Buscar en el registro

A PIECE OF HARDENED STEEL STRUCK EMPLOYEE'S RIGHT CHEEK WHILE HE WAS DRIVING A WEDGE FROM DRAGLINE RIGGING. THEY WERE USING A HARDENED PIN AND A 16 LB. SLEDGE HAMMER TO DRIVE OUT THE WEDGE.

EMPLOYEE ALLEGES THAT WHILE INSTALLING GEAR BOX COVER ON #6 BELT AT THE T.L.O, HE WAS PRYING THE COVER OVER TO INSTALL A BOLT. WHILE PRYING THE COVERR HIS FINGER GOT CAUGHT IN A PINCH POINT.

THE EMPLOYEE WAS REMOVING A SPRAY NOZZLE ON THE WASH RACK SPRAY TOWER WITH A WRENCH. THE WRENCH SLIPPED AND THE EMPLOYEES HAND STRUCK AN ADJACENT SPRAY NOZZLE CAUSING A ONE INCH LACERATION TO HIS RIGHT INDEX FINGER.

WHILE INSTALLING A BEARING CAP ON THE DRAG DRUM SHAFT OF THE PAGE DRAGLINE THE EE DROPPED A 2 3/4" X 24" BOLT ON THE TOP OF HIS LEFT THUMB.

THE EE AN ELECTRICIAN ALLEGED THAT WHILE BREAKING LOOSE A MOTOR COUPLING WITH A WRENCH ON THE 2 DRAG MOTOR OF THE PAGE DRAGLINE HE STARTED TO DEVELOPE LOWER BACK PAIN. THE EE STATED THIS WAS A N AGGRAVATION OF A CHRONIC CONDITION.

EMPLOYEE WAS REPAIRING A BROKEN 6IN FIRE HYDRANT PIPE SAID EMPLOYEE WAS IN AN 8 BOOT HOLE TYING CHAIN TO BROKEN PIPE WHEN PIPE WAS TIED OFF WITH CHAIN & THE EMPLOYEE PULLED ON CHAIN TO GET IT OUT OF HOLE THE PIPE FLIPPED & HIT EMPLOYEE IN HEAD

MAN HIT PLATE ON BOTTOM OF BUCKET WITH A HAMMER AND METAL FRAGMENT FROM PLATE PUNCTURED RIGHT LEG.

EMPLOYEE WAS USING A SLEDGE HAMMER IN THE REPLACEMENT JOB OF TOOTH ON DRAGLINE METAL MUSHROOMED SENDING PIECE OF METAL INTO HIS THIGH ONE STITCH WAS USE TO CLOSE WOUND

WHILE CUTTING LOCK TABS ON LID OF 5 GALLON PAIL WITH A RAZOR KNIFE KNIFE SLIPPED CUTTING LEFT INDEX FINGER

38505E ALLEGES THAT WHILE USING A POCKET KNIFE TO WHITTLE A PIECE OF WHILE ACTING AS PLATFMEN THE KNIFE SLIPPED GOT THRU THE WOOD LACERATING 3 FINGER.

61206ORKIGN ON BELT WHEN KNIFE SLIPEPD AND CUT THE PALM OF HS RIGHT HAND.

WAS FIRST SEEN BY DR ON 7-6-92. EMPL WORKING ON CARRIER ROLLER OF A CAT MODEL #245. STRUCK THE ROLLER WITH A HAMMER CAUSING SHARP PIECE OF METAL FROM THE ROLLER TO STRIKE ARM.

THE EMPLOYEE ALLEGED THAT WHILE CHANGING TEETH ON 123 EASI-MINER HE STRUCK A TOOTH WITH A 2 LB. HAMMER. A METAL SLIVER FROM TEH TOOTH WAS EMBEDDED IN HIS LEG. THE SLIVER WAS APPROX. 3/4" LONG AND 1/8" THICK.

WHILE USING A 4 POUND SLEDGE HAMMER TO LOOSEN A TOOTH AND TOOTH ADAPTER FROM A FRONT END LOADER BUCKET,A PIECE OF METAL BROKE LOOSE AND ALLEGEDLY STRUCK THE EMPLOYEE.

DIGGING HOLE WITH SHOVEL TO LET DOWN THE JACK PLASTIC HANDLE OF SHOVEL BROKE

THE EMPLOYEE, AN ELECTRICIAN, ALLEGED THAT WHILE PRYING A DROP LIGHT HOUSING APART USING A SCREW DRIVER AND HIS POCKET KNIFE, THE LOCK ON THE KNIFE RELEASED AND CLOSED ON HIS FINGER. THE EMPLO YEE SUSTAINED A LACERATION TO THE TIP OF HIS MIDDLE FINGER ON HIS RIGHT HAND REQUIRING 3 STITCHES.

REMOVING PIN FROM DRIVE CHAIN STRUCK HAMMER PC OF METAL FLEW UP LODGED IN R CHEEK

WHILE INSTALLING A BEARING IN THE STICK ON THE 245 BACKHOE, A PIECE OF METAL SPLINTERED OFF THE BEARING AND EMBEDDED IN THE EE S LEG LEG ABOVE THE KNEE CAP.

EMPLOYEE ALLEGES THAT HE WAS INSTALLING A DRAG CHAIN LINK ON T HE LOT 29 DRAGLINE HE WAS HITTING A WEDGED PIECE OF STEEL WHEN A F RAGMENT SLINTERED OFF & EMBEDDED IN THE EMPLOYEES RIGHT HAND

THE EMPLOYEE STATED THAT HE WAS ATTEMPTING TO REMOVE A CHOKER FROM THE RIPPER ASSEMBLY OF #102 DOZER. WHEN THE CHOKER TWISTED AND PINCHED HIS RIGHT INDEX FINGER AGAINST THE RIPPER SMASHING AN D CUTTING FINGER.

WHILE USING A SLEDGE HAMMER TO DRIVE A SOLID METAL/STEEL PIN FROM A HOUSING A PIECE OF STEEL BROKE LOOSE FROM THE PIN, STRIKING HIM IN THE HAND. THE PIN WAS PART OF THE BUCKET TOOTH ASSEMBLY OF A DRAGLINE.

EMPLOYEE ALLEGED THAT WHILE HAMMERING A BUSHING INTO THE CHEEK OF THE DRAGLINE BUCKET HE OVER SWUNG,MISSING THE BUSHING.THE FORWARD MOMENTUM CARRIED THE HEAD,OF THE SLEDGE HAMMER,PAST THE BUSH ING CAUSING A PINCH POINT BETWEEN THE HANDLE AND THE BUSHING. AS A RESULT THE FINGER WAS STRUCK AGAINST THE OUTER EDGE OF THE BUSHING.SEVERE LACERATION AND CONTUSION TO THE INDEX FINGER OF RI

THE EMPL STATED THAT HE AND A FELLOW EMPL WERE BREAKING OFF THE TUBE JOINT OF THE DRILL STEM AND PRESSURIZED WATER SPRAYED INTO HIS FACK AND EYES THE MPL THEN HAD A FOREIGN BODY IN HIS R EYE

WHILE PULLING THE DRILL HOLE PLUGS FROM THE HOLES OF THE DRILL PATTERN, THE SHOVEL HANDLE WITH "J" HOOK ATTACHED TO THE END PULLED LOOSE THE EYE OF THE PLUG CAUSING I.NAME ALLEGEDLY TO JERK TO A STANDING POSITION, THEREBY STRAINING HIS BACK. THE HOLE PLUGS ARE MADE OF PLASTIC AND TAPERED SO A STO FIT A 12 3/4 INCH HOLE. DIRT AND MATERIAL THAT FALL INTO THE PLUGS WAS BEING REMOVED P

THE EMPL ALLEGED THAT WHILE REMOVING RIPPER POINTS ON 448 THERE WAS ONE STRUCK ON SHANK EMPL WAS HITTING ON TOOTH TO KNCOK LOOSE PIECE CHIPPED OFF TOOTH AND STRUCK L THIGH

TWO EMPLOYEE WERE REPLACING THE BUSHINGS ON TILT CYLINDER OF 6560.586 DOZER THEY ATTEMPTED TO PUT THE BUSHING IN WITH A HAMMER THE BUSHING BEING VERY HARD METAL CHIPPED THE PIECE OF METAL LODG ED IN LITTLE FINGER LEFT HAND

WHILE CLOSING THE 1 PRIMARY CRUSHER USING A 30 TON PORTA POWER THE WELDED PUSHED BLOCK TO WHICH THE JACK WAS PUSHING FROM BROKE AT THE WELD. ALLOWING THE 3X3X3 PUSH BLOCK COME LOOSE STRIKING THE EMPLOYEE ON THE RIGHT FOREARM A SPLINT WAS APPLIED THE EMPLOYEE WAS GIVEN TYLENOL WITH CODEINE EMPLOYEE RETURNED TO WORK AS 313 CLEAN MAN AT ILD HIS NEXT SHIFT.

MECHANIC WAS REMOVING BEARING RACE USING A HARDENED HAMMER AGAINST HARDENED STEEL. THE RACE CHIPPED AND LACERATED HIS LEFT CALF.

EMP WAS CHIANING DOWN A PUMP ON A SAMLL TRAILER USED A BINDER TO TIGHTEN CHAIN AND A 18" PIPE OVER BINDER HANDLE. PIPE SLIPPED STRIKING EMP IN FACE SMALL LACERATION REQ 2 STICHES.

EMPLOYEE WAS ASSISTING IN THE REPAIR OF A SHIVE ON THE DRAGLINE SHOE. WHILE HOLDING THE SHIVE IN PLACE, ANOTHER EMPLOYEE WAS HAMMERING THE PIN IN PLACE. A LONG HANDLED SLEDGE WAS BEING USED. A S THE HAMMER WAS BEING SWUNG, THE PENDULUM MOTION OF THE HANDLE BUTT STRUCK THIS EMPLOYEE'S FINGER SMASHING IT AGAINST THE SHIVE SPOKE.

EMPL USING SCREWDRIVER AS TORQUE MULTIPLIER WHE%ILE STEADING WITH LEFT HAND.SCREWDRIVER SLIPPED CUTTING RIGHT PALM.

THE EMPLOYEE STATED THAT HE WAS STRIPPING INSULATION ON A 25 KV CABLE WHEN HE CUT HIS FINGER WITH HIS KNIFE. THE EMPLOYEE STATED THAT HE HAD THE LEAD WIRE TRUNED OVER AND HAD HIS FINGER IN THE WRONG PLACE.

WHILE ATTEMPTING TO FORCE THE TOOTH AND ADAPTER BACK ONTO A DRAGLINE BUCKET BY STRIKING THE TOOTH WITH 16 LB SLEDGE HAMMER A SMALL PIECE OF METAL BROKE LOOSE AND STRUCK HIM IN THE LEFT JAW REQ UIRING 5 STITCHES TO CLOSE THE WOUND

WHILE USING A S5EDGE HAMMER TO INSTALL A DRAGLINE TOOTH ADAPTER WEDGE,THE HAMMER CAUSED APIECE OF THE WEDGE TO FLAKE OFF AND STIKE THE EMPLOYEE.THE METAL PIECE PUNCTURED THE THIGH OF THE EMPLO YEE.UPON EXAMIN5TION BY ORTHOPEDIC SURGEON NO METAL PIECE OR PIECES COULD BE FOUND IN THE WOIND.

WHILE ATTEMPTIN1 TO SEPERATE THE TRACK SEGMENTS OF A TRACTOR DOZER, THE INJURED PARTY STRUCK THE SEGMENT WITH A 8 LB HAMMER CAUSING A SHARD OF METAL TO BREAK LOSE AND STRICK THE INDIVIDUAL.

I.NAME USING LA9GE HAMMER TO DRIVE MASTER PIN INTO TRACK OF C.M.SMALL SHARD OF METAL FROM PIN BROKE LOOSE AND STRUCK HIM IN LEFT INNER THIGH.

THREE MEN WERE 5OWERING GALVANIZED PIPE WITH FITTING DOWN A GRATED STAIRWAY, HE WAS ON THE LOWER END AND ANOTHER EMPLOYEE WAS ON THE UPPER END TO HELP GUIDE THE PIPE AND HIS EMPLOYEE WAS ON A ROPE WHICH THEY3HAD WRAPPED AROUND THE PIPE AND UP TO A WRAP AROUND A PIPE RAILING LOWER END GOT TO HEAVY AND HE WENT TO LAY IT DOWN ON THE STAIRS AND IT SLIPPED A LITTLE ON THE ROPE AND END O

THE EMPLOYEE ST5TED THAT HE WAS CUTTING A ROPE OFF OF A PUMP HOSE WHEN THE KNIFE CUT THROUGH THE ROPE AND CUT HIS LEG.

THE EMPLOYEE ST5TED HE WAS REMOVING A BUCKET WEAR PLATE BY TAPPING IT WITH A SLEDGE HAMMER WHEN A SLIVER OF METAL CAME OFF THEN WEAR PLATE STRIKING HIM IN THE LEFT SHIN. THE EMBEDDED SLIVER OF METAL WAS REMO5ED AND THE LACERATION WAS SUTURED.

THE EMPLOYEE ST5TED THAT HE WASD STRIKING A ROLLER ON #652 DOZER WITH A HAMMER WHEN HE STRUCK THE EDGE OF THE ROLLER BREAKING A SILVER OF METAL OFF WHICH STRUCK HIM TO HIS LEFTF ARM.

WHILE USING A H5MMER SPIKE MAUL TO REMOVE A WEDGE FROM A DRAGLINE CABLE SPROCKET A PIECE OF T HE HAMMER FACE CHIPPED LOOSE STRIKING HIM IN T HE ABDOMEN.

EMPLOYEE STATED3HE INJURED HIS LEFT HAND WHEN HE STRUCK IT AGAINST A JAGGED PLUG WELD WHILE SWINGING A SLEDGE HAMMER THE LACERATION REQUIRED THREE SUTURES AND A TETANUS SHOT

I.NAME REMOVING3LARGE MEAL GUARD A CO-WORKER USING PRY BAR CAUSED GUARD TO MOVE PINCHING I.NAME LEFT THUMB.

I.NAME ALLEGES THAT WHILE STRIKING THE SURFACE OF A BEARING WITH A 20# HAMMER A PIECE OF METAL P''% SPLINTERED FROM THE SURFACE OF THE HAMMER STRIKING HIM.

EMPLOYEE ALLEGES HE WAS CLEANING FROZEN MATERIAL FRONM THE BOTTOM OF THE LEVELINE JACKS ON THE 45R B-E DRILL.HE WAS HOLDING A BAR IN THE RIGHT HAND AND STRUCK HIS RIGHT INDEXZ FINGER WITH A 2 2 POUND HAMMER.NOISE NOR LIGHTING CONTRBUTED TO THIS ACCIDENT.

EMPLOYEE STATED HE WAS REMOVING DRAGLINE BUCKET TOOTH WEDGES BY TAPPING WEDGE WITH SLEDGE HAMMER AND METAL SLIVER STRUCK HIM ON FOREHEAD

EMP ALLEGES HE WAS STANDING BEHIND A COWORKER WHEN SLEGEHAMMER HE WAS USING MISED ITS MARK STRIKING ON EDGE OF BURNED STEEL WHICH SPLINTERED AND STRUCK HIM IN LEFT RING FINGER LACERATION REQUI THREE SUTURES TO CLOSE

THE EMPLOYEE ALLEGES THAT HE WAS TAPPING THE BASE OF A MAGNETIC DRILL WITH A HAMMER WHEN HIS HAND STRUCK THE DRILL BIT LACERATING IT THE LACERATION REQUIRED EIGHT SUTURES TO CLOSE

EE ALLEGES THAT WHILE ATTEMPTING TO CUT A PIECE OF TUBBER BELTING A KNIFE SLIPPED & CUT HIS LEFT THIGH. THIS CUT PRODUCTED A LACERATION APPROX 4" LONG.

EMPLOYEE ALLEGES WHILE CUTTING A HOLE IN THE TOP OF A PLASTIC BUCKET WITH A POCKET KNIFE THE BLADE CLOSED CUTTING HIS RIGHT FINGER REQUIRING SUTURES