Buscar en el registro

A Diagnostic Mechanic was working on a pump to connect two flanges together. As the mechanic engaged the impact wrench, the bolt shifted and the spud wrench unexpectedly moved, striking the employee in the lip. Event went reportable on 09/17/2026.

Nuts were stuck on tramp cylinder tried multiple ways to loosen them was advised not to cut the nuts off and was directed to use a 1" impact which resulted in the stem unscrewing from the cylinder causing a nitro discharge from accumulator shooting stem and impact into employees chest and face

Employee beginning to experience symptoms consistent with heat stress while performing work activities. Event became reportable on 9/11/2026.

Haul truck operator claimed they were rough loaded and felt pain in their back. Injury went reportable on 09/06/2026.

Operator trainee injured their right hand when assisting in idler maintenance. The event went reportable on 09/06/2026.

Dropped rod bearing striking and chipping tooth.

Employee was walking across the work area and stepped on uneven terrain. This caused their left knee to pop and employee then felt pain in their left knee. Event went reportable on 09/03/2026.

Operator was being loaded and reported a rough load which caused back pain. The event went reportable on 09/01/2026.

A mechanic's left index finger became pinched between sling and regrind ball mill when performing routine maintenance. Event went reportable on 08/25/2026.

A mechanic was in the process of reinstalling the screen motor and rigging the motor into position. As the crew was repositioning the motor to complete the alignment, the motor unexpectedly shifted, causing the back side of the motor to rise. At that time, the mechanic's finger was pinched. The event went reportable on 08/24/2026.

The haul truck operator was exiting and stepped onto the truck's walkway when their right knee hit a metal panel. This contact caused a cut on the right knee. The event went reportable on 08/22/2026.

A ground laborer tried to get more leverage on a cable and put the hot stick behind them in order to pull better when they felt pain in their right calf. Event went reportable on 08/21/2026.

Haul truck operator experienced a pain in the lower back while placing a lock on a security gate of HT. Event went reportable on 08/19/2026.

The tip of the employee's boot caught the edge of a stair, causing the employee to fall forward. The employee's right knee struck the stair, resulting in a cut requiring stitches

Operator was doing a walk around on their haul truck and got dust/debris in their eye. Employee lost time on 08/14/2026.

Shovel mechanic was working on the drill mast and when stepping down they rolled their right ankle. The employee was placed on restrictions on 08/09/2026.

A mechanic was using crosswalk and fell to the ground landing on their left knee and elbow. They employee did not go on restrictions or lost time but did start physical therapy 08/24/2026.

Employee got redness and a rash when working their rotation. Event went reportable on 08/07/2026

HDTS mechanic claims to have received a right shoulder strain after repeatedly using an impact gun during the course of their assigned tasks. The event went reportable on 08/06/2026. The employee was placed on restricted duty on 08/12/2026

Haul truck operator reached to grab a bottle of water. At this time the shovel released the second dipper into the truck causing a rough loading event and experience multiple muscle strains. The event went restricted duty on 08/13/2026.

A mechanic reportedly got something in their eye when washing a Haul Truck. The mechanic stated they did not feel any discomfort until they got home. After some time, the eye discomfort became pain, and the employee sought medical attention. The event went reportable 08/01/2026.

Operator of a water truck started to pull themself up the ladder when they lost grip and fell backward. Event went reportable 07/30/2026.

The CMV Driver was walking towards the semi-trailer when their right toe caught something on the ground causing them to trip and they landed on their right side with their arm caught underneath them. They impacted their right wrist and shoulder, their arm made contact with their right upper ribs when they hit the ground.

Mechanic performing routine maintenance on a haul truck changing out the park brake valve. While using their wrench, employee slipped on ladder and caught themselves with their left hand by grabbing onto a hose on the truck. This resulted in the employee feeling a sharp pain in their left shoulder. The employee was given restrictions starting 08/03/2026.

Employee was moving boxes with shirts in them and as they were lifting a box, they felt a pop. Event went reportable on 07/29/2026.

Employee started shoveling and realized their back was in pain in the beginning of their shift. Event went reportable 07/30/2026.

Was putting discharge cap back on trailer after offloading trailer. When EE pushed the cap with EE's right thumb, EE applied extra pressure and it bent EE's thumb back which resulted in a sprain.

While pulling forward with the bed raised to plug out, the front wheels lifted off the ground. When the front end came back down, the operator began to feel pain in their back. Went reportable 07/26/2026.

Employee was walking and fell resulting in hurt right ankle and scraped their left elbow/arm. Injury went reportable 07/23/2026.

Employee lost their balance and instinctively placed their hand on a job box to stabilize themselves. The movement caused the job box lid to close, striking the back of their right hand. Went reportable on 07/23/2026.

Employee was performing routine work and bent over to connect strongback. As employee stood up, they felt a sharp pain in their lower back. Event went reportable 07/22/2026.

Hydromet Maintenance employee attempted to adjust a belt mop tray While repositioning the tray, the tray edge causing a laceration to the right index finger. Injury went reportable on 7/16/2026.

Employee descended a crane ladder and missed their grip causing them to fall onto their back. Event went reportable 7/8/2026.

Employee attempted to close the door of a wet scrubber after inspection; However, door slammed shut, catching the employee's left ring finger above the fingernail and resulting in an injury to the fingertip. Event went reportable 07/06/2026

Was attempting to remove a pneumatic hose to reposition it. The fitting was slightly bent and difficult to remove. EE applied extra force and the hose disconnected and struck EE in the chin. As a result EE received 3 stitches on the chin and was released to regular duty

Rear-end collision involving two haul trucks on a haul road.

Haul Truck operator was prepping truck prior to operation and bent their thumb backwards, hyperextending it, when adjusting their dispatch screen. Employee was immobilizing brace.

Employee was laying a 4-inch pipe; when moving the pipe employees' pants leg was caught on a piece of PVC pipe, cause the employee to trip and fall forward landing on their forearms. Felt pain in their back a short time later. Employee was seen at clinic.

Lube operator was doing their 2nd round of lube and did not feel good due to heat. Event went reportable on 6/24/2026.

A Mechanic injured right bicep during unplanned repair. They felt/heard a "pop" while lifting and aligning fender with pry bar. Continued work briefly; pain worsened. The injury went reportable on 6/24/2026.

Employee was working on a haul truck. When they completed working on the inside of the haul truck the employee stepped down and rolled their left ankle. The injury went reportable on 6/23/2026.

Employee stepped on uneven ground, resulting in a trip and forward stumble. The employee landed on their right knee. Injury went reportable on 6/20/2026.

Maintenance employee performing routine rounds in the Morenci canyon crushing plant. The employee began to feel lightheaded and was attempting to sit down when suddenly they lost awareness. The employee quickly recovered and got back up.

The Rubber Tire Dozer operator pulled off the haul road to allow traffic to pass. During this time, the equipment encountered a pothole, resulting in the operator experiencing pain in the lower back and left shoulder. The operator went on restrictions on 6/17/2026.

Employee started to dismount a Trackhoe and stepped on a rock, hurting their left ankle. Employee was put on restrictions 6/14/2026 and returned to work, able to work at full capacity on 6/15/2026.

A sampler tech employee was walking to throw away a wooden pallet into the bin by the Sampler Shed when they stepped onto some soft ground causing their right ankle to roll. Employee went on restrictions on 6/9/2026.

Employee was carrying a bag of trash and tripped over a drain pipe on the ground, causing EE to fall, resulting in a hairline fracture of the 5th metacarpal of left hand

During normal loading operations, the Shovel was swinging back into the bed of Haul Truck with the second dipper when the dipper dropped into the bed. The dipper landed half on, half off of the dovetail causing the bed to rise. The front of the truck rose into the dropping back to the ground. Employee went on restrictions on 06/03/2026.

A Met Mill Tech was moving some sample buckets when they experience pain in their lower back. They claim to have bent over and picked up a sample tray/bucket and twisted and felt a knife sensation in their lower back. The employee went on restrictions on 05/28/2026.

A Mill Diagnostic mechanic was guiding a coupling guard into position using crane assistance. The mechanic attempted to lift the bottom edge of the guard to maneuver it over the adjustment bolt. The guard was set back down, the mechanic's left hand was still positioned underneath, resulting in the left index finger being caught and pinched between the adjustment bolt and the guard.