Buscar en el registro

EE WENT TO SEE DR. TO GO VOER EMG RESULTS WHICH WERE FROM A PREVIOUS INJURY. EE ALLEGEDLY CLAIMS THAT WHEN GOING BACK TO REGULAR DUTY, HE AGGRAVATED A PRIOR INJURY. HE WAS SENT TO DR. FOR AND EMG AND CAR. DR. PUT HIM ON LIGHT DUTY 6-13-00. PRIOR TO THIS, THE EE WAS RELEASED TO FULL DUTY FORM HIS PRIOR INJURY AND HAD BEEN WORKING HIS REGULAR WORK DUTY AND HOURS.

DRILLER WAS PUSHING BOTTOM OF DRILL PIPE INTO LOADER WITH HIS LEFT HAND. DRILL PIPE ROTATED CATCHING THUMB OF LEFT HAND IN BETWEEN THE LOADER AND THE DRILL PIPE SMASHING THE THUMB.

EE WAS USING A 6" GRINDER TO CUT ALUMINUM PIPE. THE GRINDER KICKED BACK STRIKING THE EE'S FACE. EE SUFFERED LACERATION ON THE MOUTH AND BROKEN TOOTH.

EE WAS REMOVING BOLTS FROM SPRING CAGE ON DOZER WITH AN IMPACT WRENCH. THE SPRING RETAINER WAS BROKEN AND STACKED UP. THIS CAUSED MORE PRESSURE ON THE SPRING AND IT CAUSED THE RETAINER CAP TO MOVE FORWARD AND MASH HIS HAND BETWEEN THE CAP AND THE SPRING MOUNT.

EE WAS ATTEMPTING TO INSTALL A CHUTE. THE LIFTING CHAIN WAS NOT HOOKED UP PROPERLY. AS THE CHUTE WAS LIFTED THE CHAIN PULLED BACK ON THE CHUTE. THE LOWER END OF THE CHUTE THAT POSITIONED IN TH E CRUSHER HOPPER SLIPPED OUT DROPPING THE UPPER END ONTO THE EE'S RIGHT WRIST.

BULLDOZER OPERATOR OVERTURNED ON BASE STOCKPILE. EQUIPMENT ROLLED OVER ON IT'S SIDE. FALL OF APPROX. 15 FT. OPERATOR RECEIVED CUTS AND BRUISES. OPERATOR WAS TO CLOSE TO THE EDGE OF PILE.

EE WAS USING A TORCH TO CUT OUT A STEEL BEEM & WHEN THE BEAM WAS PARTIALLY CUT IT POPPED OUT STRIKING EE ON THE HAND - BROKE FINGERS.

EE WAS STANDING ON THE SCREEN DECK WHILE EE ATTEMPTED TO HOIST A 4'X8' SCREEN PANEL FROM THE SHAKER DECK. THE WELDIGN ROD WHICH EE HAD FASTENED TO THE SCREEN PANEL TO LIFT WITH BROKE. THE P ANEL DROPPED ONTO THE SCREEN PENNING EE'S LEGS BETWEEN THE PANEL AND THE SCREEN DECK WALK.

EE WAS CLOSING ACCESS DOOR TO CRUSHER WHEN A ROCK WEIGHING APPROX 100 LBS FELL OUT OF THE CRUSHER AND STRUCK THE EE'S LEFT LEG.

EE WAS USING A CUTTING TORCH TO REMOVE TRACK ADJUSTER FROM A DOZER. HE WAS UNAWARE THAT THE ADJUSTER WAS STILL UNDER PRESSURE. AS HE WAS CUTTING THE LAST BOLTS, A CRACK OPENED, RELEASING A STR EAM OF PRESSURIZED GREASE STRIKING THE EE IN THE FACE AND GROIN. THE GREASE CUT LACERATIONS ON THE FACE AND SCROTUM CAUSING TISSURE DAMAGE AND THE EMBEDMENT OF GREASE IN THESE AREAS.

EE WAS USING AN ELECTRIC HAND BUFFER TO REMOVE RUST FROM PARTOON. A PARTICLE OF RUST FLEW UNEER HIS FACE SHIELD INTO THE RIGHT EYE.

CONTRACTOR WAS GRINDING ON AN APPARENTLY BAD WELD ONA SECTION OF 8" PIPE. THE WILD BROKE CAUSING THE PIPE TO STRIKE THE CONTRACTOR ON HIS UPPER RIGHT LEG. EACH END OF THE PIPE WAS ON THE GR OUND WHILE THE CENTER OF THE PIPE WAS OVER A DEPRESSION IN THE TERRAIN. THE CONTRACTOR WAS WORKING IN THIS AREA.

EMPL LEAVING QUARRY LOADED,PULLED AN INCLINE THE ENGINE DIED AND TRUCK STARTED BACK DOWN INCLINE. EMPL TRIED TO STEER TRUCK THROUGH A CURVE.TRUCK FAILED TO NEGOTIATE CURVE OVER-TURNING RESTING UPSIDE DOWN.

EMPLOYEE WAS FILLING CONE CRUSHER WITH OIL,HE WAS USING A 12 VOLT PUMP.THE BATTERY HE WAS USING FELL ON TOP OF HIS RIGHT FOOT CAUSING THE INJURY(BRUISED).

INJURED WAS ATTEMPTING TO FREE A ROCK THAT WAS WEDGED BETWEEN THE CABLE A SHEAVE ON THE MOTOR CRANE. HE WAS PULLING ON THE CABLE, THE ROCK FELL ON THROUGH, THE CABLE WENT DOWN AND PULLED HIS H AND IN BETWEEN CABLE AND SHEAVE. FINGER KEPT HURTING AND HE WENT TO DR 8-30-90, WAS X-RAYED AND GIVEN PRESCRIPTION FOR INFLAMMATION.

INJURED WAS USING AN AIR WRENCH TO REMOVE A NUT FROM A BOLT ON FRONT END LOADER BUCKET AND WAS HOLDING THE BOTTOM OF THE BOLT WITH THE PALM OF THE HAND. WHEN THE BOLT LOOSENED, THE HEAD OF THE BOLT CAME OUT OF THE SOCKET AND BEGAN SPINNING AT A VERY FAST RATE OF SPEED.