Buscar en el registro

Employee attempted to do a job that required two people. Not doning his work gloves was a contributing factor to this injury. Employee received a laceration to his right pinky finger.

While using exterior water cannon on water truck, employee states that the water truck lurched and went into a ditch. Employee held on to truck and injured his rib after truck came to rest. Injuries reslulted in a fractured rib with no other internal issues.

Mechanic twisted knee stepping down off of a forklift. Initially thought to be a minor sprain. Examination by a doctor indicates possible ligament or meniscus tear. Currently on restricted work duty pending results of further evaluation by doctor.

Contractor employee sustained a laceration to the forehead when struck by a cyclone gate during a severe storm event and related power outage. Gate unexpectedly blew open striking the employee as he was exiting the pond enclosure. Laceration required suturing by a medical professional. All appropriate PPE was being worn.

EE WAS WALKING AROUND BACKHOE TO AVOID BEING SPRAYED BY WATER CANNON TYPE SPRINKLER AND HIT FACE FIRST INTO HOE BUCKET. FRACTURING 4 FRONT TEETH. BACKHOE WAS NOT RUNNING AT THE TIME.

EE WAS REMOVING A DEFECTIVE GREASE AIR PUMP (67LBS.) OUT OF THE LUBE TANK ON THE LUBE TRUCK. HE WAS ON THE 3RD RUNG OF A 6'STEP LADDER IN ORDER TO LIFT THE PUMP OUT. AFTER GETTING THE PUMP OUT , HE SET IT ON TOP OF THE TANK AND STEPPED DOWN TO THE 2ND RUNG. AS HE WAS LIFTING THE PUMP TO THE GROUND, IT SLIPPED FROM HIS GRASP & THE INTAKE END OF THE SHAFT STRUCK HIS HIP,TO THE GROUND

EE WAS ASSISTING A CO-WORKER IN THE INSTALLATION OF A LIME AUGER. EE WAS LIFTING AND PUSHING THE LIME AUGER INTO A TROUGH, WHEN HE HEARD A "POP" IN HIS LEFT ARM AND IMMEDIATELY EXPERIENCED PAI N.

GRINDING THE NEW WEAR STEEL ON THE SIDE OF THE DOZER PUSH ARM (LEFT SIDE ARM). WELDER NOT SURE, BUT HAND GRINDER APPARENTLY SLIPPED FROM HIS GRASP. THE GRINDING WHEEL CUT HIS RIGHT WRIST. SUTU RES REQUIRED TO CLOSE WOUND. EE WAS SITTING AT THE TIME OF THE INCIDENT.

WHILE DRIVING UP TO THE LEACH PAD, PICKUP TRUCK TURNED RIGHT & HIT SOME BUMPS IN THE ROAD. DRIVER BOUNCED AROUND, AND FELT LT DOOR ARM REST HIT HIS SIDE. INITIALLY THERE WAS NO PROBLEM. LOWER BACK BEGAN TO HURT & HE SAW A DR. ON DEC.10TH. INDIVIDUAL HAD STRAINED HIS BACK MUSCLE. HE WAS WEARING HIS SEAT BELT.

WHILE DRIVING DOWN THE LEACH PAD ROAD, THE PICKUP TRUCK HIT A POTHOLE IN THE ROAD CAUSING THE EE'S UPPER AND LOWER JAW TO STRIKE AGAINST EACH OTHER CHIPPING AND CRACKING THE RIGHT INCISOR TOOT H.

OPERATOR WAS TRYING TO PUT AIR CONDITIONER DIRECTIONAL COVER BACK IN PLACE AT THE SAME TIME AS HE WAS OPERATING THE LOADER. THE COVER SLIPPED & HIS LEFT HAND ENTERED THE OPENING. HIS LEFT RING FINGER CAME IN CONTACT WITH THE SQUIRREL CAGE FAN, LACERATING THE FINGERPRINT PORTION OF THE FINGER & ALSO RESULTING IN AN OPEN DISTAL TUFT FRACTURE ON THE END OF THE FINGER.

EE WAS PULLING A GREASE HOSE OFF A REEL TO GET ENOUGH TO REACH A PULLEY. WHEN ANOTHER EE PULLED ON THE LINE TO HELP THE EXTRA SLACK CAUSED THE EE TO STUMBLE. HE WENT FORWARD TO TRY TO REGAIN H IS BALANCE. HE THEN STEPPED ON A ROCK AND FELL TO THE GROUND AND TWISTED HIS RIGHT SIDE. COMPANY WAS NOT AWARE UNTIL 9/19/02.

EMPLOYEE HAD JUST POSITIONED THE TRACK ADJUSTER CYLINDER IN THE SWING FRAME WHEN IT SLIPPED AND SMASHED HIS FINGER BETWEEN THE CYLINDER AND THE TRACK RAIL.

EE HAD LOADED TWO ZINC CANS ONE ON TOP OF THE OTHER ONTO A HANDTRUCK TO MOVE THEM TO THE ZINC FEEDER APPROX. 20 FT AWAY. WHEN HE LEANED THE HANDTRUCK BACK THE CANS STARTED TO FALL FORWARD. HE REACHED OUT AND STOPPED THE CANS FROM FALLING BUT STRAINED HIS BACK IN THE PROCESS.

EE WAS CLIMBING DONW OFF OF THE LUBE TRUCK AND GRABBED THE RAIL WITH HIS LEFT HAND. WHEN HE WENT TO GRAB THE NIPPLE OF THE GREASE TANK WITH HIS RIGHT HAND HE MISSED HIS POINT OF CONTACT AND FE LL BACKWARDS LOSING HIS GRIP AND FALLING APPROX.FT TO THE GROUND LANDING ON HIS RIGHT ARM AND CAUSING A FRACTURE ABOVE THE WRIST.

EE WAS PUSHING THE RIGHT FORK OF THE GRADALL TOWARDS THE CENTER OF THE ATTACHMENT. WHILE HE WAS PUSHING THE FORK IT SWUNG BACK ONTO HIS LEFT HAND CATCHING IT BETWEEN THE FORK AND THE FRAME OF THE ATTACHMENT.

EMPLOYEE WAS BARRING OUT A CHUTE AT THE CV-20 TO RS-03 TRANSFER POINT. A ROCK FELL FROM THE PLUGGED AREA, BOUNCED OFF THE BELT OF RS-03 AND STRUCK THE 4' PRY BAR THE EMPLOYEE WAS USING WHICH C AUSED THE PRY BAR TO HIT THE EMPLOYEES LT. SIDE FACE.

EMPLOYEE WAS ROLLING UP WELDING LEADS ON THE BACK OF A SERVICE TRUCK. AS HE STEPPED ONTO THE BUMPER OF THE TRUCK HIS FOOT SLIPPED AND HE FELL.

EE AND OTHER WERE ASSIGNED TO FABRICATE A SIDLINER FOR FEEDER 1. AFTER CUTTING THE TEMPLATE AND SETTING UP FOR WELDING THEY WERE GIVEN A DIFFERENT WELDING HARD FACE ROD TO USE THAN THEY USED I N THE PAST FOR THIS TYPE JOB. THEY ASKED FOR THEMSDS SHEET FROM CO. CO WAS NOT ABLE TO FIND ONE. CO AKSED THEM NOT TO WELD UNTIL COULD LOCATED THE MSDS. TOHER ACTED AS A SPOTTER AS WELL AS TR

THE EMPLOYEE WAS FABRICATING A LOCKER. SOMETIME DURING THIS A PIECE OF CINDER LODGED IN THE EMPLOYEE'S EYE. AT 3:00 PM THE EMPLOYEE NOTICED THAT HIS EYE WAS RED AND IRRITATED. ON MONDAY HE THO UGHT THAT HE HAD RECEIVED A WELDING BURN AND WAS USING WELDERS EYE DROPS TO RELIEVE THE IRRITATION AND TOLD HIS SUPERVISOR THAT IT FELT A LITTLE BETTER. BY THURS. HIS EYE WAS STILL SORE & RED

WHILE UNLOADING A PNEUMATIC BULK TRAILER WITH A TRUCK TRACTOR, HE FELT DEHYDRATED AND ASKED OTHE EE TO FINISH UNLOADING THE TRAILER WHILE HE SAT INSIDE OF THE TRUCK CAB. OTHER EE COMPLETED THE UNLOAD WITHIN 15 MINUTES. UPON CHECKING ON DRIVER IN CAB, HE FOUND HIM LAYING ON FLOORBOARD UNCONSCIOUS. EMTSWERE SUMMONED FROM MINE, THEY COULD NOT REVIVE HIM.

EE WAS REMOVING A BELT CLAMP FROM THE BACK OF A P/U BED. THE EE FELT A SHARP PAIN IN HIS SHOULDER WHEN HE LIFTED THE CLAMP AND DROPPED IT. THE EE REPORTED THIS TO HIS SUPERVISOR AND SAID HE TH OUGHT HE WOULD BE OKAY. THE NEXT DAY THE PAIN PERSISTED AND HE WAS TAKEN TO THE DOCTOR. ON MARCH 9 THE EMPLOYEE AGAIN WENT TO THE DOCTOR AND WAS GIVEN A CORTIZONE INJECTION.

EMPLOYEE WAS TRIMMING AWAY THE TELLOWMINE PIPE WALL TO EXPOSE A BROKEN SPLINE FOR REMOVAL. EMPLOYEE HAD JUST CHANGED THE BLADE IN HIS RAZOR KNIFE. DURING THE TRIMMING OF THE WALL THE BLADE SLIPPED OFF THE PIPE AND LACERATED THE FINGER.

EE WAS TIGHTENING A PIECE OF UNISTRUT CONDUIT FIXTURE DOWN WHEN THE COUPLING STRIPPED THROUGHT THE THREADS & THE UNISTRUT FELL KNOCKING HIM BACKFROM THE LADDER. HE GRABBED FOR ANOTHER PIECE OF CONDUIT THAT HAD A ROUGH EDGE WHICH CAUSED THE INJURY.

EE WAS REMOVING THE DUST HOOD FOR SC-01. THE HOOD BOUND UP AND WHILE THE EE WAS PUSHING ON IT THE HOOD CAME LOOSE. THE EE FELL THROUGH THE CHUTE AND STRUCK HIS SHIN CAUSING THE LACERATION.

TWO EMPLOYEE'S WERE REMOVING THE BAFFLE PLATE TO POSITION IT DIFFERENTLY. AS THEY WERE CUTTING THE PLATE LOOSE EE PULLED ON IT AND THE PLATE CAME LOOSE. A STIFFNER BRACE ATTACHED TO THE PLATE STRUCK EE'S ARM AND CAUSED THE INJURY.

EE WAS PLACING A 65 LB DOR BAR IN THE SAFE AND THE BAR STARTED TO TURN OVER. WHEN THE EE TRIED TO CATCH THE BAR HIS FINGER WAS PINCHED BETWEEN A SHELF IN THE SAFE AND THE DORE BAR CAUSING THE INJURY.

EMPLOYEE WAS USING A RAZOR KNIFE TO CUT 80 MIL. LINER. AS THE EMPLOYEE WAS CUTTING AWAY FROM HIMSELF THE KNIFE SLIPPED AND HE FELL FORWARD ONTO A CORNER OF THE FRESHLY CUT LINER. THE LINER P UNCTURED HIS LEFT WRIST CREATING A LACERATION (SMALL).

EE HAD STOPPED AT TR-06 TO FUEL AND LUBE. WHEN HE CHECKED THE RADIATOR FLUID LEVEL HE MOVED THE CAP TO THE FIRST CLICK AND NOTHING HAPPENED. WHEN HE MOVED THE CAP TO THE SECOND CLICK THE CAP B LEW OFF AND SPRAYED ANTI-FREEZE ON HIS RIGHT HAND CAUSING A SECOND DEGREE BURN.

EE WAS PARKED, WAITING TO BACK UP AND GET LOADED. HIS HAUL TRUCK WAS FACING THE HIGHWALL APPROX. 30 FT. FROM IT. A LARGE ROCK APPROX. 5 SQUARE FT. ROLLED DOWN THE HIGHWALL 180 FT. AND STRUCK T HE FRONT GRILL OF THE HAUL TRUCK. THE FORCE LIFTED THE REAR WHEELS 3 FT. OFF THE GROUND CAUSING THE EE TO STRIKE HIS FACE AGAINST THE STEERING WHEEL.