Buscar en el registro

While working under the bucket of a wheel loader noticed that one of the braces against the cylinder of the bucket was unstable. While resolving this, one of the braces came loose and struck EE in the left eyebrow and shoulder, causing EE to fall back into a bolt rack. This caused bruising on EE's shoulder and lower right back with some bleeding from the left eyebrow.

Foreman attempted to lift a heavy piece of plant equipment and injured right bicep.

Two Miners and one supervisor were installing 24" x 25' plastic pipes. Normally equipment is used to place pipes, but this was impossible due to the location of this specific section of pipe. Miners were physically moving the pipe into place by hand. Miner felt lower-right back and leg pain while lifting and pushing pipe into place.

Employee had spend Monday 12/12/16 working on a crushing plant, climbing up and down ladders to track conveyor belts. On Tuesday 12/13/16 EE was climbing up the quarry truck to start it. EE swung EE's leg up on the step and felt a pop in EE's back.

Installing oil pressure line on cone. Tightening hose and felt back twinge. Crawled out and told crew he hurt his back. Stayed at work until 9 am and then went home to rest because he could not move. He went to the clinic on 12/9/14. Work status off until Friday when he should be seen for a follow up appointment. Injury: back sprain/strain.

During the previous 3 days (June 16-18), EE had been working on a project pulling a lot of hose. He felt discomfort and pain from the pulling in his groin and behind the belt area. He though it might just have been indigestion, but the pain increased and was reported on 6/19/14.

Moving a board over his head, sliding it, then a big couple of popping noises came out of his arm and then it felt like something tore in his forearm.

Lifted up hatch door over the hydraulic pumps to check hose. Went over and released the pressure off hydraulic tank. Door was straight up & down jammed into postion. Went to check hoses again and leaned on the door. The door cam loose and fell open. Hand slipped and got caught on inside latch of the door.

Ee had a knife lying amongst his tools in his drill - he went to move his tools & he caught his finger on knife.

EMPLOYEE WAS SHOVELING WET SAND IN OUR SUSSEX PIT AND WENT TO TURN SIDEWAYS AND THEN FELT SOMETHING PULL IN LOWER BACK.

WORKING ON LOADER & WAS PINCHED BETWEEN LOADER TIRE & CRANE.

EE WAS CLIMBING THE 475 LOADER TO CHECK TO SEE IF THE HEATER WAS PROPERLY INSTALLED. EE HAD TO PULL HIMSELF UP THE LOADER, DUE TO NO STAIRS ON THE LOADER AND AS HE DID THIS HE PULLED SOME MUSC LES IN HIS LOWER BACK AS HE REACHED THE TOP OF THE LOADER.

EE WAS PICKING UP AN 8 LB ROCK OUT OF A SKIDSTEER BUCKET. AN 85 LB ROCK FELL ON TOP OF EE S RIGHT HAND OUT OF THE SKIDSTEER BUCKET. EE S RIGHT THUMB WAS HIT AND APPEARS TO BE BRUISED AND POSSI BLE BROKEN BONES.

EMPLOYEE REPORTED RIGHT KNEE PAIN WHILE STANDING ON THE CATWALK OF A HAUL TURKC AFTER CLOSING THE CAB DOOR WITH HIS RIGHT HAND.

EE WAS ASSISTING IN THE REMOVAL OF BOLTS FROM A CRANE CARRIER DRILL. HE WAS POSITIONED UNDER THE MAST AND WHEN HE STRAIGHTENED UP, HIS HEAD HIT AGAINST THE LIGHT MOUNTED ON THE MAST. HE EXPERI ENCED PAIN IN HIS NECK. DIAGNOSED AS NECK STRAIN

ON 08-22-95 EMPLOYEE WAS LIFTING AGLIME BAGS FROM PALLET WHEN HE FELT A PAIN IN HIS RIGHT GROIN LATER THAT DAY HE AGAIN EXPERIENCED PAIN IN THAT AREA WHILE LOADING BOXES INTO HIS TRUCK HE WE NT TO A PHYSICIAN WHO DIAGNOSED PAIN AS A HERNIAEMPLOYEE IS CONTINUING TO WORK WITH LIFTING RESTRICTIONS UNTIL SCHEDULED SURGERY DATE OF 09-18-9 5

STARTED 4-28-95, FRIDAY, WHEN DOING STRENDOUS WORK WAS SORE OVER THE WEEKEND. AS OF TODAY, WEDNESDAY, 4-3-95, EE WAS WORKING ON THE FEEDER OF CRUSHER TAKING BIG BOLTS OFF & HIS BACK HURT. IT I S HARD FOR HIM TO WORK IN CONDITION.

WHEN EMPLOYEE ATTEMPTED TO LIFT A 4FT RAILROAD TIE WITH ANOTHER EMPLOYEE HE FELT A SHARP PAIN ON HIS LEFT SIDE MEDICAL EXAMINATION REVEALED A LEFT INGUINAL HERNIA

ON 10/17/94 EE WAS HELPING REPLACE TURBOS ON A LOADER. AS HE WAS LEANING OVER TO PLACE A CHARGERON THE ENGINE HE FELT A PULL IN HIS ARM. THE INCIDENT WAS NOT REPORTED UNTIL MARCH OF 1995. ON M AY 15, 1995 HE SOUGHT PHYSICAL THERAPY TREATMENT

LACERATED LINER ON A ROCK WHILE GETTING ROCK UNSTUCK FROM PLANT.

PULLED MUSCLE ARM WHILE LIFTING.

EE WAS FILLING UP FUEL CONTAINER FOR A FELLOW EE WHO RAN OUT OF FUEL IN HIS TRUCK IN THE PROCESS THE NOZZLE OF THE CONTAINER SQUIRTED FUEL IN THE FACE AND EYES.

WORKING PUTTING BELT ON CONV CAUGHT FINGER IN PULLEY

EE BENT OVER TO PICK UP A PIECE OF A METAL STRAP. THE STRAP WAS 18X1 AND WEIGHED LESS THEN 1/2 LB. HE REPORTED THAT WHEN HE BENT OVER HE FELT SIGNIFICANT PAIN IN HIS BACK AND WAS UNABLE TO STA ND. HE WAS TAKEN TO THE HOSPITAL AND WAS DIAGNOSED AS HAVING A LUMBAR SPRAIN. THE PHYSICIAN PLACED HIM ON NO WORK STATUS. HE STATED THAT HE HAD SOME BACK PAIN 4 DAYS PRIOR BUT HAD NOT INFORME

EMPLOYEE WAS ADJUSTING THE SCREEN ON THE CRUSHER. TURNED WRONG THROWING HIS BACK OUT.

EMPL WAS LATE FOR WORK. EMPL WAS REPARING & CLAIMS WHILE LIFTING STEEL HE STRAINED BACK.

LIFTING STONE.

EMPLOYEE WAS REPAIRING ENDLOADER WHEN THE DRIVE SHAFT FELL ON HIS HAND INJURING HIS FINGER.

DOING REPAIR WORK.

MOVING A STONE.

EMPLOYEE WAS HELPIGN REPAIR JAW, WHEN BEARING FEEL ON HS FOOT. IT DIDN'T BOTHER HIM UNTIL 2 WEEKS LATER. HE DID NOT REPORT THIS TO OFFICE.

EMPLOYEE WAS CLEANING CONE CRUSHER. DUE TO HIS SIZE AND THE SIZE OF CONE. HE TWIST HIS BACK AND PINCHED A NERVE IN HIS BACK.

EMPL WAS SHOVELING AAROUND CRUSHER BUT DID NOT KNOW HE WAS INJURED UNTIL 2 DAYS LATER WHEN IT BOTHERED HIM.

EMPLOYEE WAS HELPING TO CLEAN OUT BIN IN THE CRUSHER- LIFTED A HEAVY ROCK AND SPRAINED MID BACK.

EMPLOYEE WAS SUPPORTING ONE END OF A 21FT SECTION OF PIPE WHILE ANOTHER EMPLOYEE WAS THREADING THE OTHER END THREADS DID NOT CATCH ALLOWING PIPE TO FALL PINCHING EMPLOYEES HAND BETWEEN AN AN GLE IRON & PIPE

EMP STATES THAT3WHILE PUCHING OVER PALLETS DURING COURSE OF WORK DAY HE STRAINED HIS BACK AND LEFT FLANK