Buscar en el registro

Employee climbed into bed of semi with a shovel to break loose carbon that was stuck to the bottom of the bed, while using the shovel employee slipped and fell on right shoulder. Employee was taken to Express Care for evaluation, after x-rays it was determined no bones were broken. They recommend seeing an orthopedic doctor.

Mechanic was assisting the welder in picking up a plate of metal (4'x10'x1/2"). Two plates were stacked on top of each other on the ground. Employee tried to lift top plate so the forks of the bobcat could slide under top plate. When ee attempted to lift this plate, ee heard a popping sound from the lower right side of back. Employee collapsed onto the ground in pain.

while torching/cutting feeder chain during demolition at Crown II mine prep plant, chain struck worker on the hardhat causing slight laceration.

Struck on right leg with rock.

Employee burnt forearm while using torch.

EE walked around timber trip that was stuck and struck a roof bolt with her hard hat. She had a neck stain at the time and continued to work until 10/9/08, when she had surgery.

Employee was cutting bands on bundle of roof bolts, slipped and twisted foot causing strain.

A roof fall occurred in the South Sub Mains at 9Xcut in entery #7. The fall measured 25' long, 25' wide and 9' high. The fall did not affect ventilation, travel or cause injury. It will not be cleaned up.

Broken wire in trailing cable for hoist controls.

Rock fell from brow and struck employee, fracturing his pelvis, left femur and 2 left ribs.

EE was hit by rock on his lower back.

EE slipped and twisted left knee. EE continued to work until today 4/29/08, he will undergo surgery.

Employee was struck on left hand with a piece of steel, fracturing thumb.

A roof fall occurred in the south submain of 35 xcut in entry #11. The fall measured 20' long, 20' wide & 8' thick. The fall did not affect ventilation, travel or cause injury. It will not be cleaned up. No one is required to work or travel in this entry.

Employee smashed right thumb.

A roof fall occured in the 2nd south Sub Main at x cut 50 in entry #4. The fall did not affect travel, ventilation or cause injury. The fall measured 20' long, 18' wide and 9' high. It will not be cleaned up. No one is required to work or travel in the entry.

A roof fall occurred in unit 1 (1st west panel) in the rooms. It is located in return room 2 in the last open xcut. It measures 20 ft wide, 30 ft long & 7 ft thick. This fall did not affect ventilation, travel or cause injury. It will not be cleaned up. No one is required to work or travel in this entry.

A roof fall occurred in the return of the 3rd West panel. The fall is located in entry 8. It measures 20 ft long, 2 ft wide & 8 ft tall. It is at 11 x-cut. This fall did not affect ventilation, travel, or cause injury. It will not be cleaned up. No one is required to work or travel in this entry.

A roof fall occured in the return of the 2nd South submain entries. The fall measured 20 ft long, 25 foot wide and 8 foot high. It is located in #8 entry at 16 X Cut. This fall did not affect ventilation, travel or cause injury.

Employee sprained left ankle when he fell over metal laying on ground.

Employee cut finger on piece of metal requiring 5 stitches.

A roof fall occurred on the travelway of the 1st west panel, entry #6 at 41 x-cut. The fall did not affect ventilation, travel or cause injury. The fall was 25 ft long, 18 ft wide, & 10 ft high.

Employee was hit by top.

A roof fall occurred in the 6th east, #42 crosscut, #11 entry. The fall was 18' long, 18' wide & 8' high. The area was bolted with 8' tension rebar bolts. The fall didn't affect ventilation, travel, damage equipment or cause any injury. No one was required to work or travel in this entry.

A roof fall occurred in the 1st West unit in entry #5 at footage station 3710. The fall did not affect ventilation, travel, or cause injury. The fall was 20 ft long, 20 ft wide & 8 ft high. The fall occurred on the section breaker feeder.

EE was standing in last open X-cut in unit. A piece of rock fell from between the bolts, striking him on back of head and neck.

A roof fall occurred in the 6 ep, #74 crosscut, #10 entry. The fall was 18' wide, 18' long & 9 high. The area was bolted with 8' point anchor bolts. The fall didn't affect ventilation, block travel, damage equipment, or cause any injury.

A roof fall occurred in 3ssm, #4 & #5 entries at 21 crosscut, the fall was 80' wide & 12' high. The area was bolted with 6' to 8' point anchor bolts. The fall didn't affected ventilation, traveling damage equipment or cause ant injury.

a fall occurred in the 2nd south room 35 crosscut 1 the fall was 20' wide, 20 ' long, and 8' high. The fall didnt affect ventilation, travel, damage, equipment, or cause any injury. the area was bolted with 6' to 8' point anchor bolts. this was in worked out rooms, no one is required to work or travel in the area.

A roof fall occurred in the SSM intake aircourse in entry #8, xcut 38. The fall measured 20' wide, 20' long & 8' high. It did not effect travel, ventilation or cause injury. No one is required to work or travel in this area.

A roof fall occurred on the 3rd west belt 3 xcuts outby room #1. The fall was 35' long, 35' wide & 10' tall. It did not effect ventilation, cause injury or block travel.

Employee was bolting at the face. He moved to the rear of the bolter when a piece of shale fell directly in front of him striking him on the upper right foot.

A roof fall occurred in the 3NSM, #5 entry, #12 crosscut. The fall was 20' long, 30' wide, and 10' high. The fall didn't affect ventilation, travel, damage equipment, or cause injury. The area was bolted with 8' & 10' point anchor bolts.

Employee was moving roof plates around on roof bolter when one slid down cutting his right lower arm. He received 3 stitches.

A roof fall occured on the 2nd South belt at x-cut 19, entry # 5. The fall was 30' long, 25 ' wide and 8' high. It did not affect ventilation, cause injury or block travelway.

A roof fall occurred in the 2nd West Return in entry #1 at xcut 20. The fall was 20' long, 20' wide & 8' high. The fall did not affect ventilation, block travel or cause injury. No one is required to travel or work in this area.

A roof fall occurred in the 6th East Panel, #6 entry, #89 crosscut. The fall was 20' long, 40' wide, 9' high. The fall didn't affect travel, ventilation or cause injury. It did damage belt structure. No one is required to work or travel in this entry.

A roof fall occurred in the 3rd west at 1710' station, #3 entry. The fall was 30' long, 18' wide and 8.5' high. The area was bolted with 8' point anchor bolts. The fall didn't affect ventilation, cause injury, damage equipment or block travel. No one is required to work or travel in this entry.

A roof fall occurred in the 6th East, #6 Entry, at 83 Crosscut. The fall was 20' long, 20' wide, and 9' high. The area was bolted with 8' point anchor bolts. The fall didn't affect ventilation, cause injury, or block travel. It did damage some beltline. No one is required to work or travel in this entry.

A roof fall occurred in the 2nd West, entry #9, xcut 35. The fall was 20' long, 20' wide & 8' high. The area was bolted with 6 & 8' point anchor bolts. The fall did not affect ventilation, block travelway or cause injury. No one is required to travel or work in this area.

Notification by MSHA of possibility of pneumoconiosis.

A roof fall occurred in the 2nd South submain entry #3 at 2170 footage station. The fall was 20 ft long, 20 ft wide, & 8 ft tall. The area was bolted with 6' & 8' point anchor bolts. The fall did not affect ventilation, block travelway or cause injury. No one is required to travel or work in this entry.

Unintentional roof fall 6EP Panel #8 Entry footage 5,200 Feet. 20 ft long x 20 ft wide x 8 ft high. 4 Way Intersection. Bolted with 8 ft TR Bolts. Approx date of developement 7/17/07. This is a non-working section, affected no equipment or caused injury. Escapeway was not affected.

A roof fall occurred in the Main North belt entry between #13 & #14 crosscuts. The fall was 30' long, 18' wide, & 8' high. The area was bolted with 8' point anchor bolts. The fall didn't affect ventilation, cause injury or block travel. It did damage some belt line. No one is required to work or travel in this entry.

A fall occured in the 1st West panel, #5 entry, 18 crosscut. The fall was 20 foot long, 20 foot wide and 8 foot high. The area was bolted with 6' & 8' point anchor bolts. The fall did not affect ventilation, block travelway, cause injury. 48" conventional belt structure was covered.

Employee was struck on the back with a piece of slate.

A fall occurred in the 2nd south, #2 entry, 2800 ft station. The fall was 20' long, 20' wide & 8' high. The area was bolted with 6' & 8' pt anchor bolts. The fall did not affect ventilation, cause injury, block travel or damage equipment. No one is required to travel or work in this entry.