOSE FROM THE DOOR. THE EMPLOYEE FELL BACKWARDS STRUCK HIS HAND AND ARM ON THE GUARD RAIL.

OPERATOR STEPPED OUT OF LOADER AND STEPPED ON TOP OF FUEL CAB, BEFORE STARTING DOWN LADDER. HE TWISTED HIS LEFT ANKLE WHEN HE STEPPED OFF FUEL CAP.

EMP. WAS USING A FRONT END LOADER TO CLEAN THE AREA AROUND THE PLANT. WHILE USING THE LOADER, HE MANEUVER INTO AN AWKARD POSITION. HE PUT THE LOADER INTO REVERSE TO A LEVIATE THE PROBL EM. HE SIAD THE LOADER JARRED HIM WHEN HE PUT THE MACHIE INTO REVERSE.

BRIGHT SUNNY AFTERNOON. THE EMPLOYEE AND ANOTHER WERE REPAIRING COVER PLATE ON WEIGH SCALE AT SCALE HOUSE, WORKING CLOSELY TO EACH OTHER.

INJ BRUISED KNE9 ON STEERING COLUMN ON A PIT TRUCK .(OR KNEELED DOWN ON ROCK TIGHTENING BOLTS ON TOP OF CRUSHER WHILE USING AIR IMPACT WRENCH).

WAS USING GRIND9R & WAS HIT IN RT.EYE WITH A PIECE OF METAL EMPLOYEE WAS GRINDING A ROUGH PLACE ON IMPELLER SHAFT WHEN A PIECE OF METAL FLEW IN BEHIND HIS SAFETY GLASSES

WORKING ON ELEC7RIC FAN MOTOR TRYING TO FREE BEANINGS WAS SPINNING FAN BLADE WITH FAN UNPLUGGED TO CHECK BEAVING NIGHT FINGER BETWEEN BLADE AND FAN FRAME CUT INDEX FINGER ON LEFT HAND.

WAS HOLDING PUN7H IT CUT HIS FINGER.DOES NOT KNOW HOW HE DID IT.

RUNNING LOADER 5ND HIT ROUGH PLACE IN FLOOR WITH BUCKET BLADE.TURNING WHEEL AND STOPPING LOADER HE SLID OFF SEAT AND HIT RIBS AGAINST STEERING WHEEL.

WE WERE USING A3SPUD BAR TO CLEAN ROCKS BETWEEN TAILPULLEY & CONVEYOR BELT. EE STUCK HAND BETWEEN CONVEYOR BELT & TAILPULLEY TO PULL OUT ROCK. ROCK SLIPPED & PINNED HAND BETWEEN CONVEYOR BE LT & TAILPULLEY1 FRACTURED THUMB ON RIGHT HAND PEELED OFF SKIN ON RING FINGER OF RT HAND.

INJURED WAS ATTEMPTING TO PERFORM ENGINEERING WORK ON CONVEYOR HE SLIPPED AND FELL APPROX 25 STRIKING HEAD ON CONTERWEIGHT BACK ON SUPPORT AND THEN FELL TO GROUND INJURED HAD BROKEN 7 TH VERTE BATE LACERATION ON HEAD, BACK STRAIN MULTIPLE CONTUSIONS AND ABRASIONS.