Buscar en el registro

Employee was using a pry bar when working on a bus, removing the transmission. The bar slipped and struck EE in the mouth, causing the tooth filling to fall out and broke part of the tooth.

Employee cut the tip of ring finger on their left hand with a razor knife. Required 5 stitches to close the wound.

An employee was sweeping the floor in the LO1432 Loader at the end of the shift. When EE straightened their back, EE noticed pain in the lower back.

EE was attempting to remove a D7 undercarriage roller. EE was striking the flange of the roller with a 15lb. sledgehammer when a fragment of the roller flange broke off. The piece of metal struck EE in the left thigh resulting in a 1" laceration in the thigh.

Mechanism beam hung on motor base. Used slate bar to pry beam away from motor base. Beam came loose and caught right hand between motor base and beam, causing a laceration on the ring finger.

Employee was attempting to cut a nylon zip tie with a utility knife. Access to the zip tie was very limited, employee's hand slipped on the knife and employee cut right index finger, the wound required stitches (6) to close.

Employee alleges ee was trying to turn a push beam with a slate bar and in doing so hurt back. The event was not reported until Jan 25th, 2019. On Jan 29th ee presented an excuse that covered the days missed as being under Drs care for the alleged injury.

Employee was removing a pry bar that had been wedged between the handrail and crusher platform when the crusher lid was opened for repairs. When EE grabbed the bar and pulled, it sprang back shoving EE's arm against the crusher and injuring EE's left elbow.

EE was working on a belt at the vessel ref while using a box knife, the knife slipped and contacted the EE leg (thigh).

Employee was assisting putting Concrete Forms together. Partner was hitting a bull pin when his hammer slipped off his target and struck him in the jaw.