Buscar en el registro

Employee was cleaning work area at the end of his shift when he felt something in his left eye. Employee received medical treatment, including prescription eye ointment to prevent possible infection. No lost time or restricted duty.

EE WAS MOVING PALLET JACK FROM UNDER PALLET. THE JACK HUNG UP UNDER PALLET AND JERKED EE, PULLING MUSCLE IN LOWER BACK LEFT SIDE. EE WENT TO THE DR. ON 5-3-02 WHERE HE WAS PLACING ON LITE DUTY . IT THEN BECAME REPORTABLE.

EE WAS PLUMBING IN A SINK W/QUEST PIPEING AT THE FILTER PLANT. THE PIPE WAS TOO LONG. EE COULD NOT GET A HACK SAW IN THE SPACE BECAUSE IT WAS A SMALL SPACE. EE TRIED TO CUT THE PIPE W/A POCKET KNIFE. THE KNIFE SLIPPED & CUT LEFT PALM OF HAND JUST BELOW THE THUMB. EE WAS TAKEN TO THE COMPANY DR WHERE HE RECEIVED 6 STITCHES.

LEFT HAND GOT CAUGHT BETWEEN CONEALONG HANDLE AND A PIECE OF METAL. THE COMEALONG WAS ATTACHED TO AND CUT TOP SIDE OF LEFT HAND. WAS TRANSPORTED TO HOSPITAL ER WHERE HE RECEIVED SIX STITCHES I N HAND. THEN IT BECAME REPORTABLE.

PICKED UP SLEDGE HAMMER TO HIT SIDEOF SAND TANK TO LOAD OUT A TRUCK. THE WEATHER WAS VERY COLD AND THE SAND HA DFROZEN. AS THE EMPLOYEE HIT THE SIDE OF THE TANK HE FELT A PULL BETWEEN HIS S HOULDERS ON THE LEFT SIDE. HE AHD PULLED THE MUSCLE JUST UNDER THE LEFT SHOULDER. HE WAS TRANSORTED TO THE DR WHO PLACED EMPLOYEE ON LITE DUTY.

7EMPLOYEE WAS PACKING A PUMP WITH ANOTHER EMPLOYEE. THE INJURED EMLOYEE WAS HOLDING THE PACKING GLAND AS THE SECOND EMPLOYE EWAS PUSHING WITH A BAR. THE BAR SLIPPED AND STRUCK THE INJURED EM PLOYEE ON THE LEFT INDEX FINGER. THE FINGER BECAME INFECTED 3 DAYS LATER.

EMPLOYEE WAS BENDING OVER DRIVING A SCREW OFF OFA SHAFT WITH A 24 OZ. HAMMER. HE STARTED TO RAISE UP AND STRAINED HIS BACK WENT TO DOCTOR ONTHE 17TH OF MAY.

EMPLOYEE WAS WORKING ON PIPELINE WHEN HE STARTEDFEELING PAIN IN HIS CHEST. HE CAME TO THE SHOP AND 911 WAS CALLED TO THE PLANT TO CHECK HIM OUTEMPLOYEE WAS ADMITTED TO HOSPITAL OVERNIGHT FOR TESTS.

EE WAS CUTTING TAPE FROM WIRES ON A MAKE-UP BOX ON A 75 HP MOTOR THE MAKE-UP WIRES WERE RELATIVELY SHORT AND REQUIRED REACHING INTO THE MAKE-UP BOX TO CUT THE TAPE WITH A RAZON KNIFE. HOLDING THE WIRES WITH THE LEFT HAND & CUTTING THE TAPE WITH THE RIGHT THE KNIFE WAS PULLED ACROSS THE TAPE AND ALSO THE RING FINGER OF THE LEFT HAND CAUSING A CUT.

EE WAS CUTTING A PIECE OF RUBBER HOSE. THE KNIFE HE WAS USING SLIPPED STRIKING EE IN LEG CAUSING A WOUND ABOUT 3/4" LONG BY 1" DEEP. THIS WOUND REQUIRED 2 STITCHES.

EE WAS TURNING A FEED SCREW WITH A PIPE WRENCH, WHEN A KNOT POPPED OUT IN THE GROIN AREA. SURGERY WAS REQUIRED ON 10-17-97, AT WHICH TIME THE ACCIDENT WAS REPORTABLE.

EE WAS USING AN "EASY OUT BOLT" TO DISLODGE A BROKEN BOLT AND WHEN HE APPLIED PRESSURE A PARTICLE FLEW OFF LODGING IN EE'S (L) EYE.

WHILE EMPLOYEE WAS HOLDING A KNOCK WRENCH HAMMER. HAMMER HEAD MUSHROOMED CAUSING A PIECE OF METAL TO LODGE INTO EMPLOYEES LEFT ARM JUST ABOVE THE WRIST.

EMPLOYEE WAS USING AN ADJUSTABLE WRENCH THAT SLIPPED CAUSING ARM TO STRIKE PANEL BOX, CUTTING ARM.

EMP WAS HELPING LINE A ROD MILL. SAFETY (BACKUP)CHAIN HOIST FELL AND STRUCK HIM IN THE BACK AND SIDE. A BOLT HOLDING THE HOIST BROKE CAUSING IT TO FALL.

EE WAS OPENING A BUCKET AND THE KNIFE HE WAS USING SLIPPED AND CUT HIS ARM. CUT REQUIRED STITCHES.

EMPLOYEE WAS PRYING CHUTE INTO POSTION AND FELT PAIN IN LOWER BACK.

DREW SPIKE HAMMER BACK TO SWING, HEAD FELL OFF HANDLE AND STRUCK EMPLOYEE IN THE SMALL OF BACK CAUSING TRAUMA TO LOWER LUMBAR REGION.

EE WAS BRUSHING SAND FROM GLASSWARE THAT FEEDS THE I-6 COOLER. HE BUMPED HIS HAND AGAINST THE HOT GLASSWARE CAUSING A 2ND DEGREE BURN.

EMPLOYEE WAS DISMANTLING A PUMP AND A WRENCH SLIPPED, STRIKING HIS HAND AGAINST THE PUMP BODY, BREAKING HIS FINGER.

WHILE PUTTING RODS INTO A ROD MILL, THIS EMPLOYEE WAS HIT IN THE EYE BY THE END OF A PUSH ROD (WOODEN) BEING USED BY ANOTHER EMPLOYEE.

EMPLOYEE WAS BREAKING APART ELEVATOR CHAIN WHEN A PIECE OF METAL BROKE OFF AND WENT INTO EMPLOYEES LEFT WRIST.

LOOSENING BOLTS ON MANIFOLD WRENCH SLIPPED HIT L INEX FINGER

EE WAS REACHING DOWN TO HOOK COME A LONG TO PONTOON WHEN BACK POPPED.

EMPL MOVING MOTOR ON J#1 VACUUM PUMP INTO POSITION WITH PRY BAR AND FELT A KINK IN HIS NECK.

EMPLOYEE WAS GOUGING FROZEN ORE OUT OF A BIN WHEN HE HIT HIS ELBOW OVER THE CHUTE.

CLEANING SCREENS PAIN IN R ELBOW Y

EMPLOYEE WAS CHIPPING SLAG FROM A WELD & A SMALL PIECE FLEW INTO HIS RIGHT EYE

EMPLOYEE WAS USING A WRENCH ON AN ICE COVERED VALVE.THE WRENCH SLIPPED AND HIS FINGER WAS CAUGHT BETWEEN THE WRENCH AND A METAL BOX.

EMPLOYEE WAS PRYING AT ROCK IN CRUSHER. THE ROCK FELL, HIT THE PRY-BAR CAUSING THE PRY-BAR TO HIT THE EMPLOYEE IN THE FACE AND LIPS.

EMPLOYEE WAS TRYING TO TURN SMALL BOLT IN RATCHET-TYPE WRENCH, KNIFE SLIPPED, STRUCK KNIFE IN BASE OF THUMB ON LEFT HAND REQUIRING 1 SUTURE.

EMPL DISLODGING CHOKEUP IN CRUSHER WITH CROWBAR PULLED TOO HARD ON CROWBAR,CAUSING PULLED MUSCLE IN LOWER BACK.

PIPE ON TOP OF SAND TANK WAS CHOKED. EMPLOYEE TRIED TO UNCOKE, OPENED PIPE. CONTENTS OF PIPE SNAD AND WATER SPEWED INTO EMPLOYEES FACE AND EYES. EMPLOYEE USED EYE WASH IN PLANT, BUT STILL FE LT GRIT IN RIGHT EYE.

EMPL WAS INSTALLING NEW STRIKER BAR ON DRILL USING PIECE OF STEEL AS DRIVING BAR TO TIGHTEN ATTACHMENT. WHEN STRUCK BY HAMMER SMALLL PARTICLE OF STEEL BROKE OFF & HIT EMPL ON CHIN.

EMPLOYEE WAS TIGHTENING BOLTS ON RODMILL WRENCH SLIPPED CAUGHT THUMB BETWEEN WRENCH AND GUARD ON RODMILL,MASHED THUMBNAIL PARTIALLY OFF ON LEFT HUMB REQUIRING REMOVAL OF THUMBNAIL.

EMPL WAS BAGGING FELDSPAR HIS REGULAR JOB. BAGGING MACHINE STUCK BLEW DUST ONTO EMPL & INTOI HIS PANTS POCKETS WHERE HIS POCKETKNIFE WAS FULL OF DUST. WHILE EMPL WAS CLEANING KNIVE HE CUT H IS FINGER REQUIRING 4 SUTURES.

FOUR EMPLOYEE S WERE LIFTING AN ELECTRIC MOTOR DXX FROM A DUST COLLECTOR WITH A ROPE ONE EMPLOYEE LIFTED MORE QUICKLY THAT THE OTHERS AND CAUSED MOTOR TO SWING TOWARD SIDE WHERE EMPLOYEE WHO W AS INJURED WAS LIFTING CAUSING HIM TO CATCH HIS FINGER BETWEEN THE MOTOR AND THE FRAME.

EMP WAS CHANGIN1 SAND LINES. A WIRE LOOP BROKE AND LET A BAR SLIP OUT WHICH CAUGHT HIS FINGER BETWEEN THE BAR AND MOTOR BASE, MASHING FINGER AND FRACTURING IT, REQIRING REMOVAL OF FINGERNAIL AND SUTURES 3

I,NAME WAS HELP3NG OTHER EMPLOYEE PUT METAL DOOR BACK ON MICA BIN AND IN THE PROCESS AT TIGHTENING THE BOLTS THE WRENCH SLIPPED OF THE BOLT AND PINCHED HIS FINGER AGAINST THE METAL PLATE.

EMPL RAISING CO3VEYOR BELT SUSPENDED ON WINCH CABLE AND EMPL WAS HIT ON LEFT HAND BY FLY-BACK OF WINCH HANDLE.

EMPLOYEE WAS HE5PING CHANGE BEARINGS ON FEEDSCREW WRENCH SLIPPED CAUSING EMPLOYEE TO HIT ELBOW ON FEEDSCREW SEVERAL DAYS LATER INFECTION SET UP IN ELBOW JOINT REQUIRING LANCING ON 6-1-86

EMPLOYEE WAS RE4OVING TAPE FROM AROUND ELECTRICAL CONNECTIONS ON ELECTRIC MOTOR WITH KNIFE IN RIGHT HAND WHICH WAS USED TO CUT TAPE, LEFT HAND SLIPPED WHEN TAPE CAME OFF OF CONNECTIONS. EITHER KNIFE OR WIRE 7UT LEFT PALM.

EMPLOYEE WAS SHOVELING GRAVEL FROM UNDER CONVEYOR BELT A BLISTER FORMED ON HIS LEFT HAND WHICH BROKE ALLOWING SMALL PIECE OF STONE TO ENTER PALM OF HAND NEAR BASE OF THUMB WAS REMOVED 10-23-85 REQUIRED 3 SUTURES

EMPLOYEE WAS SHOVELING SPILLAGE FROM UNBDER HARDINGE MILL. IN THE PROCESS EMPLOYEE HAT TO GO THRU RAILINGS THAT SURROUND THE MILL AND IN SO DOING HIT HIS LEFT KNEE ON THE RAILING.

EMPLOYEE WAS CHANGING TRACTION WHEEL ON TOP OF ELEVATOR AND HAD PUT BAR THROUGH ELEVATOR CHAIN AND HITCHED IT TO A COMEALONG TO HOLD THE CHAIN IN POSITION. THE BAR SLIPPED OUT LETTING THE CHAIN FALL CATCHING EMPLOYEE\S LEFT HAND, HURTING HAND, REQUIRING 5 STITCHES.

EMPLOYEE WAS USING HYD.RAM WITH A WOOD SPACER AND WHEN PRESSURE WAS APPLIED TO THE UNIT,THE WOOD SPACER FLEW OUT AND STRUCK EMPLOYEE\S RIGHT ARM.

EMPLOYEE WAS DOING REPAIR WORK ON THE TRACK ON A D-6DOZER AND THE SOCKET WRENCH SLIPPED OFF BOLT AND CAUGHT HIS FITH FINGER NAILRESULTING IN LACERATION.

EMPLOYEE WAS MOVING RAILCAR USING CAR MOVER BAR, BAR SLIPPED, CAUSING LEFT HAND TO BE HIT OVER END OF RAILCAR. TOP OF LEFT HAND. WAS BRUISED.

EMPLOYEE WAS BURSTING ROCK THAT WAS HUNG IN CRUSHER AND HAMMER HIT CRUSHER AND HANDLE HIT SHIN