Buscar en el registro

Injured states "I forgot my knife so blaster was throwing their closed knife at pillar next to me which hit and opened on impact then bounce (sic) and stabbed (sic) me in the arm." 3 stitches required.

Injured was cleaning out under some conveyor belts using a water hose when water deflected onto injured's face an into right eye. Injured was wearing safety glasses at the time. Injured went to Dr. on 10/19/21, diagnosed with a corneal abrasion.

Employee reported on 7/14/2021 that EE's back was hurting and had been bothering EE since the week of 6/28/2021, when EE was operating various pieces of equipment. Employee stated EE's back hurt from climbing in and out of equipment. Employee received medical treatment on 7/14/2021 was released to full duty and again on 7/27/2021 when EE was given work restrictions.

Employee was seated power washing, stood up and felt pain in their right knee.

The employee states EE closed hopper inspection door on sweeper truck when EE felt a pain in EE's elbow. Reportable due to medical treatment on 4.28.2022.

Employee stated that while changing liners, a rock fell from a ledge, bounced off something, and struck EE in the mouth, breaking a tooth.

Technician was removing a transmission plate from under a 980G loader when the plate fell on EE's left arm causing a fracture. The plate was held by one bolt which bent/broke causing the plate to fall.

Employee stated EE was shoveling on the catwalk of the VSI when EE felt a pain in EE's lower back. Employee received medical treatment on November 6.

Employee was bringing 50 pound anfo bags from inside the truck to the tailgate. While bending over, employee twisted and felt pain in lower back. Employee sought treatment with Chiropractor on 12-30-19. No work restrictions given.

Employee stated that as they were loading a blast hole, a small rock fell from the hole being loaded above and struck them on the neck and shoulder.

Employee stated EE was climbing into a screen deck to replace a screen when EE cut hand on a sharp rock.

Employee stated was installing a V belt, rolled finger between the sleeve and the v belt.

Employee stated was lifting bags of ANFO and felt a strain in the left shoulder. Went to the doctor on 6/14/2019 and was referred to physical therapy. Was first aid until then.

Technician was installing a suspension cylinder on a 773 Off Road truck. While attempting to push the rigged cylinder in to place technician felt a pinch and pain in lower back.

Employee stated ee was helping splicing a belt and pinched finger in the belt clamp

The employee stated that when stacking bolts on the roof bolter the employee cut arm on a band.

Employee was troubleshooting a flow problem on the belt press. When EE pulled a hose off, the fluid sprayed EE in the face. Employee states EE knocked safety glasses off when the fluid startled EE.

The employee stated employee was picking up a belt roller and felt a pop in employee's back.

The employee was working on damaged hydraulic cylinder, attempted to move cylinder. The cylinder moved easier than anticipated pinching finger between cylinder and frame.

Employee was shoveling, cleaning work area, felt pain in right shoulder. Employee was put on restricted duty on July 7 after diagnosed with damage to rotator cuff.

The employee was changing a screen and struck EE's elbow on a beam.

Employee stated EE grabbed the handle of a tool being worked on by another employee and burned EE's hand, unaware the handle was hot.

The employee was climbing up the ladder on a haul truck and felt pain in EE's knee. Surgery on 9-8-16 made injury reportable.

The employee was changing a screen when he turned and felt a pain in his back.

The employee was working on the belt press checking a water line, when he inadvertently pulled the line loose causing water to splash in his eye. No injury, antibiotic was prescribed as preventive care.

The employee bent over to pick up a wheel chock and felt pain in his lower back.

The employee stated his eye started hurting following his shift at work. Went to the doctor who indicated it is possible he got sand under his contact lense.

The employee was installing roof bolts, he turned to grab a bolt and felt a pop in his knee. The employee was on full duty until he required surgery on 2-20-15 at which time he was placed on restricted duty.

The employee was climbing into the haul truck, as he stepped on the lower step, which is designed to be flexible, it shifted causing additional strain to his left arm.

The employee lifted a chute to clear it and returned the chute down to the normal position. When he removed his safety harness he felt pain in his left shoulder. The employee was given restrictions on 9-11-14.

The employee was removing a 8 inch block, by pushing it with his foot, from under the front wheel of a 773 Haul Truck that had been loaded on a trailer.

The employee stated he bent over to pick up a hitch pin and felt a pain in his low back.

The employee reported shoulder pain after shoveling and having removed a panel during his shift. No specific incident to contribute to the injury.

While an IMTR employee was unloading a drill steel from a delivery truck, the forks of the lull hung up on a cross member, when it released it pushed the drill steel onto the Fred Weber Inc. truck driver's foot.

Employee was removing a pin from a hydraulic cylinder when the cylinder fell on his thumb.

The employee was disassembling a take up, when a roller fell on his foot above the steel toe.

The employee was moving a chute and felt a pop in his right shoulder.

The employee was changing out screens and strained his right shoulder.

The employee was adjusting the seat forward and struck her left knee on the dash.

The employee was shoveling and experienced groin pain. It was initially diagnosed as a personal health condition. A medical specialist later determined that the condition may have been caused by heavy lifting or straining.

Unloading screen and caught finger between the screen and hand rail of the catwalk.

Employee was working under the crusher chipping welding slag and fines fell from above and went behind safety glasses into his right eye.

Employee was lying on his stomach checking the oil on a 8x20 shaker and when completed he went to sit up and felt a "charlie horse" in his low back.

Employee was working on a Pantera 900 drill and he was removing a cover off of the side of the boom, when he bent to set it down he felt a sharp pain in his low back.

Employee was loading scrap steel into loader bucket when he threw a large piece into bucket causing it to bounce out and strike him on the left side of his head. His hearing aid broke inside his ear canal. Employee went to the ER to remove the foreign objects from his ear canal.

EE was working in the crusher tower repairing the hammer mill. He handed another employee some tools and turned around and struck his upper front tooth on the lid of the mill. His front tooth was chipped toward the midline.

EE states he was working on a truck removing a flywheel. He does not know how he got some metal in his eye.

EE reported to have injury at work after working all weekend at his 2nd job. EE admitted to working at his shop 8-10 hrs barbequing on concrete at pumpkin patch. Minor lifting of pumpkins from bed of truck resulted in strain. Questionable as being work related.

EE ALLEGES HE WAS SHOVELING WHEN HE STRAINED HIS CERVICAL SPINE.

EE alleges to have injured left ankle & right knee while performing maintenance on slide chute.