Buscar en el registro

Employee was performing clean-up activities on ground level next to conveyor belt 10 when errant rock fell from screen deck and hit his right thumb and right ring finger cutting his finger.

Employee reported that metal plate he had just cut, fell on his foot just above the steel toe.

Employee reported that while cutting metal rail with cutting torch, piece of slag fell into his boot burning the front of his ankle.

A shackle hit a contract rigger in the nose as he was guiding it away from a counterweight.

Employee reported that he was helping fellow employee true holes on the EL-Jay Screen when a bolt hit him in the mouth, chipping a tooth.

Employee reported that while inspecting a screen sensor, a piece of metal flatbar that he was holding came in contact with a vibrating screen causing the flatbar to hit his right shin. Injury required 2 stitches.

Employee was one of two individuals welding at opposite points in primary crusher feed hopper. Employee was treated for welder's burns that night after suffering eye pain.

Employee was in vacinity of welding operations. Was notified prior to welder striking electode. Employee closed eyes and shielded eyes with hardhat. Employee completed shift and began having eye pain at home. Employee went to Emergency Room later that evening where he was diagnosed with Ultraviolet Keratitis (welder's burns).

Employee was training new employee when drill steel became dislodged from carousel and struck the employee. The employee recieved two mild compression fractures in his back.

Employee not sure if air blast from oxygen side of torch caused a piece of dirt or slag to get into eye. Physician removed object with no problem. This accident was not reported to supervisor until 02/03/2007.

Employee was running a rock crusher, when a rock hit him in the back of head under his hard hat.

Employee was attemting to remove bridged material when rock slid down the side of hopper cutting right leg

A screen being hoisted up to a screen tower became dislodged from the hook causing the screen to fall striking employee on right shoulder

WHILE USING AN AIR IMPACT WRENCH TO TIGHTEN BOLTS ON PLATE AT JAW CRUSHER, THE FORCE OF AIR EXHAUST BLEW SMALL PIECE OF RUST IN LEFT EYE. EE WAS WEARING SAFETY GLASSED BUT NOT GOGGLES. OBJECT CAME IN AROUND GLASSES FRAME.

WHILE DRILLING A HOLE IN METAL PLATE USING A 1/2" ELECTRIC DRILL THE BIT GRABBED, JERKED DRILL MOTOR OUT OF GRASP, MOTOR SPUN AROUND STRUCK RIGHT HAND, BROKE BONE IN RIGHT HAND.

WHILE PERFORMING DRILLING DUTIES A SECTION OF DRILL STEEL FELL FROM UNSECURED ROCK AND STRUCK EMPLOYEE ON RIGHT HAND.

WHILE OPERATING A WALK BEHIND DITCH WITCH EMPLOYEE INJURED LOWER BACK. DIDN'T ADVISE FOREMAN. WENT TO DOCTOR ON 2-28 OFF FROM WORK FEB 29 MAR 1 AND 2.

WHILE INSTALLING DRILL BIT ONTO HAMMER DRILL CAUGHT LITTLE FINGER ON RIGHT HAND IN PINCH POINT WHEN HAMMER DRILL ROTATING CLOCKWISE ENGAGED DRILL BIT SEVERING LITTLE FINGER BETWEEN 1ST & 2ND J OINT. EMPLOYEE SAID HE WAS SQUATTTING DOWN HOLDING DRILL BIT TO ALIGN IT WITH HAMMER DRILL. WHEN HE LET GO OF DRILL BIT, HIS FEET ROLLED ON LOOSE ROCK AND HE LOST BALANCE, FELL BACKWARD DROPP

WHILE CLEANING UP AROUND THE CONE CRUSHER, A 4" ROCK BOUNCED OFF THE SCREEN AND STRUCK EE ON LOWER BACK. EE WAS SENT TO DR., EXAMINED AND RELEASED FOR LIGHT DUTY FOR 3 DAYS. EE WAS REPRIMANDED FOR WORKING IN A RESTRICTED ARE WHILE PLANT IN OPERATION.

WHILE MOVING METAL BEAM SUSPENDED FROM POLE TRUCK, EMPLOYEE WAS GUIDING BEAM WITH HANDS, WHILE WALKING BACKWARDS TRIPPED OVER BEAM ON GROUND, FELL BACKWARDS, SUSPENDED BEAM STRUCK EMPLOYEE ON LEFT SHIN AND CHEST.

WHILE HELPING REMOVE A SECTION OF CONVEYOR WHICH WAS BEING HOISTED BY A CRANE EMPLOYEE WAS IN A SITTING POSITION PUSHING ON CONVEYOR WITH BOTH FEET. A SECTION OF CONDUIT BROKE LOOSE AND STRUCK EE ON HEAD BELOW SAFETY HELMET.

DURING RECENT RENOVATIONS EE WAS BENDING OVER CUTTING IRON FOR A FEW HOURS, AND LIFTING AND MOVING IT. AT LUNCH HE COMPLAINED OF PAIN IN NECK, SHOULDER AND ARM. DR SAYS AREA IS INFLAMED FROM S TRAIN.

AFTER STEAM CLEANING SOME OIL BARRELS, EE DISCONNECTED SPRAY HOSE FROM STEAM CLEANER BEFORE RELEASING PRESSURE. EXCAPING STEAM BURNT LOWER BODY.

ON 5-11-49 WHILE WELDING. EMPLOYEE SUSTAINED FLASHBURN ON RIGHT LEG ABOVE BOUT TOP. DID NOT REPT. TO FOREMAN. ON 5-16-94 WHIEL AT WORK BUMEPD RIGHT LEG AND ORE OPEN BLISTER EXPOSING RAW WOUN D. REPORTED TO FOREMAN. FOREMAN ADVISED OT GO DR.

WHILE WELDING ON JAW CRUSER RECEIVED FLASH BURNS ON UPPER CHEST, NECK AND FOREARMS.

STANDING ON RAISED BOARD CUTTING STEEL PATCH FROM BIN AT PORTABLE PLANT WITH TORCH. PATCH WEIGHING 100 LBS. FELL ON BOARD, BOARD BROKE, EMPLOYEE FELL 6' TO GROUND BROKE LEFT ANKLE.

WHILE STANDING ON A STEEL BEAM PERFORMING WELDING DUTIES, BRUISED BOTTOM OF FOOT.

HE WAS OPERATING DROPBALL THE DROP BALL SLANTED ON PART OF ROCK.IT THREW TIRE INSIDE OF DOOR AND HIT HIS LEFT ARM.

GOT THROUGH WELDING AND HAD TO PUT RODS BACK INTO THE STINGER. HAD TO TURN HEAD PART OF STINGER TO TIGHTEN ROD AND HE WAS STANDING TOO CLOSE.

EMPL STRAINED LOWER BACK MUSCLES WHILE OPERATING CRANE LEVERS.

HE WAS DRILLING AND ROCK FELL ON LOWER LEFT LEG AND KNOCKED HIM OFF OF TRACKS ONTO BACK AND NECK.

OPERATOR WAS REACHING FOR STEERING LEAVER ON DOZER CONTROL CONSOLE HE HIT HIS LITTLE FINGER AGAINST THE LEAVER INSTEAD OF GRASPING WITH HIS HAND WHEN HE HIT THE LEAVER WITH THE TIP OF HIS LITT LE FINGER IT BENT BACKWARDS & BROKE BONE