Buscar en el registro

Mechanic was knocking out a bearing race from a hub on the ground using a brass drift and a hammer. The brass drift edge slipped off the surface of the race as he hit the drift. This caused his left hand to be smashed against a stud on the hub.

EE was using a pry bar when it slipped and smashed his finger

While drilling a water well, the injured floor hand was making a drillpipe connection. The injured employee did not wait for the other floor hand to get tongs completely around the pipe, he put his hand in a pinch point, the tongs were then latched. Injured employee had the tip of his left ring finger amputated.

Employee was using a chain come-along to secure the moldboard on a motorgrader. When hydraulic force was applied to the moldboard, the come-along's chain broke and struck the employee.

Employee was going to change a quick connection off a welding cable. The screw driver he had would not fit in the hole. He started cutting it wih a knife, the knife slipped and cut through his glove. It cut his left hand.

Employee was using a hammer to loosen a tooth point on Loader when the hammer struck the hardened surface of the4 tooth, a piece of the tooth flew off and lodge in his leg.

REMOVING FILTER FROM DIRT MOVING EQUIPMENT. WAS STANDING ON TIRE WHEN WRENCH SLIPPED. FELL BREAKING HER COLLARBONE.

WHILE TIGHTENING A BOLT WITH A WRENCH, THE WRENCH SLIPPED CAUSING HIS SHOULDER TO POP. THE EMPLOYEE CONTINUED TO WORK WITH SOME REOCCURRING PAIN. THE EMPLOYEE HAD AN APPOINTMENT FOR AN MRI ON 5/29/03 AND WAS TAKEN OFF WORK ON 6/2/03.

WHILE HAMMERING ON A HARDENED SURFACE WITH A HAMMER A SLIVER OF METAL STRUCK HIM IN THE ABDOMIN.THE SLIVER WAS REMOVED AND REQUIRED 1 STITCH.

EE WAS REMOVING CHOKER FROM COME-A-LONG WHEN IT SPRAN BACK AND HIT HIM IN THE MOUTH.

WHILE TIGHTENING LUGNUTS ON THE REAR TIRES OF A 100 TON END DUMP TRUCK, THE EE'S RIGHT HAND GOT CAUGHT BETWEEN THE TORQUE ARM OF THE TORQUE WRENCH AND THE TIRE RIM.

WHILE INSTALLING BOLTS ON THE DRUM END OF THE DRAG DRUM WITH A SLAP WRENCH, THE WRENCH SLIPPED AND PINCHED THE END OF THE EMPLOYEE'S RIGHT INDEX FINGER REQUIRING STITCHES.

INJURED AND ANOTHER EMPLOYEE WERE CHANGING TIRES ON UNIT 702-F5070.ON THE SECOND TIRE HE HAD A BAR IN EACH HAND WHILE PRYING THE TIRE OFF THE RIM AND AT THE SAME TIME PUSHING WITH HIS RIGHT KN EE ON THE RIM. HE FELT A PAIN IN HIS RIGHT KNEE AND IT BEGAN TO SWELL. HE REPORTED THE ACCIDENT TO HIS SUPERVISOR AND SUBSEQUENTLY WENT TO HIS DOCTOR.

EMP WAS CUTTING3CABLE TRAYS APART THE PAN CAME APART AND CAUGHT HIS HAND BETWEEN THE PAN AND STEEL TABLE

PRYING TUBE ON COAL CAR COUPLER -PRY BAR SLIPPED CAUSING HIM TO FALL BACKWARDS.

EE STATED HE WAS CUTTING A BROKEN PLASTIC PIPE FITTING FROM A STEEL PIPE FITTING WHEN THE PEN KNIFE HE WAS USING CLOSED ON HIS FINGER.