UNIT 1301: 24 citaciones de la MSHA Metal/Non-Metal

EE WAS WALKING ACROSS THE TOOL VAN WHEN HE STEPPED ON A WEAK SPOT INT HE FLOORING. THE SPOT GAVE WAY CAUSING HIM TO FALL.

EMPLOYEE WAS CHANGING A LOADER TOOTH WHEN A PIECE OF METAL STRUCK HIS ABDOMEN.

EMPLOYEE WAS ATTEMPTING TO UNWEDGE A STUCK ROCK IN THE JAW CRUSHER. THE WEDGE SLIPPED CAUSING IT TO FLY UP, STRIKING HIM IN THE FACE.

EE WAS TROUGHING ROCKS ON A CONVEYER BELT WHEN ONE OF THE ROCKS SLIPPED BACKWARDS, STRIKING HIS HAND, BRUISING IT.

EE WAS REMOVING A BEARING FROM A SHAFT, THE BEARING SLIPPED, STRIKING HIS HAND, BRUISING IT.

EE WAS DOING REPAIRS ON EQUIPMENT WHEN HIS BACK BEGAN TO HURT.

EMPLOYEE WAS HELPING TO SET UP A CONVEYER, TRIPPED ON A CROSS TIE, SPRAINING HIS ANKLE.

EE WAS CLIMBING OFF A LOADER WHEN HE BUMPED AGAINST THE OUTRIGGER OF A CRANE PARKED NEXT TO THE LOADER, HURTING HIS HIP.

EE WAS CLIMBING A LADDER WHEN HIS LEFT KNEE GAVE, CAUSING PAIN IN THE KNEE AREA.

EMPLOYEE WAS HELPING TO LIFT A SCREEN WHEN THE MUSCLE IN HIS ARM POPPED OUT OF PLACE.

EE WAS WALKING, SLIPPED, AND FELL ONTO A SHARP ROCK, CUTTING HIS KNEE.

EE WAS INSTALLING A DRIVE BELT ON A SCREENING PLANT WHEN THE IDLER FELL, CATCHING HIS FINGER, SMASHING IT.

EE STATED HE WAS SHOVELING SOME MATERIALS WHEN HE FELT A PAIN IN HIS BACK.

EE STATED HE SCRAPED HIS KNEE AS HE WAS CHANGING SOME SCREENS. A FEW DAYS LATER THE AREA WAS INFECTED.

EE STATED THE DOZER HE WAS DRIVING HIT A BUMP, JARRING HIS BACK.

EE WAS ADJUSTING A BELT ON A CRUSHER WHEN HIS HAND SLIPPED, HIT THE BELT ADJUSTER BRUISING IT

HE WAS CHANGING THE BELTING SWIVEL ON A CRUSHER. HIS WRENCH SLIPPED AND HE HIT HIS ELBOW ON THE SIDE OF THE CRUSHER.

EE STATED HE WAS WALKING BY THE SHAKER OF A CRUSHER WHEN A ROCK FELL OUT OF THE SHAKER AND HIT HIM ON THE BACK OF THE NECK.

EE SUFFERED AN ASTHMA ATTACK. HER COWORKERS WERE UNAWARE SHE HAD THIS CONDITION AND CALLED AN AMBULANCE. \

EE WAS WORKING NEAR A CRUSHER WHEN A ROCK FELL FROM THE JAW OF THE CRUSHER AND STRUCK HIM ON THE SIDE OF HIS HEAD.

EE WAS SHOVELING SME DIR WHEN HIS SHOVEL SLIPPED, CATCHING HIS FINGERS BETWEEN THE HANDLE AND A PART OF THE CRUSHER.

EE WAS ATTEMPTING TO MOVE A BLOCK, WHEN HE FELT A PAIN IN HIS BACK.

AS EE WAS SLIDING SOME RAILING ALONG TOP OF THE SCREEN HE WAS INSTALLING, THE RAILING HIT AN OBSTRUCTION, STOPPING THE MOVEMENT OF THE RAIL BRUISING EE'S HAND

CRUSHER JAWS BECAME INPACTED WITH A LARGE ROCK. USING A SMALLER ROCK IN AN ATTEMPT TO BREAK UP THE IMPACTION, HE TOSSED THE ROCK INTO THE JAWS AREA. IT BOUNCED AND RICHOCHETED BACK, STRIKING H IS HAND.

AS EMPLOYEE WAS STEPPING ON THE LOADER HE'D BEEN WORKING ON, HE TWISTED HIS ANKLE.

EE WAS CHECKING THE FEED BELT WHICH HAD STOPPED. A SHE PUT HIS HAND ON THE V BELT TO SEE IF IT WAS SLIPPING, IT TURNED CATCHING HIS FINGER, CUTTING THE TIP OFF AT THE FIRST JOINT.

WHILE HAMMERING ON SOME BELT FASTENERS, A PIECE OF METAL FLEW UP AND HIT HIM IN THE EYE.

WHILE TIGHTENING BOLTS, WRENCH SLIPPED, HE HIT HIS FINGER WITH THE WRENCH AND TORE HIS FINGERNAIL OFF.

ANDY HAD AN ALLERGIC REACTION TO A BEE STING.

85061S INSTALLING A SCREEN WHEN HE SMASHED HIS FINGERS BETWEEN THE SCREEN AND CRUSHER.

HE FELL WHILE CLIMBING DOWN FROM PRIMARY CRUSHER ONTO LOADER. HE FELL ABOUT 4 FEET ONTO HIS RIGHT SIDE.

HE WAS WALKING ON THE CAT WALK WHILE DOING SOME REPAIR WORK ON IT, WHEN THE CAT WALK GAVE OUT AND HE FELL THROUGH TO THE GROUND.

INJURED WAS LIFTING SOME SCREENS TO PUT INSDIE A SKAKER HE STRAINED A MUSCLE IN HIS STOMACH.

INJURED OPEEND THE DOOR TO THE BACKHOE AND STARTED TO GET IN. THE WIND CAUGHT THE DOOR AND SLAMMED IT INTO HIS HAND.

HE WAS WALKING ALONG BELT TO DISLODGE ROCK WHEN HE SLIPPED AND FELL ONTO BELT.

I NAME STATES HE WAS SHOVELING SAND & PULLED THE MUSCLES IN HIS BACK PLEASE

INSTALLIN G PIN ON CONVEY ON CRUSHER. PIN SLIPPED HIT KNEE IT WAS FALLING

INSTALLING COUNTER WT ON CRUSHER WT SLIPPED CATCHING FINGER ON WT AND CRUSHER.

A LARGE ROCK FELL FROM GRIZZLY PINNING HIS LEG AGAINST BARS OF CRUSHER. METAL CUT HIS LEG.

I NAME WAS OPERATING A CRANE LIFTING A CONE FROM THE CRUSHER WHEN THE CRANE WAS PULLED FORWARD BY THE WEIGHT OF THE CONE. WHEN A FRONT OUTRIGGER BROKE, THE CRANE WAS PULLED INTO THE CRUSHER.