Buscar en el registro

EMPLOYEE ATTACHED TWO EMPLOYEE BRIME BUCKETS TON ROPER. AS BUCKETS WERE BEING RAISED TO FLOAT DECK ONE FELL HITTING EMPLOYEE ON HER HEAD & FOREAM.

EMPLOYEE WAS MAKING UP SODA ASH AND WAS BENDING OVER PICKING UP A 100 LB BAG. EMPLOYEE WAS NOT AWARE OF THE SERIOUSNESS OF THE ACCIDENT @ SIX MONTHS LATTER THEREFORE IT WAS NOT REPORTED TO HIS SUPERVISOR UNTIL 6/19/92. USF&G CONTROVERTEDTHE WORKER'S COMP. CLAIM.

EMPLOYEE WAS TRYING TO REMOVE BIT OFF HEAD AND METAL SHAVING FLEW OFF AND GOT EMBEDDED IN EMPLOYEE'S UPPER PART OF LEFT ARM.

CUTTING BELT WITH KNIFE LACER L RING FINGER

ATTEMPTING TO TIGHTEN GUIDE WITH WRENCH IT SLIPPED OFF, INJ TO NOSE

REMOVING GEAR CHAIN SLIPPED HIT ON HIS RT FOREARM LACER 4 STITCHES

EMPLOYEE WAS CHANGING BITS. BIT BAR SLIPPED OFF THE BIT CAUSING EMPLOYEE TO HIT HIS HAND ON THE FLOOR.

MOVING CABLE WITH ROPE IT BROKE EMP HIT ELBOW ON MINER

EMPLOYEE WENT TO TURN BUCKET ELEVATOR WITH PIPE WRENCH TO CHECK FOR FREEDOM OF MOVEMENT WHILE TURNING SHAFT WITH WRENCH, ELEVATOR BACKLOADED AND PINCHED LEFT HAND BETWEEN WRENCH AND MOTOR MOUN T.

CUTTING BAND AROUND RUBBER BELTING FOR PORTABLES. BAND WAS CUT WITH CLAW HAMMER, RELEASED ENERGY, CAUSING BAND TO STRIKE LEFT ELBOW.

MOVING MINER CABLE WITH HOOK (CABLE HOOK).

EMPLOYEE WAS INSTALLING A CONVEYOR MOTOR ON A MINER, PRESSAR SLIPPED AND JARRED RIGHT HAND. INJURY OCCURED WHILE EMPLOYED UNDER AMAX POTASH CORP) EMPLOYEES INJURY HAS NOW REQUIRED SURGERY

EMPLOYEE WAS CHANGING BITS ON A MINER BAR SLIPPED & CAUGHT LITTLE FINGER BETWEEN BAR &BIT

EE WAS CLOSING VALVE WITH A CHEATER WRENCH. IT SLIPPED OFF OF VALVE STEM AND HIT RIGHT ANKLE.

GUIDING BOLT N PLATE, BEING PUSHED BY PORT O POWER PLATE FELL BOLT FELL ON FINGER

EMPLOYEE WAS USING A SOCKET & SOCKET CAME OFF HEAD OF BOLT CATCHING FINGER BETWEEN RATCHET HANDLE & DISCHARGE CHUTE OF PUMP.

EMPLOYEE WAS WORKING ON MINER, THE WIRE ROPE WAS WRAPPED AROUND A SQUARE MEMBER AND THE SHARP CORNER CUT THE CHOKER AND CHOKER HIT UPPER LIP.

INSTALLING PIN, IN JACK AND BAR SLIPPED.

EMPLOYEE WAS SPLICING CRUSHER PLUGS ON CABLE, HE WAS TAKING TAPE OFF OLD B.O. PLUG, KNIFE SLIPPED THROUGH TAPE AND CUT WRIST.

TIGHTENING NUT WITH HAMMER AND BOX END WRENCH HAMMER SLIPPED HITTING EMPL ON FINGER.

EMPLOYEE WAS DEMONSTRATING THE PROCEDURE ON HOW TO ADJUST A CONVEYOR CLUTCH AND PULLED UP ON WRENCH AND STRAINED LOWER ABCK.

EMPL SWINGING S5EDGE HAMMER-HEAD CAME OFF STRIKNNG EMPL ON LITTLE FINGER.

BELT CREW WAS I3STALLING A TAIL PULLEY T AKE-UP ASSEMBLY & A PRY-BAR BEING USED TO MOVE THE TAKE-UP FELL ON TOP OF HIS RIGHT FOOT

EMPLOYEE & PART3ER HAD A 4FT LENGTH OF 6IN PIPE SUSPENDED FROM A COMEALONG HAND HOIST WITH DIRECTIONAL LEVER IN THE DOWN POSITION MOVING THE PIPE INTO POSITION CAUSED THE HOIST TO RELEASE THE HANDLE FLEW UP 5ND STRUCK EMPLOYEE OVER RIGHT EYE

EMPLOYEE WAS WO9KING ON PIPE WITH PIPE WRENCHES IN PIPE FITTERS SHOP WHEN HE EXPERIENCED PAIN IN LEFT ELBOW AND ARM BELIEVE IT IS PULLED LIGAMENT IN ELBOW HE HAD SERIOUS TROUBLE WITH SAME ELB OW SOME YEARS A1O

EMPLOYEE WAS CLEANING DRAIN LINE WITH A WATER LANCE AND HIT A PIECE OF SHARP RUSTY METAL CUTTING HIS LEFT THUMB ON THE RUSTY METAL.

EMPLOYEE WAS SERVICING MINER AND WAS BOWLING RADIATOR OUT. HE HAD A SCREWDRIVER HOLDING UP THE LID AND THE SCREWDRIVER SLIPPED AND MASHED HIS FINGER.

CHIPPING SAMPLE AND HIT THUMB WITH PICK HAMMER.

HITTING CONNECTING LINK ON CRUSHER CHAIN WITH HAMMER AND PIECE OF LINK BROKE OFF STRIKING HIM IN RIGHT SHOULDER.