Buscar en el registro

Left index finger was swollen, but did not know how/when, or where. Or it could have been a spider bite. Finger gotten worse later that same morning. Taken to the hospital. They then numbed his finger and cleaned it. They gave him antibiotic. Has to go in every 6 hours to have his finger cleaned out.

Employee was changing out extruder grid when he inadvertenty moved a protective cover over a section of catwalk that was under construction. Employee had been aware and warned of the covering over the catwalk. Employee lost his balance causing him to fall.

Walking around K-3 Kiln gust of wind blew dust and metal particals in face and eyes. a foreign piece of metal went into left eye.

Employee felt hot, went to get more water and felt faint. Safety Coordinator at the facility called paramedics as a precatuionary. Employee was taken to Hospital and later that evening was released.

Employee was in manbasket attempting to weld wear ring on rear of kiln when a gust of wind took it out of his grip and pinched right thumb between new wear ring and rear of hood.

The employee cut his left wrist with a razor knife as he was cutting on a 3" water hose.

Employee was walking by a screen when a piece of material flew into his left eye.

EE tripped on steps, struck left knee on vertical part of hand rail. Fell, got back up, with bruised and scratched left knee.

Employee was filling a rental compressor with diesel. As he lifted the can to pour he lost his footing & fell, hurting his back.

Employee and other ee were attempting to restart a conveyor. as He was cleaning the inside of the convoyer with his arm, Other EE turned on the conveyor.

Truck driver fell off from the back step approximately 3 ft. while tarping trailer and broke his right leg.

While tightening the nose cone bolt with his foot and holding the wrench with his left hand and keeping the bolt from turning with his left foot, the bolt turned catching his left index finger between the end of the wrench and nose cone. This smashed his left index finger.

HE WAS PUTTING A NEW 14" THURST ROLLER ON K-Y COOLER WHEN IT SLIPPED AND PINCHED HIS RIGHT RING FINGER.

Hot dust putting out of rotary kiln #3 flew into eyes as i was walking by. Prescription issued 1-26-05.

EMPLOYEE WAS DUMPING HOT ROCK ONTO PILE WHEN WIND BLEW HOT AMBERS ONTO HIS ARMS, LOWER BACK AND NECK. EMPLOYEE LIFTED BUCKET OF BOBCAT ABOVE CAGE TO DUMP.

EE WAS DESCENDING STEPS WHEN HE FELT SHARP PAIN IN JAW. EE HAD AN INFECTION IN HIS JAW. EE PULLED HANDS OFF OF HANDRAILS TO GRAB AT HIS FACE. EE LOST HIS BALANCE & FELL & BROKE RIGHT LEG BETWEEN KNEE & ANKLE.

DURING DRIVEBELT REPLACEMENT, DRAWING V-BELTS THROUGH A SIX-GROOVE SHEAVE ATTEMPTING TO ROLL THE V-BELT INTO PLACE, HE PINCHED HIS LEFT INDEX & LITTLE FINGER BETWEEN SHEAVE & DRIVEBELT. MEDICATION: CEPHALEXIN FOR INFECTION, PROPOXYPH FOR PAIN, NAPROXEN FOR INFLAMMATION.

WAS CLIMBING OFF 966F LOADER GOT OFF THE LOADER TURNED TO WALK AWAY FROM THE LOADER AND FELT SOMETHING TWIST IN HIS BACK.

WAS WALKING BY WATER TANK FELL IN HOLE THAT WAS MADE BY OVERFLOWINNING WATER. STRAIN TO GROIN.

HIS EXTRUDER WET PLUGGED WENT TO DIG OUT LIFTED GAURD HELD IT UP ON HIS SHOULDER WHILE SHOVELING INTHE EXTRUDOR THE SHOVEL STUCK IN MUD GUARD FELL OFF HIS SHOULDER CAUSING A CONTUSION TO HIS L EFT MIDDLE FINGER.

DOING HIS NORMAL DAILY ROUTINE OF RUNNING THE RAW PLANT HE STRAINED HIS LOWER BACK. REPORTABLE BECAUSE OF THE PRESCRIPTION PILLS. MOTRIN, FLEXERIL, VICODIN.

WAS WALKING DOWN ACCESS RAMP SLIPPED ON LOOSE MATERIAL THAT HAD SPILLED ON RAMP AREA AND FELL, LANDED ON HIP, STRAIN TO BACK, KNEE, SHOULDER.

WAS CHECKING OUT HIS COOLER AREA SLIPPED ON SOME WET MATERIAL AND SPRAINED RIGHT KNEE. THIS WAS NOT RECORDABLE AND NOW THEY WANT TO SEND HIM TO THERAPY AND AN MRI

WAS PLACING SQUARE TUBING PIECE OF STEEL ON GROUND END SLID DOWN ACROSS FINGERS CUTTING FINGERS.

PUMICE DUST BLOWN BEHIND SAFETY GLASSES AND INTOLEFT EYE. EYE IRRITATED AND SCRATCHED.

EMPLOYEE WAS USING A 2 LB SLEDGE HAMMER AND A BOLT TRYING TO REMOVE ANOTHER BOLT OUT OF THE HAMMER MILL ROTOR. HE SWUNG THE HAMMER AND HIT HIS LEFT THUMB CAUSING MEDIAL AND LATERAL LACERATIONS AND CRUSHING THE TIP OF HIS LEFT THUMB.

EE WAS FIXING A WATER LINE IN A TRENCH, EE WAS FINISHING UP THE JOB. WHEN HE STARTED WALKING BACKWARDS, HE TRIPED & FELL STRICKING HIS LEFT ELBOW ON THE GROUND.

PULLING OIL BARREL TO LEVEL IT OUT MARCH 2000. SHOVELING MATERIAL OUT OF SURGE TUNNEL PULLING GROIN AREA.

EMPLOYEE WAS ADJUSTING BELT SKIRTING. HE PLACED A 5# HAMMER ON THE BELT FRAME AND IT FELL OFF AND HIT HIS FOOT ABOVE STEEL TOE.

EE STATED THAT HE WAS REPLACING A GUARD AFTER CLEANING AND TRACKING A CONVEYOR BELT. HE STATED THAT WHILE REPLACING THE GUARD HE FELL INTO THE TAIL PULLEY, CAUGHT HIS LEFT HAND IN THE TAIL PUL LEY AND FREED HIMSELF WITH A PRY BAR THAT WAS LAYING CLOSE BY.

EE FELL THROUGH A PIECE OF PARTICLE BOARD BEING USED FOR FLOORING AT HIS WORK STATION.

EE WAS SHOVELING OUT A BURIED CONVEYOR. COMPLAINED OF PAIN AND NUMBNESS IN RIGHT ELBOW SEVERAL DAYS LATER.

SWINGING A HAMMER TRYING TO TAKE A KNIFE OFF THE EXTRUDER SHAFT.

WHILE CLEANING THE STEDMAN CRUSHER. EE ATTEMPTED TO TURN THE CAGES TO CLEAR BUILT UP MATERIAL. AS THE CAGE ROTATED HIS HAND WAS PINCHED BETWEEN THE CAGE AND PACKED MATERIAL.

WAS KNEELING ON CATWALK TIGHTENING THRUST ROLLERS ON KILN. MADE HIS SORE AND SWOLLEN.

EE WAS COMING DOWN WALKWAY FROM PELLET SILOS AND SLIPPED AND FELL INJURING HIS LOWER BACK.

EE WAS INSTALLING A TAIL PULLEY AND STRAINED HIS BACK. NO ONE TO HELP HIM REMOVE THE OLD TAIL PULLEY.

EMPLOYEE WAS PUSHING MATERIAL INTO THE SURGE PILE WITH A FRONT-END LOADER. A LARGE KLINKER WAS IN THE PILE OF MATERIAL. EMPLOYEE CLIBED OFF THE LOADER TO REMOVE IT AND WHEN HE BENT OVER HIS HA RD HAT FELL OFF. WHEN HE RAISED UP TO PUT HIS HAT ON, HE HIT HIS HEAD ON A SUPPORT BEAM.

WAS GETTING OFF LOADER SLIPPED AND FELL WAS HOLDING ONTO HAND RAIL.

EE WAS STANDING ON TOP OF THE LOADER'S BACK TIRE ATTEMPTING TPO HEAT UP A GREASE GUN BY PUTTING IT AGAINST THE EXHAUST PIPE. THE TIRE HAD MUD ON IT, HE LOST HIS FOOTING, SLIPPED AND FELL ON HI S BACK--ON THE TIRE--THEN FELL TO THE GROUND. THIS IS CLAIMANT'S DESCRIPTION OF ACCIDENT--NO WITNESS.

EMPLOYEE WAS CLEANING CHUTE WITH A BAR. BAR SLIPPED AND HIT HIS HAND ON THE CORNER OF THE CHUTE.

EE WAS CLEANING COMPACTED MATERIAL FROM A SILO WITH A PRY BAR. MATERIAL DISLODGED AND FELL, PUSHING THE PRY BAR INTO THE EE'S CHEST.

EE WAS CLEANING A CHUTE. HEAVY STEEL DOOR MUST BE REMOVED TO CLEAN. WHILE REINSTALLING THE DOOR, SHE LOST HER BALANCE AND FELL FORWARD, CRUSHING HER FINGER WITH THE DOOR.

EMPLOYEE WAS USING A BAR TO UNPLUG A CHUTE, WHEN HE JAMMED HIS THUMB INTO THE CHUTE.

PUTTING COMPUTER BACK TOGETHER WHILE PUTTING IN THE SCREWS THE SCREWDRIVER SLIPPED PONCTOSE LEFT HAND.

EE WAS CLEANING COMPACTED MATERIAL FROM THE VACUUM CHAMBER OF THE EXTRUDER. HE WAS USING A PRY BAR AND A SHOVEL.

MOVING A STEEL BEAM WITH A FORKLIFT IT WAS SHAKEN A LITTLE BIT SO HE PUT IT BACK ON THE GROUND TO REPOSITION IT HE PICKED IT UP WITH HIS HANDS TO MOVE IT AND DROPPED IT ON HIS FOOT.

EE WAS WORKING IN THE QUARRY DIRECTING A TRAINEE ON THE SCRAPER. HE PICKED UP A BRANCH STICK TO USE TO DIRECT THE OPERATOR. LATER IN THE DAY HE DEVELOPED SWELLING AROUND THE FACE AND ITCHING. IT APPEARS HE WAS EXPOSED TO POISON OAK OR SOME POISONOUS PLANT OR SUBSTANCE.

EE WAS WORKING INSIDE THE KILN ASSISTING IN POURING CASTABLE AT THE 1 TIRE LOCATION. THE LIFHT WENT OUT AND EE STUMBLED IN THE DARK.

EE WAS INSPECTING BAGHOUSE AREA AND SLIPPED AND TWISTED HIS RIGHT KNEE.