Buscar en el registro

Employee was changing a bearing on a tail pulley that snapped forward and cut left pinky finger.

Employee placed his left hand in door jam of loader, door wasn't securely latched which allowed the door to slam shut breaking his finger.

Employee hurt wrist & forearm while shoveling.

Shop area - employee was carrying part of a steel blocking when his right knee popped.

Employee was tightening a bolt on excavator bucket with 3/4" impact wrench. His finger got caught between bolt and h-link causing a gash on left middle finger. Employee was taken to the nearest hospital where his finger was stitched.

After following proper lock out tag out procedures, EE went to complete the task of dislodging a rock from the under belt conveyor of the Minyu jaw. While not visible from walkway approaches, a few pieces of material had worked to the edge of the feeder. While attempting to remove the rock, a rock from above struck hardhat of EE causing him to fall to the ground.

Twisted ankle on a rock

Employee was hit in the chin by a cable when he attempted to jump over it, but instead stepped on the cable as it was being tightened. Employee went to the doctor for some stitches and then went back to work for the rest of the day.

Two employees were placing a backstop for a ramp to a feeder hopper. The backstop, 5' x 15' x 1/2" steel plate, was lifed vertical to lean against feeder, the groundman pushed up on the steel plate by hand to over center when he did that the chain came unhooked from the plate which caused the steel plate to fall toward him pinning his leg against the ground.

Employee was putting the guardrail back on a loader. The rail slipped and cut the employee's left index finger.

Employee was repairing roller belts. Hand was drawn in and pressed between roller and conveyor belt.

Cutting on El-Jay screener - a piece of slag fell down into left top of boot causing a burn to the ankle area. Removed boot, administered first aid and employee was taken to the doctor.

Employee was cutting a screen with a grinder. The grinder slipped and cut his finger.

Employee was cleaning up floor pit with a loader. He hit a rock which stopped the loader - seat belt came lose and the employee hit his head on the windshield and his stomach hit the steering wheel causing some bruising.

Employee was replacing O-ring of steering cylinder with 14mm wrench and it slipped off bolt, right hand jerked back hitting against the corner edge of metal frame on the loader. Employee could not open his hand afterward and was told to go to the doctor.

Material in a cone discharge conveyor tailpully caused the belt to stop, the plant operator radioed ee to check out the belt. He climbed up on the plant grabed the drive belts to turn the conveyor backword by hand to clean the tailpulley out. As he did the plant operator started the conveyor.His thumb went arond the Vee Belt Pulley severing the tip of his thumb.

Employee was shoveling around a crusher feed belt, which was feed by another belt. He noticed some material had built up in the rock box and was spilling over onto the ground. As he attempted to clear the material with a shovel, he placed his hand on the rock box and was struck on the left hand index finger tip by a rock.

Employee was driving a loader and hit a pothole and claims his back hurts. He went to the doctor but has continued working full time.

Employee sliped and fell off the Screen Deck landed wrong on his foot which resulted in a possible sprained ankle

EE WAS ATTEMPTING TO CLEAN UP A PISTON ON THE WIRE WHEEL SIDE OF THE SHOP BENCH GRINDER. THE TOOL REST WAS BROKEN OFF & ONE WAS ON ORDER. THE GRINDER SHOULD NOT HAVE BEEN USED. EE WAS HOLDIN G PISTON BETWEEN HIS 2 HANDS & PISTON GOT CAUGHTIN THE WIRE BRUSH & CAUGHT THE TIPS OF HIS FINGERS

TURNING A LOADER WHEEL OVER- FLANGE OF WHEEL SLIPPED - FINGER GOT CAUGHT BETWEEN FLANGE AND WHEEL AND RIGHT FINGER WAS LACERATED.

OPERATOR USED HIS FOOT TO TRY TO MOVE A STUCK PIECE OF ASPHALT AND IT KICKED BACK AT HIM PINCHING HIS ANKLE EITHER BETWEEN TWO PIECES OF ASPHALT OR BETWEEN THE SIDE OF THE FEEDER AND THE ASPHA LT.

THE WELDER WAS USING ELECTRIC GRINDER AND A PIECE OF FOREIGN MATERIAL GOT INTO HIS LEFT EYE.

EE STEPPED OUT OF HIS TRUCK HE TOOK A COUPLE OF STEPS AND WENT DOWN AT THE TIME HE WENT DOWN HE COMPLAINED OF PAIN SHOOTING DOWN HIS LEG LIKE HIS HIP WENT OUT OR HIS LOWER BACK WENT OUT.

ADJUSTING A TAIL PULLEY AND WRENCH CAME OFF AND GOT ON TAIL PULLEY THEN HTI MY HAND.

MOVING STEEL BEAMS, TURNED AND SEEMED TO TWIST LEFT LOWER BACK.

A ROCK HE WAS MOVING SLIPPED AND SQUEEZED HIS FINGER BETWEEN ANOTHER ROCK.

CHAIN SADDLE ON BUCKET OF LOADER PULLED ON CHAIN TO ALIGN SADDLE W/PICK POINT BUCKET APPROX 10' OFF GROUND WHEN CHAIN SADDLE PEEPLED OFF BUCKET EDGE AND FELL TOWARDS HEAD AREA AND IN THE PROCE SS OF WARDING OFF THE BLOW W/RIGHT ARM ELBOW WAS IMPACTED RECEIVING THE DAMAGE.

LIFTING AN DINSTALLING HYD MOTORS ON 980 C WHEEL LOADER IN TIGHT CONFINED AREA.

A MACHINE WAS BEING DISMANTLED WHEN A PIN CAME LOOSE. SCREEN AT THE MACHINE SHIFTED UNEXPECTEDLY& SWUNG INTO THE VICTIMS ARM ON THE RIGHT SIDE A SAFETY CHAIN HAS BEEN ADDED TO ELIMNATE ANY UN SUSPECTED MOVEMENT IN THE FUTURE

EE WAS CUTTING A PIECE OF RUBBER WITH A RAZOR KNIFE. IT SLIPPED AND HE CUT HIS HAND.

DRIVER NOTICED THAT SOME ASPHALT MATERIAL WAS NOT CLEANED OUT OF THE TRUCK BOX FROMA PREVIOUS JOB & JUMPED ONTO THE TRUCK BOX & STRAINED HIS LOWER BACK. INITIAL BACK INJURY ON A PREVIOUS INJUR Y WITH ANOTHER COMPANY

LOADING ROCK CRUSHING EQUIPMENT ONTO FLAT DECK SEMI TRAILER. UNHOOKED CHAINS FROM LOAD--STEPPED AWAY AND STUMBLE ON LOOSE CHAIN ON DECK AND FELL FROM TRAILER. LANDED ON RIGHT SIDE OF BODY ON C RUSHED GRAVEL PIT FLOOR AND ROLLED TO A SITTING POSITION. BRUISED RIB CABE LEFT SIDE.

HE WAS HAMMERING ON A PIECE OF STEEL AND SOMETHING FLEW INTO HIS EYE.

EE WAS INSIDE A SCREEN DECK LIFTING 1" X 6" BAR, HE STOOD UP & HIT HIS SHOULDER ON A CROWN BAR. WE WERE NOT NOTIFIED OF THE INCIDENT. WE FOUND OUT ABOUT TI 5/11/98. EE SAID AT THE TIME IT WAS NO BIG DEAL. HE HAS BEEN INFORMED THAT IT IS.

FLASH BURN TO THE EYES--WORKING NEAR WELDER WORK UP NEXT DAY WITH BURNS.

EE SLIPPED OFF TRUCK AND DISLOCATED RIGHT KNEE AND STRAINED LEFT KNEE. EE IS A TRUCK DRIVER WITH A HISTORY OF WEAK KNEES DATING PRIOR TO HIS EE WITH AGGREGATES WEST, INC.

EE WAS CHANGING SCREEN AND TIGHTENING 60' OF SCREEN WHEN HE PULLED SOMETHING IN HIS SHOULDER.

EE WAS SWINGING A SLEDGE HAMMER. THE HAMMER SLIPPED. EE HIT HIS LEFT HAND ON PIECE OF MACHINERY CAUSING A BRUISE.

EMPLOYEE WAS HANDING ANOTHER EMPLOYEE A BELT UP ON A CONVEYOR WHEN SOME ROCK DUST AND PARTICLES FELL INTO HIS FACE. A ROCK PARTICLE WAS REMOVED FROM THE LEFT EYE LATER THAT DAY.

RUNNING LOADER AND TURNING HEAD QUICKLY CONTINUOUSLY FOR EXTENDED PERIOD OF TIME CHECKING TO MAKE SURE NO ONE IS BEHIND LOADER, RESULTED IN NECKAND SHOULDER PAIN. CHIROPRACTIC CARE SOUGHT ON 9/4/97.

EMPLOYEE WAS LIFTING CHUTE WITH LOADER AND BOOM. HE SPUN AROUND ITNO THE CORNER OF THE BOOM WHICH CAUSED A CUT OR PUNCTURE ON HIS HEAD.

EE WAS GRINDING A PIECE OF METAL AND A SMALL PARTICLE OF METAL WAS THROWN UNDER HIS SAFETY GLASSES. EMBEDDED IN HIS RT EYE.

EE BUMPED HIS HELMET & IT FELL OFF THE CRUSHER, CRACKING THE LENS. EE BEGAN WELDING (ARC) AND CONT FOR SOME TIME BEFORE HIS RIGHT EYE BECAME SORE. THE CRACK IN THE HELMET WAS ON THE SIDE (RIGHT) ALLOWING LIGHT THRU TO FLASH BURN HIS RIGHT EYES.

EWE WAS UNDER WASH PLANT CHANGING SCREENS, HE HOISTED HIS BODY UP WITH ONLY HIS ARMS TO SUPPORT HIM AND PROCEEDED TO PUSH HIS WAY OUT FROM CONFINED SPACE FEET FIRST. THE WEIGHT AND MOVEMENT MA DE HIS RIBS SORE SHORTLY AFTERWARD. HE TOLD THE FOREMAN OF THE SORENESS, BUT SOUGHT NO TREATMENT UNTI 6-12-97. EE WENT TO CHIROPRACTOR TO RIBS PUT BACK IN.

EMPLOYEE WAS AT A CAR WASH, WASHING HIS DUMP TRUCK AND TRAILER.HE WAS STANDING ON THE TRAILERS FENDER,AND THEN JUMPED OFF INTO THE GROUND.HE APPLIED MOST OF THE WEIGHT TO HIS LEFT FOOT, CAUSIN G IT TO SWELL AND BECOME PAINFUL.HIS FOOT WAS A APARENTLY STAINED NOT BROKEN.

EE PULLED A SCREEN OUT AWAY FROM A CONVEYOR FRAME, BUT THE SCREEN PULLED BACK CAUSING EE'S FINGERS TO GET SMASHED BETWEEN THE SCREEN AND CONVEYOR FRAME. WHEN EE REMOVED HIS HAND HIS LEFT MIDDL E AND RING FINGERS WERE DEEPLY CUT, REQUIRING STITCHES.

FREEZING WEATHER CREATED ICE ON A LOADER. EE WAS GREASING THE UPPER ARMS OF THE LOADER FROM THE BUCKET, WHEN HE SLIPPED AND FELL ABOUT 4' TO THE GROUND. HE HIT HIS BACK ON THE BUCKET ON THE WA Y DOWN AS WELL AS HURTING HIS LEFT FOREARM. HE WAS COMPLAINING OF LOWER BACK PAIN AND A SORE LEFT FOREARM.

V-BELTS ON A CONE CRUSHEER STARTED ON FIRE. WHEN THE CONE CRUSHER STOPPED THE MOTOR KEPT GOING, CAUSING A FRICTION FIRE. EE TRIED TO PUT THE FIRE OUT WITH A FIRE EXTINGUISHER, BUT INHALED TH E EXTINGUISHER FUMES.

EE CLAIMS HE FELL AFTER TRIPPING ON DIRT CLODS WHILE WALKING AROUND THE END OF THE SCREENER.