Buscar en el registro

EMPLOYEE WAS HELPING TO HOLD UP A JACKHAMMER DRIVING 2" BOLTS THROUGH THE SAE MILL LINER. HE HAD POSITIONED HIS RIGHT THUMB IN FRONT OF THE JACKHAMMER BOLT; WHEN THE HAMMERING BEGAN, THE BOLT GAVE WAY SUDDENLY CAUSING THE HAMMER STEEL TO ENTER THE BOLTHOLE AND CATCH HIS THUMB BETWEEN THE MACHINE AND THE MILL LINER. INJURY RESULTED IN FRACTURE TO TIP OF RIGHT THUMB; SUTURES OF NAIL

EE STATED THAT HE HAD PLACED THE 48" PIPE WRENCH ON A PUMP IMPELLER SHAFT. A NYLON SLING WAS ATTACHED FROM THE WRENCH TO THE TAKE UP ON THE BOOM TRUCK TO PROVIDE MECHANICAL ADVANTAGE. THE EE H AD HIS RIGHT HAND ON THE WRENCH HANDLE, HOLDING IT IN POSITION UNTIL SET. THE SHAFT TURNED SUDDENLY AS TENSION WAS APPLIED, CATCHING THE TWO FINGERS BETWEEN THE HANDLE AND THE PUMP GUARD.

GRINDING RUBBER. GRINDER JUMPED AND CUT LEG ABOVE KNEE CAP.

EMPLOYEE STATED THAT WHILE REMOVING THE BOLTS FROM THE TRACK MASTE RLINK THAT WHEN HE REMOVED THE LAST BOLT HTE LINK SEPERATED AND PULLED THE AIR WRENCH OUT OF HIS HAND AS THE AIR HOSE PASSED THROUGH HS HAND THE CLAMP USED TO HOLD THE COUPLING TO THE HOSE CUT HIS HAND.

EMPLOYEE WAS OPERATING A HDPE FUSION MACHINE. THE DEVICE UNEXPECTEDLY LIFTED UP. THE EMPLOYEE, IN REFLEX, PUT HIS HAND UP AND MACHINE HANDLE CAUGHT THE FINGERNAIL ON EMPLOYEES LEFT LITTLE FING ER. DOCTOR REMOVED FINGERNAIL & PUT 5 STITCHES.

EMPLOYEE STATED THAT HE WAS IN THE PROCESS OF CHANGING A DRILL BIT ON DL01 WHEN HE CAUGHT HIS FINGER IN BETWEEN THE HYDRAULIC WRENCH & THE DRILL DECK THE EMPLOYEE SUSTAINED A SLIGHT FX ON THE TIP OF THE PHALLANGE OF THE LH RING FINGER

THE EE STATED THAT HE ALONG WITH OTHER FLUOR A DNIEL EE WERE REMOVING THE CONCAVE PANELS FROM CR01. THE ROCK BREAKER WAS BEING USED TO SHAKE OR LOOSEN THE PANELS THE ROCKBREAKER BIT SLIPPED FR OM THE SIDE OF THE PANEL. THE HOUSING OF RB01 HIT THE EDGE OF ONE OF THE PANELS CAUSING IT TO CHIP AND SEND A PIECE FLYING 6-8 FT WHERE IT STRUCK THE EE ON THE SIDE OF THE FACE HITTING HIS GL

EMPL CLEARING A PLUGGED FEED CHUTE WITH A JACKHAMMER. DROVE THROUGH PLUGGED MATERIAL,JACKHAMMER DROPPED 18" AND CAUGHT HAND BETWEEN THE JACKHAMMER AND THE FRONT OF THE FEEDER.

USING TORQUE WRENCH OTHER EMP GRABBED IT PINCHED HIS FINGER

THE EMPLOYEE WAS SHARPENING DOWN HOLE DRILL BITS WITH A HAND HELD GRINDER.LATER IN THE SHIFT HE FELT SOMETHING IN HIS EYE.HE WENT TO THE DOCTOR THE NEXT DAY AND HAD A SMALL OBJECT REMOVED FROM HIS EYE.