Avísenme cuando se presente un nuevo incidente de la MSHA en Gilbertville Sand.
| Trimestre | Horas trabajadas | Citaciones | S&S | Por 1M hrs |
|---|---|---|---|---|
| 2025 Q4 | 3,812 | 3 | 0 | 787.0 |
| 2025 Q3 | 3,224 | 0 | 0 | 0.0 |
| 2025 Q2 | 3,455 | 0 | 0 | 0.0 |
| 2025 Q1 | 2,609 | 0 | 0 | 0.0 |
| 2024 Q4 | 4,932 | 0 | 0 | 0.0 |
| 2024 Q3 | 3,922 | 0 | 0 | 0.0 |
| 2024 Q2 | 4,194 | 0 | 0 | 0.0 |
| 2024 Q1 | 3,663 | 0 | 0 | 0.0 |
Employee was exiting loader using proper 3-points of contact. Employee's foot slipped off last step of loader putting sudden stress on left arm and straining left shoulder.
Audiologist report of 4/4/2023 on annual hearing test indicated a reportable hearing loss of 32.33 dB in the Left Ear. Employee is currently enrolled in BMC Aggregates Hearing Conservation Program and will be retrained on hearing conservation program and proper use of hearing protection.
Employee was working on dredge. While walking on land near dredge, employee tripped over cable used to anchor dredge. Employee fell, landing on left knee causing injury to knee.
Employee was using utility knife to cut rubber hose in order to install new fitting on end of hose. In process of cutting hose, utility knife slipped, causing laceration/puncture wound approximately 1" long on the inside of right thigh about 2"-4" above knee. Wound required 5 stitches.
Employee was working on sand plant screen box. While performing maintenance employee fell through maintenance door used to access lower portion of screen box. During fall employee struck elbow on edge of opening and jammed shoulder.
Stand pipe fell and hit employees shoulder.
Employee was working on a 5th wheel plate off of a non-mining piece of equipment (Over the road truck DOT). He was on his knees and turned to his left and pulled left back muscle.
Changing oil on final drive of backhoe. Noticed drain pan was getting full, stood up to get another drain pan. Walked around corner of backhoe and ran into open service on the backhoe. The result was a laceration to the bridge of nose that required stitches.
Was grinding on a piece of metal and grinder kicked back and cut his left hand.
Was kneeling on knees pulling old belt out of bottom of leg #2 while the new belt was being pulled in above me. There was a piece of plywood that the new belt was laying on. When they pulled the new belt, the plywood slipped off of the beam it was resting on and hit him in the back of the head on his hard hat and snapped his head ahead.
Repeated lifting of 50lbs sand bags at bagging operation.
A crane was holding a dredge impeller in an upright position with a nylon strap tied around the impeller. The crane operator put slack in the cable. The victim had his hand between the strap and the impeller. When the slack was taken up, his hand was pinched and pulled his finger out from between the strap and impeller.
Chipping or grinding a weld and got piece of metal in left eye.