Buscar en el registro

Sharping a machete in a vice. Employee had a hand held sharpener and was pulling it across the blade. Employee's hand slipped off the sharpener handle and the right bottom ring and little fingers hit the blade.

Just finished up a blend and were cleaning off a grate on the blender. 1 man was holding the grate up as IE was wiping their hand under the grate on the flat part of the blender, cleaning the excess powder. The man holding the grate didn't know the hand was under the grate and dropped it on the tip of IE's right hand middle finger tip.

Employee was performing maintenance on palletizer, making adjustments to turntable. Employee pulled on wrench to loosen a bolt on the bearing & felt a pinching pain in neck & shoulder; reported incident to supervisor on 05/30/17 because pain was still present. Employee was scheduled off work on 05/31/17 & went to clinic for checkup (no time was lost from work).

Employee was cleaning iron oxide (umber) from inside the bottom cone of the bag house; inserted right hand into enclosed chute leading to moving air lock; fingertip of right index finger was partially amputated.

Employee was walking up stairs; toe of boot caught on grate and caused employee to fall, hitting left arm/elbow on toe board. Employee declined medical attention at time of incident, but sent for medical attention at 2:30pm on 10/28/2015; advised to wear sling on left arm and not use arm for 2-3 days. Employee was not scheduled to work again until 11/02/2015.

Employee was picking barite on picker belt; large rock rolled back down the conveyor belt that had already passed employee and rolled on top of left hand and four fingers.

Employee was patching a hole in a water pipe. He stepped across/stood over pipe to weld patch in pipe; right foot slipped and twisted right ankle.

Employee was changing screens at Washer and screen frame fell on right index finger causing bruising and soreness.

Picked up bearing housing from back of welding truck. Brought it through door of shop, lifted it up to table and felt something pull and burn beneath rib cage. Housing weighs 45-50 lbs (as per employee's description).

Employee was checking oil and greasing WA600 loader. Stepped down and missed the step and fell to the ground, hurting lower left side of back, left hip and left leg. Employee thought he would be okay, so he did not go to the doctor at the time of the incident. On 11/27/2012, employee was still in pain and was sent to the doctor for evaluation.

A 22 ton rough terrain crane was traveling up an incline on a dirt access road when the crane stalled, lost power and steering, rolled back into the berm on the dirt road, turning over the crane and trapping the operator inside.

Stepped over dirt hill and knee popped. Grabbed handrail to keep from falling. Went to emergency room. Only drawled one week workers comp.

Employee was poking product through chute; pole kicked back and injured shoulder.

Employee was walking across catwalk to his workstation at the water gun. He slipped and fell into the guardrail and mashed his hand on the guardrail with his body weight. He jammed his left index and middle finger.

Employee went to adjust gap between top roll and end of conveyor chain. Co-worker started chain conveyor. Injured's left little finger hand was pulled into gap. The conveyor stopped. Other employee came to victim and tried to pull his hand out but could not. He then got a steel bar to widen gap and pulled victim's hand free.

Employee reached down to pick up bag to weigh and felt a sharp pain in his lower back.

EE WAS BACKING UP A 35 TON DUMP TRUCK TO DUMP A LOAD OF BARITE. WHEN THE DUMP WAS RAISED THE GROUND TURNED LOOSE UNDER BACK TIRES. TRUCK FLIPPED OVER HIGHWALL AND FELL APPROX 30 FT LANDED UPSIDE DOWN. 911 WAS CALLED & EE WAS TAKEN TO ER ROOM. EE REC'D BROKEN LEFT ARM & COMPLAINED OF LOWER BACK PAIN

WHILE EMPLOYEE WAS CUTTING WITH A HEDGE TRIMMER, HE CUT HIS RIGHT HAND AND RECEIVED STITCHES.

THE CONTINUOUS MOTION OF MOVING 50 LB. BAGS FROM ONE PALLET TO SCALES THEN TO ANOTHER PALLET CAUSED MUSCLE STRAIN TO LOWER BACK.

EE was lifting and changing out screens at the washer plant on 4-1-04 when he began to fell soreness. on 4-2-04 he loaded a belt for denver filter dishcarge in back of truck when he felt pain on right side of groin. ee went to dr on 4-5-04, 2pm

THE LOADING SYSTEM KICKED OFF AT SEPARATOR PLANT AND THE EE WENT TO TRIP SWITCH WHEN HE TRIPPED OR SLIPPED ON STEP. HE FELL AND CAUGHT HIMSELF WITH LEFT ARM IN AN AWKWARD POSITION, DISLOCATING HIS SHOULDER.

EE MOVING MUDBALLS W/LOADER; HEARD SOMEONE FALLING DOWN CHUTE, REVERSED TO BACK OUT OF WAY. THE PERSON HIT THE LIP OF BUCKET, BOUNCED UP AND HIT THE TOPS THEN CRASHED THRU THE WINDSHIELD. GLAS S BROKE LENS OF GLASSES ALLOWING FOEIGN MATTER THE LEFT EYE.

EE WAS WORKING AT SEPERATOR PLANT WHEN WIND BLEWSOMETHING INTO HIS EYE EVEN THOUGH HE WAS WEARING SAFETY GLASSES.

EE WAS WORKING ON RETURN PUMP AT WASHER PLANT WHEN HE FELT SOMETHING PULL IN HIS GROIN AREA AND DISCOMFORT BEGAN. NOTE: AS OF THIS DATE HE HAS NO LOST TIME. HOWEVER, THE DR. STATED THAT HIS HERNIA WILL HAVE TO BE REPAIRED AND HE IS REFERRING HIM TO A SURGEON.

EE WAS WORKING ON PACKER AND AS HE TWISTED AND LIFTED, HIS MUSCLES TIGHTENED CAUSING LOWER BACK PAIN.

EE PICKED UP ON TRAILER TO CONNECT ONTO BALL OF TRUCK WHEN HE FELT A PULL IN HIS BACK.

EE TURNED TO CATCH A LADDER BEFORE IT FELL AND TWISTED HIS BACK.

EMPLOYEE WAS WORKING ON A BIN SCREW AND PINCHED LITTLE FINGER ON RIGHT HAND BETWEEN THE ANGLE AND THE MOTOR.

EMPLOYEE WAS DRIVING COMPANY TRUCK TO PLANT SITE WHEN DEBRIS FLEW IN WINDOW OF TRUCK AND LODGING IN HIS RIGHT EYE.

EE WAS CLIMBING THE LADDER TO GET IN HIS TRUCK, APPROX. 8 FT. TO GOT TO A STEP AND HIS BACK STARTED HURTING. HE THOUGHT AND WOULD BE OK. HE DIDNT THINK HE NEEDED TO GO TO THE DR. AT 1:30 PM HE TOLD OTHER THAT IT WAS STILL HURTING. OTHER RETURNED TO THE OFFICE AND CALLED COMP FIRST 2:25 PM HE THEN CALLED UPPERT CARE AND SENT HIM TO THE DR.

EE WAS IN THE MAINTENANCE SHOP HELPING TWO OTHEREMPLOYEES WORK ON THE CYLINDER OF A LOADER. THEYWERE TRYING TO TURN A 4" NUT ON THE CYLINDER USING A 4" PIPE ON THE END OF THE WRENCH TO HELP TU RN THE NUT. THE NUT CAME FREE AND THE PIPE FELL OFF OF THE WRENCH AND HIT TOP OF INJURED'S FOOT.

HE WAS SITTING ON THE LOADER THAT HE WORKS ON. AS HE WAS SITTING HE SAID HE FELT A TWINGE IN HIS BACK. HE TOLD COWORKER THAT HE NEEDED TO THE DR. SENT TO MEDICAL CENTER. TOLD THE RETURN TO REG ULAR DUTY. HAS FOLLOWUP APPTS. FOR THERAPY. THIS WAS A REOCCURANCE OF AN INITIAL INJURY.

EE WAS WEED EATIG AROUND THE PLANT & GOT INTO SOME POISON IVY HE REPORTED THIS TO STAN BEARDEN STAN TOOK HIM TO URGENT CARE WHERE EE WAS GIVENA SHOT FOR TREATMENT.

EE WAS FUELING THE DRAGLINE WHEN HE FINISHED HE CLIMBED DOWN OFF OF THE MACHINE & WHEN HE JUMPEDOFF OF THE LAST STEP HE HAD A TWINGE IN HIS BACKHE REPORTED THIS TO RONNIE POSEY ON 9/21/99 HE W ENT TO DR & WAS TOLD THAT IT WAS THE MUSCLE IN HIS BACK THAT WAS INJURED HE WAS PUT ON LIGHT DUTY & GIVEN A RX.

EMPLOYEE WAS CHANGING SHAKER SCREENS, EMPLOYEE GOT HIS LEFT HAND HUNG UP IN THE GRATING OF THE SCREEN AND PULLED HIS FINGERS.

EMPLOYEE WAS TRYING TO SHOVE A LARGE ROCK THROUGH BREAKER SCREEN. AS HE WAS CLIMBING OUT OF SCREEN, HE TURNED AND FELT A PULL IN HIS BACK. THE FOLLOWING DAY, HE HAD A PAIN IN HIS LEG BUT HIS B ACK WAS BETTER. CALLED FOR DOCTOR'S APPOINTMENT.THIS WAS NOT A LOST TIME ACCIDENT.

HE WAS WORKING AT THE PACKER IN THE OCHRE MILL. HIS SHOULDER STARTED HURTING. HE REPORTED IT TO SUPERVISOR. HE WAS SENT TO THE DR. WHERE HE WAS TOLD THAT HE HAD SOME TENDONITIS. HE WAS TOLD TO DO LIGHT DUTY FOR THE REST OF THE WEEK.

EE WAS PACKING OCHRE ON FRIDAY. SAT MORNING HE GOT UP AND HAD SOME BACK PAIN. HE WORKED MONDAY PACKING OCHRE BUT WAS STILL SORE. TUESDAY HE WENT TO DR. ATWELL, WHO PUT EE ON LIGHT DUTY AND TOL D HIM TO GO TO HYSICAL THERAPY 3 DAYS A WEEK FOR4 WEEKS DR ALSO TOLD EE TO COME BACK IN 3 WEEKS FOR A CHECK UP.

EE WAS WORKING AT COHRE MILL AND STRAINED HIS BACK AS HE PICKED UP A BEARING AT THE NORTH DRYER.

AS EE WAS WALKING UP HILL TO THE BREAKROOM HE SLIPPED ON LOOSE ROCK CAUSING INJURY TO RIGHT FOOT. HE WENT TO DR. ON 1-20-99 AND FOUND HE HAD A FRACTURE TO HIS RIGHT FOOT.

EE WAS ASSITIN GEE IN THE OCHRE MILL PACKING THE OCHRE IN BAGS. WHILE PUUTTIN GTHE BAGS ONTO A PALLET ONE OF THE BAGS FELL TO THE GROUND, EE BENT OVER TO PICK UP THE BAG AND THE BAG GOT CAUGH T ON THE SIDE OF THE PALLET AND CAUSED HIM TO PULL A MUSCLE ON THE LEFT LOWER SIDE OF HIS BACK.

EE WAS CLEANING HIS BUCKET ON LOADER. HE STEPPEDBACK AND SLIPPED. HE TRIED TO CATCH HIMSELF AND TWISTED HIS BACK.

EE WAS PULLING DOWN ON A PIPE WRENCH WHEN THE WRENCH SLIPPED. HE LATER REACHED TO GRAB THE WRENCH AND HURT HIS BACK. LATER THAT WEEK HIS BACK KEPT HURTING SO HE WENT TO DR. DR. SAID HE HAD A S PRAINED LUMBAR.

AS EE WENT TO EE DUMP TRUCK, HE PUSHED UP ON LEVER OF TRASH HOPPER AND THIS IS WHEN HE FELT PAIN FROM HIS ELBOW DOWN TO THE FINGERS. HE WENT TO DR AND WAS PLACED ON LIGHT DUTY.

EMPLLOYEE WAS STEPPING OUT OF THE WATER GUN SHED WHEN H SLIPPED ADN FELL ON ICE THAT WAS BUILD UP ON STAIRS WHICH RESULTED IN MINOR BRUSING.

AS EMPLOYEE STEPPED OFF HIS LOADER ONTO GROUND HE PULLED A MUSCLE IN HIS LOWER BACK.

WHILE CHECKING FLOT PLANT CHEMICAL TANK HE TWISTED HIS ANKLE. SEE ATTACHED REPORT

EE PARKED HIS DUMP TRUCK TO LOAD SAND. AFTER PARKING HIS TRUCK HE PUT SCOTCH BLOCK (9.5LB) UNDER THE TRUCK TIRE AND AS HE RAISED UP HE PULLEDA MUSCLE IN HIS BACK.

EE WAS WORKING ON GRAVEL CHUTE WHEN HE RAISED UP HITTING HIS HEAD ON THE JIG ORE CHUTE.

EMPLOYEES LOCATED AN AIR LEAK IN THE FELXIBLE 1/2" ID LINE LOCATED ABOVE THE RECYCLE HOPPER INSIDE THE OCHRE MILL. THE MAINTENANCE TEAM DID NOT DEPRESSURIZE THE SYSTEM BY DISENGAGING THE THE A IR COMPRESSOR AND BLEEDING THE LINE. AS INJURED WAS MANUALLY RESTRICTING AIR FLOW ANOTHER EMPLOYEE DISCONNECTED THE FLEXIBLE LINE FROM THE VERTICAL FIXED STEEL RECEIVER LINE. OTHER EMPLOYEE T