Buscar en el registro

Employee and two co-workers were changing a 220V Surface Pond Pump when he slipped and twisted back.

After loading a coal truck I brought the end loader over by the shop and started to exit the machine. I got my feet tangled up and fell from top step to the ground.

Subject was attempting to crush a piece of rock that was lodged in the Belt Feeder. He said, he was busting the rock with a sledge hammer and he went to move it with his left hand, the rock broke crushing his left hand.

EE was positioning a gear for the continuous miner ripper when he felt a sharp pain in his lower back area and a burning sensation in his left leg.

EE had loaded a coal truck when he went to exit the end loader he lost his footage ended up swinging on hand rail - hitting his back & head on side of end loader.

Crew were setting timbers one guy threw a timber to be set and hit EE's right hand.

EE roof bolter operator had started to bolt in the #6 entry when he attempted to bend G bolt he hurt the lower part of his back.

Employee was bolting a corner when a piece of draw rock fell and hit him on the left hand.

Scoop operator was scooping rock and know out a stopping and a piece of rock and a block hit right hand of operator.

Bolting top rock fell striking him on Rt. Forearm, as he was drilling.

Bolting top got finger caught between drillpot and drill steel, mashed little finger and cut it.

EE was attempting to move rock out of the feeder when the rock fell over & caught his thumb between the rock & metal.

EE was taking drill steel apart when his right ring finger was mashed between 2 pieces of drill steel.

A roof fall occurred in the #4 right crosscut into the #5 heading. The fall was approximately 25'long x 18'wide x 8' high. The roof fall did not affect workers,ventilation nor equipment. The fall also continued in the #5 heading on 4-22-10 appx. 10' in length x 18, wide x 8' high.

Bending a roof bolt.

EE was crawling to get back on his scoop when a piece of draw rock fell & hit him on the neck & back.

EE was operating a shuttle car, when he hit a small hole and it bounced him into the top of the canopy.

Installing tram motor on a continuous miner, he was prying on the motor with a slate bar.

Employee was rockdusting around A2 belt drive when he slipped and fell against the tailpiece hitting on his right side.

EE attempted to pull a sumercable pump out of the water when his footage slipped he hit right knee down on a piece of rock.

Ran shuttle car into scoop bucket causing him to hit canopy.

Was running shuttle car and hit a hole jarring back.

Subject was attempting to hang miner cable by his self.

HE WAS GETTING READY TO SCOOP THE #1 ENTRY WHEN A PIECE OF DRAW ROCK ABOUT 1"THICK X 6"LONG FELL BETWEEN ROOF BOLTS & CUT HIS MIDDLE FINGER.