Buscar en el registro

The EE was in the bagger area stacking one load of 50lb bags on pallets. As they lifted their arm, they felt their right elbow go numb. Later in the day the EE started to feel pain in their right shoulder.

Employee was using a pulley and chain when the chain Slipped and struck left thumb.

Employee was stretch wrapping a supersack when it became unbalanced and tipped over pinning employee between supersack and crossbeam-railing.

In mid-March employee was raising the roll up garage door when the door roll caught on the roll cover causing the chain to stop moving. The employee indicated that the left middle finger flexed when the chain stopped and was sore. On May 19,2022 employee indicated that the finger was still sore and was seen at doctors office.

EE suffered a small cut on the right index finger while removing a bearing from a shaft on 02/22/22. On 03/31/22 employee reported some swelling and went the Doctor where a small sliver of metal was removed requiring 2 stitches and prescribed antibiotics.

Employee was entering the mill through the lab door. As employee exited, EE pushed on the door glass a little harder than EE should have causing the door glass to break. Employee was seen at ER and received seven stitches for two small cuts on the right hand.

Employee was removing hard hat to put on a safety harness. Employee caught the side of left eye with the hard hat's visor shield causing a scratch to eye.

Employee cut his right index finger while placing a bag on the four spout bag packer. While initially believed to require only first aid the day of the incident, to ensure no infection occurred, a physician prescribed antibiotic the following day.

Employee was stretch wrapping and he pulled the wrap across his body to fasten it to the corner of palletized material when he felt a sharp pain in his left shoulder.

The employee was replacing the water trough at the end of #4 Hardinge mill when a piece of debris entered his right eye.

Employee was assisting in the removal of a steel plate from the floor beneath the crusher. The plate was dropped, striking the employee on the right leg.

The employee was emptying barrels that fill up during production and employee strained lower right back. Employee decided to wait and see if it would get better on its own. The injury did not get better so employee made an appointment with Dr. on 1/31/2013

The employee was cleaning out a suction line from a 6" water pump because it was full of sand. He was lifting the line to attempt to shake out the sand when it slipped and dropped on his shoulder, bruising his shoulder.

Employee and another electrician were bench testing an electriclly operated valve. As the unit operated, his right index finger was pinched by the actuating arm. A flap of skin and flesh was torn loose from his finger. Employee was seen at the Emergency Room and required 8 stitches to repair the finger. Employee returned to work-No Lost Time.

EE was measuring timber and the top timber fell on his ankle.

Employee was doing clean-up and lifted an 80 pound piece of refractory to dispose of it when he strained his lower abdominal area causing a hernia.

Employee said he was picking up broken 50lb bags of talc from the floor and dumping them into carts to be disposed of. While shaking out a bag in the cart, he he said he felt pain in his lower back. Employee was seen by Doctor on 2-23-09. Employee started losing time 2-24-09.

Employees was pulling a dust collector bag cage down from the collector, when it slipped and struck him on his hard hat and then grazed his mouth.

Employee was climbing over transport pipelines on roof to check operation of a diverter valve electric motor. Employee claims that later in the day he began to feel tightness and pain in the middle of his back. He saw Dr. (Chiropractor) on 1-23-2008

Employee was helping H.D.Mechanic change bucket teeth on an excavator. He was holding the drive pin when his right thumb was pinched between the drive pin and the retainer pin. The thumb nail was torn off. He continued to work until lunch time. Later in the evening he was seen at the emer. room for x-ray ( not broken ) and dressing. He returned to work on his next scheduled shift.

Employee was helping disassemble a machine frame work. When he picked up a piece of the frame it slipped and pinched the index,middle & ring fingers of his right hand. He saw the Doctor and had a xray taken on 7/24/07. He returned to work 7/25/07 and also saw the Doctor to have pressure relieved from under the nail on his ring finger. There has been no lost time.

Employee and a partner were closing a feed valve on a talc pump they were working on. Injured employee's foot was stuck in material on floor and when he turned to move he twisted his Knee. On 4-18-2007 he went to his Doctor and is scheduled for more tests.

While cleaning area employee was lifting a Barrel to dump waste and felt a small pain in his Back. Employee continued to work until 3-1-07 and Dr took him off work for at least 1 week.

Employee did not report any incident until 2/20/07 from doctor's office. He stated that he had experienced shoulder pain for ~ 1 month prior and it was work related. This employee lifts and stacks 50# bags of clay.

On 1-25-07 employee reported feeling pain in his lower stomach area. He was seen by a Doctor on 1-26-07 and a hernia was found. The employee has not lost any work and has not had any treatment yet.** Employee missing time as of 4/20/07 for Surgery**

Employee was lowering the top portion of a high jacker (man lift). He removed the 2 pins to pivot the top down and when it came down suddenly he said it pinched his finger between the cage and frame work. Employee has seen a doctor and will have fluid removed. (2/18/08 appointment) Amendment: EE had fluid & cyst removed. He lost one day (5/5/08); resigned for other employment.

On 8-1-06 employee reported feeling pain is his stomach to his foreman while bagging 50 lb bags of Talc. On 9-7-06 employee went to his own Doctor who diagnosed a Hernia. On 9-8-06 employee reported Dr visit to Company. Surgery was scheduled and employee started losing time today 11-29-06.

Employee was helping move 4D batteries. (100 + lbs) Felt pain in right shoulder.

EE BENT DOWN TO PLACE MORE BAGS ON #2 BAGGER. AS HE TURNED TO PLACE THE BAGS, HE GOT A CATCH IN HIS LOWER BACK.

Sample chute was plugged to sample roll crusher, EE tryed to pull removable section of chute to clear. When section came loose it pinched his "R" little finger between chute and guard.

EE WAS PULLING A BAG OFF THE FILLING SPOUT ON #1 BAGGER. HE WAS RECALLED TO WORK THE DAY BEFORE THE INJURY ON A 10 WEEK LAY-OFF.

EE STATED HE WAS DUMPING THE TRASH BIN WITH THE FORKLIFT. HE TILTED THE TRASH BIN TO DUMP AND REACHED TO PULL BIN BACK DOWN LIKE USUAL & PULLED SOMETHING IN HIS BACK. WHEN ASKED IF HE NEEDED TO GO HOME OR HAVE IT CHECKED OUT, HE REPLIED " NO". HE WORKED THE REMAINDER OF THE NIGHT WITH NO COMPLAINT & WORKED 2 HOURS THE NEXT DAY BEFORE HE LEFT CLAIMING BACK PAIN. WAS GIVEN MEDS.

EE WAS LIFTING, PUSHING AND PULLING IN VARIOUS PARTS OF THE MILL. HE NOTICED THE PAIN ON 7/1/03, AND WAS GETTING WORSE AS TIME PASSED.

THROWING 50 LB BAGS AT NO 3 PACKER, EE FELT SHARP PAIN IN MIDDLE OF BACK

EMPLOYEE WAS PULLING AT #1 BAGGER. WHILE DOING A LOAD THE SEAT HE WAS SITTING IN BROKE WITH HIM CAUSING HIM TO FALL. HE GRABBED A BAR ATTACHED TO THE BAGGER TO PULL HIMSELF ONTO THE MACHINE TO KEEP FROM FALLING INTO THE AREA BELOW.

EMPLOYEE WAS STEPPING DOWN FROM A HAUL TRUCK WHEN HE STEPPED ON UNEVEN GROUND AND TWISTED HIS RIGHT ANKLE.

EE CLAIMS TO HAVE INJURED HIMSELF ON MAR.3, 2003HE WENT TO EMERGENCY ROOM ON APRIL 14TH. DURING THE PAST 6 WEEKS THE EE NEVER INDICATED TO HIS FOREMAN OR OTHER STAFF THAT THIS INJURY HAD OCCU RRED . EE CLAIMS TO HAVE STRAINED HIS ABDOMEN LIFTING A PROPANE BOTTLE ONTO A FORKLIFT. ER PHYSICIAN LIST TORN ABDOMEN MUSCLE

EMPLOYEE LIFTED AND TURNED A 5 GALLON PLASTIC PAIL CONTAINING LESS THAN 2 GALLONS OF PAINT. 5 GALLONG PAIL WAS ON A 2' HIGH STAND. EE FELT STRAIN IN LEFT LOWER BACK.

A DUST COLLECTOR CAGE SLIPPED FROM CO-WORKER'S HANDS AND EE JERKED HIS HEAD AROUND VERY QUICKLY AND OUT OF PATH OF CAGE TO AVOID BEING HIT, CAUSING HIM TO SUFFER A CERVICAL STRAIN.

CATCHING 50LB BAGS OF TALC HE FELT PAIN IN LEFT WRIST & FOREARM. ON MONDAY & TUESDAY, SEPT. 16TH& 17TH, HE WAS MUCKING IN THE MILL & FELT PAIN TO LEFT WRIST. LOST TIME STARTED 9/18/02.

AS EMPLOYEE WAS PULLING 10" ROTORY VALVE (APPROXIMATE WEIGHT = 70 LBS.) ACROSS FLOOR OF MACHINE SHOP HIS RIGHT HAND SLIPPED CAUSING HIS BACK AND SHOULDER TO TWIST. HE HEARD LOUD "POP" IN HIS L EFT SHOULDER.

WASHING VEHICLE USING BUCKET OF SOAPY WATER, HE STRAINED HIS BACK WHEN LIFTING THE 5 GALLON BUCKET OF SOAPY WATER.

TURNING METAL ON LATHE, REACHED IN TO PICK METALSHAVING OFF SHAFT, WAS CAUGHT BY ANOTHER METAL SHAVING WHICH LACERATED RT. THUMB.

WHILE HELPING CLEAN UP UNDER CRUSHER, EMPLOYEE FELT PAIN IN LEFT SHOULDER SHOVELING FINES INTO LOADER BUCKET. AS OF AUGUST 1ST, 2002 EMPLOYEE'S PHYSICIAN HAS TAKEN HIM OFF WORK UNTIL FURTHER NOTICE.

EE WAS PREPARING TO LOAD A TRUCK. HE HAD THE FORKS TOO HIGH, WHICH CAUSED THE PORTABLE LOADING PLANK TO TIP OVER. HE WAS STRUCK BY THE PLANK ON THE LEFT. HE GOT OFF OF THE FORK TO TRY TO LINE UP THE PLANT BETWEEN THE BUILDING AND THE TRUCK. THAT IS WHEN IT TIPPED OVER AND STRUCK HIS RIGHT LEG CAUSING A CONTUSION AND A CUT.

WHILE WORKING ON #38 CONVEYOR BELT, EE THREW WELDING CABLE OVER SIDE OF STAKE RACK WITH LEFT HAND, FELT PAIN IN LEFT SHOULDER

EMPLOYEE WAS TAPPING AN AUGER ON A PUMP WHEN HIS FINGER WAS CAUGHT BETWEEN THE HOUSING AND PIPE.

PACKING OUT 50 LB BAGS OF TALC ONTO PALLET, FELT PAIN IN RIGHT SIDE OF CHEST.

EE WAS PACKING OFF BAGS AT #1 BAGGER MACHINE. LIFTED A BAG--TWISTED HIS BACK TO RELEASE THE BAG ON THE PALLET AND PULLED A MUSCLE IN HIS BACK.

EMPLOYEE BENT OVER TO PICK UP A PIECE OF CARDBOARD; AS HE BENT OVER, HIS BACK "POPPED" AND HE FELT PAIN IN LOWER BACK.