Buscar en el registro

Using hammer to remove ball bearing from shaft, a small piece of metal (less than 3mm) went into skin in neck area

EE reported EE was tightening a hydraulic hose with a wrench. While pushing on the wrench something popped in EE's elbow.

Employee was using a pry bar to lift heavy pieces of steal, the pry bar slipped out, causing over extension of shoulder.

Employee reported they were swinging a large sledge hammer while installing the gabion plate back in the grizzly. In order to do that they had to swing a large (heavy) sledge hammer to beat rocks out. *Employee did not report injury until 11/29/2021*

Wrenching on a hose for a track hoe with large wrench with arm in extended raised position

While shoveling struck finger against metal chute frame.

Employee hit hand with a hammer while working on screen.

Employee was using a 3lb hammer to perform maintenance on rollers. When employee lifted and started to swing hammer, EE sprained EE's right arm.

EE injured left index finger when it was struck by a hammer. EE was holding a punch tool and another ee swing the hammer, missed the tool and struck the injured ee hand.

EE reports that they first swung a hammer and struck right hand pinky finger against metal frame of conveyor and then shortly after that EE reports that while using a socket wrench it slipped off the bolt and they struck the same area on their right hand against a belt clamp.

Opening impactor with wrench, broke blood vessel in right hand middle finger.

Removing tire from rim strained right bicep.

Shop employee had heated a loader bucket tooth to remove, struck tooth with hammer resulting in a hot piece of steel entering finger.

While working from a ladder the ee was using a hammer to open the door at the bottom of a bin. As ee swung the hammer it caught an electric power cord which threw him off balance and he fell off the ladder.

While driving a bushing onto the boom cylinder of a 988B loader, a metal chip came off and lodged into the right arm of the employee.

Employee was holding an open end wrench on the head of a bolt holding the motor on the roll mill while another employee was tightening the nut with socket. The wrench slipped off the bolt and mashed employee's middle finger on his right hand between the wrench and frame of motor. Required 6 stitches.

Employee was cutting a conveyor belt with a utility knife when the knife slipped and he cut his right thigh.

EE was holding chisel while coworker was hitting it with a sledge hammer. Coworker missed and hit EE's finger, resulting in a chipped bone at the end of EE's finger. This accident was reported to me on 03-18-05.

A ROCK WAS STUCK IN THE FEEDER AND EE WAS PRYING ON IT WITH A PRYBAR TO DISLODGE IT. THE BAR SLIPPED AND HIT EE ON THE SIDE OF HIS HEAD JUST BELOW THE EAR AND BEHIND EAR.

WAS LOADING A SCREEN DECK ON LOW BOY. EMPLOYEE WAS USING A PRYBAR TO STEADY LOAD. PRY BAR SLIPPED AND SHOVED HAND INTO ANGLE IRON FRAME.

WAS REMOVING A DRAIN PLUG WITH WRENCH CAUGHT HIS FINGER BETWEEN WRENCH HANDLE AND FRAME WHEN THE PLUG CAME LOOSE.

EMPLOYEE PINCHED MIDDLE FINGER OF LEFT HAND BETWEEN WRENCH & SIDE OF IMPACTOR WHILE HE WAS REMOVING KEEPER. SENT TO EMERGENCY ROOM FOR X-RAYS - NO BROKEN BONES - FINGER DID SWELL UP.

WRENCH SLIPPED OFF BOLT AS HE WAS REPAIRING THE DRIVE SHAFT ON A 988 A CAT HAUL TRUCK HE MASHED HIS RIGHT RING FINGER. TOOK TO HOSPITAL FOR X RAYS NOT BROKEN.