Buscar en el registro

Employee was cleaning near the Pan Conveyor at 731-B East side. While removing material from the walkway, the employee slipped on uneven ground, and the left hand contacted the moving conveyor, which lacked proper guarding. Onsite personnel assisted and transported the employee to a medical facility for stitches on two fingers.

Employees left index finger came into contact with an a/c fan blade.

Employee's right index, middle and ring finger were caught in a rotary feeder.

Employee was working in close proximity to a moving forklift, and forklift bumped into employee's right ankle.

Loader impacted the man lift in the rear tire and body shroud. The impact caused the boom and basket to swing violently creating an impact between employee and the hand rail of the basket.

Employee's tip of his left ring finger came in contact with a roller and the metal track that the conveyor rolls on. A small section of tissue from inside tip of his left ring finger was pinched off.

employee was burned when hot kiln feed dust discharged from the tertiary air drop-out box discharge chute when the employee started to remove the collection dumpster under the chute. The material flushed over the dumpster and onto the forktruck and the operator, causing the injuries and damaging the forktruck.

Raw Material Handler was performing equipment check on a Komatsu loader and was checking belt tension in engine area and did not realize engine was still running when his middle and ring finger on his left hand became caught in V-belt. The ends on both finger were amputated just below the finger nails.

THIS EMPLOYEE WAS USING A BOBCAT LOADER ON THE WEST SIDE OF 708 CONVEYOR BELT CLEANING UP SPILLAGE AND DUST ACCUMULATION IN THE CLINKER STORAGE BUILDING. HE STATES THAT AS HE WAS DOING THIS HE SUDDENLY FELT SOMETHING IN HIS LEFT EYE. HE WAS WEARING HIS SAFETY GLASSES AND SUSPECTS THE DUST FELL OFF HIS EYE LASHES OR CAME FROM SOME SWEAT RUNNING INTO HIS EYE. HE FLUSHED HIS EYE TWICE

WORKER WAS STANDING BESIDE AN ELECTRIC MOTOR SUSPENDED BY A 2' WIRE ROPE CHOKER ATTACHED TO T-HEAD BOLT LAID ACROSS FORKS OF FORKLIFT. DRIVER BACKED INTO UNSEEN CHUCKHOLE CAUSING MOTOR TO SWIN G BACK & FORTH WHILE 8-10" OFF THE GROUND. THE FORWARD MOTION CAUSED THE BOLT TO SLIDE OFF THE TIPPED FORKS & THE MOTOR DROPPED ONTO HIS LEFT BOOT TOE.

HE WAS TRYING TO MOVE A HUGE BOULDER WITH A CAT 988F FRONT END LOADER. WHEN HE PICKED IT UP WITH THE BUCKET, THE TAIL END OF THE LOADER CAME UP AND AT THE SAME TIME THE BOULDER SLIPPED OFF THE BUCKET EDGE. THIS CAUSED THE REAR END OF THE LOADER TO FALL BACK DOWN AND BOUNCE. THE BOUNCING THE OPERATOR TOOK EVIDENTLY CAUSED LOWER BACK PAIN.

INJURED FOUND IDLER ROLLER ON CONVEYOR BELT NOT WORKING SO HE USED A STEEL BAR TO DISLODGE MATERIAL STUCK BETWEEN ROLLER & SUPPORT BRACKET. HE HIT THE ROLLER WITH A BLOW. THE BAR BOUNCED UPWAR D & GOT CAUGHT BETWEEN THE ROLLER & MOVING BELT,FORCING THE BAR UP AGAINST AN ANGLE IRON FRAME. HIS GLOVED HAND HOLDING THE BAR STRUCK THE FRAMECAUSING FRACTURE. DIDN'T STOP BELT BEFORE WORKI

INJURED WORKER WAS OPERATING A CAT 988 FEL THE NIGHT OF THE ACCIDENT AND REACHED UP TO THE CEILING OF THE CAB TO ADJUST THE AIR CONDITIONING VENT IN THE DARKNESS. THE DIRECTIONAL VENT LOUVER W AS MISSING AND HE HAD NOT NOTED IT. IN HIS EFFORT TO GRAB THE LOUVER HE STUCK HIS FINGER THROUGH THE 4" HOLE AND IT WAS STRUCK BY THE FAN BLADE WITHIN CAUSING A CUT THAT REQUIRED STITCHES.

WORKER WAS USING THE RECLAIMER TO DRESS DOWN A PILE OF CRUSHED LIMESTONE WHEN A ROCK [3"-4" DIA.] WAS DISLODGED BY A RECLAIMER PADDLE & ROLLED DOWN THE PILE. IT FELL OFF THE EDGE OF THE 66" RE TAINING WALL & BOUNCED OFF THE CONVEYOR BELT 2' BELOW & HIT THE WORKER IN THE FOREHEAD UNDER HIS HARDHAT. THE RESULTING LACERATION WAS CLOSED WITH 4 SUTURES & THE WORKER RETURNED TO HIS JOB.

INJURED WAS OBSERVING THE LOADING OF CLINKER INTO A HOPPER INSIDE THE CLINKER STORAGE BLDG WHEN SOME OF THE CLINKER DUST GOT BEHIND HIS GLASSES AND INTO HIS EYE. HE ATTEMPTED TO FLUSH THE PART ICLES OUT AND THEN WENT BACK TO HIS JOB. AT THE END OF HIS SHIFT HE TOLD HIS SUPERVISOR HE WAS OK AND DECLINED TO GO TO THE DR. ONE HOUR LATER HE WENT TO THE EMERGENCY RM FOR ASSISTANCE.

THE EMPLOYEE WAS CROSSING UNDER THE RECLAIMER (BETWEEN THE RECLAIMER AND THE CABLE TRAY). HE PLACE HIS FOOT ON THE CABLE CARRIER TRACK, THE WHEEL OF THE CABLE CARRIER PINCHED HIS ANKLE.

HANGING CABLE WITH FORKLIFT STRECHED OUT TO HANGIT FELT PAIN IN LOWER BACK

THE EMPLOYEE WAS ELEVATED IN A PERSONNEL BASKET. THE OPERATOR STARTED LOWERING THE BASKET AND THE ENTIRE FORK MECHANISM FELL APPROX. 8-9 FEET. MATERIAL THAT HE WAS KNOCKING OFF OF THE CONVEYOR STRUCTURE WAS WEDGED IN THE TRACKS OF THE FORKLIFT KEEPING IT FROM COMING DOWN.

JARRED BACK WHILE OPERATING FORKLIFT ON THE ROAD LEADING TO QUARRY.

CHECKING SOME R2LLERS ON CONVEYOR BELT WHEN HAND WAS CAUGHT IN ROLLER.