Buscar en el registro

Two ee's were reattaching the bucket on a Gradall. They were attempting to remove the pin from the Gradall arm. The injured ee was holding the handle of the pin hammer while the other ee was striking it with a sledge hammer. Both hammers were hardened steel. A sharp steel fragment broke loose upon impact and entered the injured ee's arm midway between the wrist and elbow.

I-Beam was lifted and employee was cleaning dirt off of it. The lifting clamp slipped off and I-beam fell, striking employee on foot.

THE EMPLOYEE WAS TIGHTENING A SET COLLAR ON A BEARING. THE INJURY OCCURRED WHILE THE EMPLOYEE WAS USING A HAMMER. THE EMPLOYEE ISN'T SURE IF THE INJURY OCCURRED DUE TO BEING STRUCK WITH THE HA MMER OR DUE TO THE WRENCH SLIPPING. THE INJURY IS MEDICALLY REPORTABLE DUE TO THE EMPLOYEE RECEIVIGN STITCHES TO CLOSE THE WOUND.

EE WAS REPLACING MOTOR MOUNTS ON THE NO. 2 SHAKER AND WAS REPLACING THE BELTS. AS HE WAS TURNING THE SHIEVE WITH A PIPE WRENCH. THE COUNTER WEIGHT INSIDE THE SHAKER SHIFTED REVERSING THE SHIEV E AND CATCHING HIS HAND ON THE CORNER OF A PERMANENT GUARD. LOCK OUT AND OTHER SAFETY PRECAUTIONS WERE IN USE AT THE TIME OF THE ACCIDENT. STITFCHES WERE REQUIRED.

THE INJURED EMLOYEE AND A CO-WORKER HAD TAKEN THE COUNTER-WEIGHT OFF THE DRIVE SHAFT AND STOOD IT UPRIGHT IN THE FLOOR UP NEXT TO THE LAUNDRY. THEY THEN HOOKED UP THE COUNTER-WEIGHT THEY WERE GOING TO PUT BACK ANDSTARTED LIFTING IT UP WITH A CHAIN FALL. WHILE THEY WERE LIFTING IT UP TO STRUCK THE ONE THEY HAD TAKEN OFF, CAUSING IT TO TURN OVER WHICH STRUCK THE EMPLOYEE'S LOWER SH

ATTEMPTING TO REMOVE IMPELLER NUT FROM THE END OF THE SHAFT OF A NEW DRIVE UNIT FOR THE NO. 1 CLARIDIER PUMP, WHEN THE UNIT ROLLED OVER CATCHING HIS FINGER BETWEEN THE NUT AND THE PUMP FRAME. THE UNIT WAS BEING RAISED BY A ONE TON CHAIN FALL STITCHES WERE REQUIRED FOR HIS FINGER. EE LOST NO TIME UNTIL 12-17-90.

EMPL PUTTING IN MECHANICAL SPLICE ON MOUNTAIN REFUSE BELT.USED A COME-ALONG TO PULL BELT TOGETHER TO GET SPLICE MADE.RELEASED TENSION ON BELT,COME-ALONG JUMPED A TOOTH.HANDLE CAME DOWN,WEDGED HAND BETWEEN COME-ALONG AND HANDLE.

SHOVELING GLASS OUT OF RAILROAD CAR. SHOVEL FLIPPED UP GLASS IN RIGHT EYE SIDE LENS ON SAFETY GLASSES WAS MISSING.

INJURED WAS CHANGING BITS ON THE AUGER, AND WAS ATTEMPTING TO DRIVE ONE OFF WHEN A PIECE OF METAL CAME LOOSE AND WENT IN HIS LEFT ARM.

FROZEN COAL WAS COMING OUT OF THE RAILROAD CARS IN CHUNKS AND HAD TO BE BEATEN INTO SMALLER PIECES BEFORE IT WOULD GO THROUGH THE SCREEN AT THE SHAKEOUT. WHILE BEATING OE PIECE, SOME COAL W ENT INTO HIS EYE BEHIND HIS SAFETY GLASSES. EMPLOYEE DID NOT GO TO A DOCTOR UNTL 12-21-88 AT WHICH TIME THE COAL HAD BECOME EMBEDDED IN HIS EYE AND HAD TO BE REMOVED.

EMPL USING BAR TO SLIDE HOPPER UNDER SEPARATOR TUB WHEN HE FELT PAIN IN HIS BACK.LOST TIME BEGAN 7-11-88.EMPL DID REC RX AND HAD IT FILLED.

EE STRAINED BAC5 WHILE LIFTING COME-ALONG OVERHEAD.

REPLACING JACK 2N DOOR AT LOADOUT WHEN JACK SLIPPED AND CAUGHT FINGER BETWEEN DOOR AND JACK.

INJURED SAID HE WAS PUSHING ON HANDLE OF PIPE WRENCH WITH HIS FOOT. HIS FOOT SLIPPED OFF OF WRENCH. WHEN HIS FOOT CAME OFF OF WRENCH HE WAS THROWN OFF BALANCE AND PULLED A LIGAMENT IN RIGHT L EG.

EMP WAS USING CLAMP TO LIFT METAL ON TRUCK CLAMP SLIPPED AND CAUGHT HAND BETWEN TRUCK BED AND METAL

EMP WAS USING HOIST TO REMOVE COVER FROM CMI DRYYER HOOK ON HOIST CAME LOOSE AND HOIST FELL STRIKING EMP ON LEFT LEG AND ANKLE