Avísenme cuando se presente un nuevo incidente de la MSHA en No 1.
WAS CRAWLING FROM TRACK TO #4 AND #5 BELT HEAD, SHARP PAIN IN KNEE.
LIFTING LID ON FEEDER WITH SLATE BAR AND SLATE BAR SLIPPED. LID FELL AND MASHED FINGER.
CHECKING BELT HEAD, RUBBED UP AGAINST LOW HANGING ROOF BOLT PLATE, CUTTING EAR.
REPAIRING CONTINUOUS MIENR METAL SHAVING FLEW FORM CHISEL STRIKING EE IN THE NECK.
INJURED WAS REMOVING COAL SPILLAGE FROM ALONGSIDE, NO. 1 BELT CONVEYOR & CAUGHT LEFT FOOT IN A CONVEYOR RETURN ROLLER.
INJURED WAS LIFTING A COUPLING, PRIOR TO EMPLACING SAME INTO THE DRAW-HEAD OF A SUPPLY CAR, WHEN HE EXPERIENCED A LOWER BACK PAIN.
INJURED WAS INVOLVED IS ASSITING IN A BELT EXTENTION AND REPORTED HE FELT PAIN IN HIS LOWER ABDOMEN WHILE LIFTING TO PLACE TOP IDLER STRUCTURE ON CONVEYOR SIDEFRAME.
INJURED WA SCLOSING SWITCH A 480 VAC 200 AMP SWITHC BOX, SUPPLY POWER TO 100 HP FAN MOTOR CIRCUIT, WHEN A SHORT CUIRCUIT OCCURED IN SWITCH BOX, EJECTIN GMETAL FROM THE ENCLOSURE, CAUSING A LAC ERATION TO THE UNDERSIDE OF THE CHIN.
INJURED WAS SPRAYING PERMANENT STOPPINGS PER 75.333 WITH A SODIUM SILICATE PRODUCT. THE SPRAY MACHINE CLOGGED AND THE INJURED WAS PERFORMING REMEDIAL CHECKS AND ACTIVATED THE MACHINE, CAUSING PRODUCT TO BE EXPELLED FROM THE MACHINES HOPPER INTO BOTH OF HIS EYES. INJURED WAS NOT WEARING SAFETY GLASSES.
INJURED WAS ATTEMPTING TO BOARD THE TRACK MOUNTED PERSONNEL CARRIER & BUMPED HIS LEFT KNEE ON THE BUMPER OF THE VEHICLE INJURY DID NOT BECOME MANIFEST UNTIL END OF FOLLOWING SHIFT ON 03 MARCH 94
FALL OCCURRED IN NO. 6 ENTRY VIC SP 2865, APPROX 110'X18'X6'. ROOF MATERIAL WAS THINLY BEDDED SHALE STRATA AND APPEARED WET. COLLAPSED AREA ISADJACENT TO 100' COVER LINE. ENTRY WAS INITIALL Y REINFORCED WITH 36" MECHANICALLY ANCHORED BOLTS AND SUPPLEMENTALLY SUPPORTED WITH CRIBS PRIOR TO FAILURE.
INJURED WAS HOLDING 60# RAIL IN PLACAE WITH HIS RIGHT HAND, ON THE DRIFT END OF THE SUPPLY CAR, ATTEMPTING TO START A SECOND ROW OF RAILS. THE FOUR MAN SUPPLY CREW PICKED UP THE HIGHWAY END OF THE RAIL & PLACE ON SUPPLY CAR. RAIL ROTATED & CAUGHT THE TIP OF INJUREDS MIDDLE FINGER OF RIGHT HAND.
HE WAS PICKING UP AND CARRYING BELT STRUCTURE WHEN A PAIN STARTED IN HIS LOWER BACK.
HE WAS GATHERING BELT STRUCTURE WHEN A BOTTOM STAND FELL AND HIT HIM IN THE LOWER PART OF HIS LEG PUNCTURE WOUND.
WEN T TO ANSWER PHONE AT #5 HEAD DRIVE & STEP ON ANKER PIN & TWISTED KNEE
WATER SATURATED TOP AND WEAK ROOF AREA.
IN PROCESS OF TAKING CAT HEAD OUT OF SERVICE AND BREAKER APPARENTLY WAS NOT OUT DUE TO POSSIBLE FAULTY MINER BREAKER.
DUE TO WET CONDITIONS OF MINE ROOF A PIECE OF ROCK FELL ON HIM WHILE IN ROUTE TO BELT HEAD. INT HE #3 ENTRY.
EE WAS OPERATING THE 1 JOY SHUTTLE CAR OPERATOR SIDE CONTROLS LOADED WITH COAL ON ITS WAY TO THE BUGGY DUMP AS THE SHUTTLE CAR TURNED THE CORNER FROM 4 ENTRY TO 3 ENTRY THE EE OPERATOR MISJUD GE CLEARANCE FOR THE TURNALLOWING THE SHUTTLE CAR TO HIT THE RIB AS THE SHUTTLE CAR BURNED THE CORNER. EE WAS PINNED AGAINST THE RIB BRUISED OR BROKEN RIB BRUISED CHEST ON RIGHT SIDE OF RIB CA
EMPLOYEE WAS HELPING TWO OTHER EMPLOYEES MOVE THE CONTINOUS MINER TRAILING CABLE, WHEN HE LOST HIS FOOTING. HE TRIPPED, SPRINING HIS LEFT ANKLE.
EMPL WAS REMOVING THE CHARGER BATTERY CABLES FORMT HE ELKHORN SCOOP AT THE UNDERGROUND CHARGING LOCATION ONE OF THE BELLS WAS EXTREMELY HOT DUE TO A WIRE BEING GROUNDED THE MEPL SUFFERED BURNS BLISTERS ON THREE FINGERS OF L HAND INSPECTION SHOWED THAT THE ELECTRICAL CHARGING BELL WIRE WAS PULLED LOOSE INSIDE THE BELL CREATING A GROUNDING CONDITION