Buscar en el registro

EMPLOYEE WAS TIGHTENING BOLTS ON THE BALL MILL FEED END LINERS WITH 1" IMPACT WRENCH. HE REPORTED FEELING PAIN WHEN HE TWISTED HIS BACK AS IMPACT WRENCH WAS LIFTED. EMPLOYEE ARRIVED AT WORK ON 1/6/94. AS HE TURNED TO CLOSED THE CAR DOOR, HE SNEEZED & IMMEDIATELY HAD SERIOUS PAIN IN LOWER BACK. HE REPORTED TO DOCTOR AND DOCTOR TOLD HIM TO TAKE OFF WORK 1/11 & 1/12,THEN START THERAPY

54736YEE WAS CHARGING THE ROD MILL WITH RODS (PUTTING NEW RODS INTO THE MILL). ONE ROD DID NOT GO ALL THE WAY INTO THE MILL. EMPLOYEE WAS PUSHING THE ROD WITH A BAR. THE BAR SLIPPED OFF THE RO 40154 EMPLOYEE FELL FORWARD ONTO THE OTHER RODS.T AS EMPLOYEE HIT THE RODS RESULTING IN SMALL LACERATION TO RIGHT ELBOW (ONE STITCHES).

55061S PUTTING A RUBBER BUSHING ON 71 JUMBO CENTRALIZER WHEN THE PIN SLIPPED AND HE HIT HIS LEFT THUMB WITH THE HAMMER.

WHILE PRYING OFF RETAINING STRAP ON SCREEN RODS, BAR SLIPPED PINCHING FINGER BETWEEN BAR AND SCREEN RODS.

TWO EMPLOYEE WERE LIFTING RACHINE HYDRAULIC PUMP BY PLACING A BAR THROUGH EYE BOLT. EMPLOYEE HAD TO PASS BETWEEN HYDRAULIC RESERVIOR AND OVERHEAD CRANE STRUCTURAL BEAM. EMPLOYEE HAD TO TURN SIDEWAYS STRAINING LOWER BACK.

EMPLOYEE WAS ATTEMPTING TO CLOSE A 4" AIR VALVE IN BOILER ROOM WITH A PIPE WRENCH AND A CHEATER PIPE. THE PIPE WRENCH SLIPPED OFF THE VALVE CAUSING HIM TO STRAIN HIS BACK.

COME ALONG FAILED CATCHING THUMB BETWEEN HA DLE AND STEEL

SHOVED R ELBOW AGAINST GUARD RAIL

EE WAS TRYING TO REMOVE A DRILL STEEL COUPLING BY STRIKING IT WITH A SIX LBS HAMMER A PIECE OF STEEL BROKE OFF THE COUPLING AND STRUCK HIM IN THE LEFT SIDE OF CHEST. THE STEEL CHIP REQUIRED MI NOR OUT PATIENT SURGERY TO BE REMOVED.

BRAKE CALIPER ASSEMBLY WHILE BEING LOWERED INTO POSITION CAUGHT RT RING FINGER (NAIL AREA & TIP OF FINGER) BETWEEN CALIPER & ROTOR PLATE ON WHEEL

EMPLOYEE WAS ATTEMPTING TO REMOVE RIGHT FRONT SPINDLE FROM ST8 LOADER,USING A STEEL HAMMER AND DIRECTLY STRIKING HARD STEEL COMPONENT.A SLIVER OF STEEL WAS IMBEDDED IN LEFT INDEX FINGER.

I.NAME TIGHTENING ROTARY CLUTCH ON DRILL RIG USING HAND TOOL.TOOL SLIPPED AND HAND STRUCK AGAINST SHAFT OF DRILL RIG.

EMPLOYEE STARTED TO INSTALL PINS, NOTICED A PIECE OF LOOSE, WAS MOVING BASKET TO GET A BETTER POSITION TO MINE, DIDN'T NOTICE HOW CLOSE HE WAS TO THE BACK, HAD MINING BAR IN HIS HAND. BLUNT E ND OF MINING BAR STRUCK THE BACK CAUSING THE SHARP END TO PUNCTURE THE RIGHT FOOT OF THE MINER, GOING COMPLETELY THROUGH.

HH WAS REMOVING INSULATION FROM 8 KV CABLE WHEN KNIFE SLIPPED, CUTTING HIS LEFT THUMB.

USING HARDENED STEEL PUNCH TO DRIVE BEARING ONTO SHAFT, END OF PUNCH BROKE STRIKING EMPLOYEE IN UPPER ABDOMEN.

MAN WAS HANGING A 400 AMP SWITHC BOX. THE WRENCH HE WAS USING SLIPPED OFF EYE BOLT, STRUCK INJURED ON FOREHEAD, MAN HAD A CUT OVER RIGHT EYE.

I NAME WAS CUTTING A PIECE OF ANGLE IRON THE BLADE CAME OFF OF THE PIECE HE WAS CUTTING & FORWARD MOTION CUT THE TOP OF HIS THUMB

ATTEMP T TO CHANGE THREAD ON BIT USING STEEL HAMMER PC FO HAMMER CAME OFF IMBEDDED IT IN MANS R FOREAM SEVERE BLEEDING

EMPLOYEE WAS SPREADING BUCKET ARMS WITH HYD. RAM AND WOODEN BLOCK, THE BLOCK FELL HITTING HIM ON THE LEFT FOOT SMASHING LITTLE TOE ON LEFT FOOT.

CAUGHT RIGHT RING FINGER BETWEEN PRY BAR AND MOTOR STAND WHILE ATTEMPTING TO MOVE STAND ON FLOOR OF TRAILER.

INJURED WAS STRIPPING POWER CABLE TO PUT INTO SWITCH BOX.HIS KNIFE SLIPPED AND CUT HIS FINGERS.

I.NAME WAS USING CABLE CRIMPERS TO SPLICE 440 POWER LINE. HIS SHOULDER POPPED WHILE SQUEEZING CRIMPERS.

STRAIGHTENING BAR ON BOTTOM OF CAGE DOOR WITH WEDGE THE BAR BROKE OFF AND WEDGE FLEW UP HITTING I NAME ON L TEMPLE

EMPLOYEE WAS MOVING A LINER USING TWO STEEL CRABS AND OVERHEAD CRANE. ONE CRAB SLIPPED LOOSE, EMPLOYEE CAUGHT THE LINER BY HAND TO KEEP LINER FROM HITTING HIS LEGS.

HE WAS PULLING ON THE ROPE THAT OPENS THE DOOR OF A CONCRETE BUCKET WHEN A LOOP OF ROPE FOT AROUND HIS FINGER,M HIS RIGHT RING FINGER WAS PULLED AND JAMMED.

EMPL WAS OPENING CAP BOX WITH UTILITY KNIFE KNIFE SLIPPED CUTTING THUMB OF R HAND

EMPLOYEE WAS CHARGING A ROCK FACE,STOPE78V4,HE JAMMED HIS THUMB INTO THE FACE WHILE HE WAS TAMPING A HOLE.

MAN WAS REMOVIN1 OLD TRUCK BED WITH A WRECKING BAR HE WAS PULLING TOWARD HIS BODY, THE BAR SLIPPED HITTING HIM IN THE RIBS. MAN DID NOT GO TO DR UNTIL 10 23 87

EMPLOYEE WAS WO9KING TO DISLODGE A BOULDER, WHEN THE ROPE ON THE HOOK GOT SLACK AND CAUSED TOP OF HOOK TO SWING OUT AND STRIKE EMPLOYEE IN THE HEAD.

THE MAN WAS STR3PPING POWER CABLE FOR COPPER ROUGHER FROTH PUMP, WHEN HIS KNIFE SLIPPED CUTTING HIS MIDDLE FINGER AND I NDEX FINGER ON LEFT HAND

EE WAS REPLACIN1 A HYD HOSE ON HOISE REEL OF JUMBO USING A CHARGING STICK TO PRY WITH. THE STICK BROKE HITTING EE IN MOUTH. HIS LOWER LIP WAS CUT & A TOOTH WAS LOOSE.

EMPLOYEE THINKS3HE PULLED MUSCLES IN RT SIDE OF NECK WHILE MINING LOOSE

WEDGING TWO PIE7E OF METAL APART, DEVELOPED TOO MUCH PRESSURE BETWEEN THE TWO PIECES AND WEDGE BECAME A PROJECTILE.

KNOCKING A COUP5ING LOOSE FROM A DRILL STEEL WITH HAMMER WHEN SLIVER OF STEEL WENT INTO RIGHT HAND BETWEEN MIDDLE AND RING FINGER.

HOLDING A BRAKE3CALIPER WHILE I.NAME DROVE OUT THE PIN THE HAMMER HIT THE PIN AND VEERED OFF HITTING HIS MIDDLE FINGER ON LEFT HAND REQUIRED STITCHES TO CLOSE

DILODGING OVERS3ZE ROCK BETWEEN TAIL PULLEY AND BELT. HOLDING LENGTH OF STEEL BAR WHILE ANOTHER MAN USED A 6 LB. SLEDGEHAMMER. THE HAMMER MISSED THE BAR AND HIT HIS LEFT MIDDLE AND RING FINGER S CAUSING LACER5TION AND POSSIBLE FRACTURE.

REMOVING BUSHIN1 FROM STRICKING BAR WITH METAL HAMMER WHEN PIECE OF METAL FLEW OFF AND ENTERED HIS RIGHT LEG. NO STITCHES.

WHILE TIGHTENIN1 BOLT IN 12" OPIPE FLANGE THE WRENCH SLIPPED OFF BOLT HEAD & H E RECEIVED SMALL CUT & BUMP ON HEAD. HAD STITCHES.

WHILE BANDING A HOLE IN 12 INCH WATER LINE, PIP BANDING STRAP SLIPPED AND CUT LEFT THUMB.

WAS CHANGING TRIKING BAR ON MACHINE USING A BALL PEIN HAMMER TO BREAK COUPLING LOOSE WHEN HE STRUCK BY A PIECE OF STEEL INT HE CHEST.

HAMMERING ON RETRACT PIN TRYING TO PUT A NEW PIN IN WHEN PIECE OF METAL CHIPPED OFF AND LODGED IIN FRONT OF NECK

INJ CUTTING PLASTIC CAP FROM DRILL STEEL WITH POCKET KNIFE.DRILL STEEL LAYING ON SASH OF JUMBO HE HAD BEEN WORKING ON.DRILL STEEL ROLLED CAUSING INJ TO CUT INDES FINGER ON LEFT HAND.

WHILE DRIVING PIN OUT OF DIPPER BOOM WITH 8 LB SLEDGE HAMMER AND PRY BAR, HE MISSED THE BAR WITH THE HAMMER AND HIT FINGER BETWEEN BAR AND HAMMER HANDLE, BREAKING INDEX FINGER ON RIGHT HAND.

HELPING MAINTENANCE MEN GET SURFACE SHAFT LANDING IN PLACE. HE WAS PRYING WITH BAR WHEN THE BAR SLIPPED THROUGH HIS HAND, TEARING FLESH BETWEEN THUMB AND FOREFINGER ON LEFT HAND, REQUIRING SIT TCHES.

WAS STRUCK BY A COFFYING HOIST HANDLE WHILE HELPING TO CHANGE RAIL IN VIB #28 SHAFT CUT ON LEFT SIDE OF HEAD THAT REQUIRED 5 STITCHES

EMP WAS HITTING ON MACHINE WHEN A PIECE OF STEEL CAME OFF OF HAMMER STRIKING HIM IN RIGHT EYE

USING POCKET KNIFE TO CUT SMALL PIECE OF RUBBER.WAS PULLING KNIFE TOWARD HIMSELF AND CUT PALM OF LEFT THUMB-REQ A FEW STITCHES.

INSTALLING PIPE NIPPLE ON DISCHARGE OF 8\\ PUMP.USING COFFING HOIST TO PULL PIP IN PLACE.HAD TIGHTENED PIPE AND REACHED BACK TO GET HAMMER TO MOVE PIPE INTO PLACE.WHEN HE REACHED OVER TO BACK SIDE OF PIPE,HOIST SUDDENLY RELEASED,HANDLE STRUCK ABOVE RIGHT EYE.

THE INJURED MAN WAS PULLING ON A WRENCH WHILE TIGHTENING BOLTS ON A PIECE OF EQUIPMENT.

HOLDING SOCKET-TORQUE MULTIPLIER AND TORQUE WRENCH ON NUT WHEN PULLED MUSCLES IN BACK.