TXI Red River: 34 citaciones de la MSHA Metal/Non-Metal

EE WAS CHANGING IDLERS ON A CONVEYOR AND WAS TRYING TO REPOSITION HANDS TO HOLD THE IDLER, WHEN IT SLIPPED CAUSING FINGER TO BE PINCHED BETWEEN THE CAMS ON THE IDLER.

EE & CO-WORKER WERE CARRYING AN ALUMINUM LADDER TO THE SHAKER. WHILE TURNING TO GO UP THE STAIRS EE FELT A PULL IN HIS UPPER LOWER BACK. THE ACCIDENT WAS CAUSED BY THE LENGTH OF THE LADDER & THE SHARP TURN ATOP THE STAIRS.

THE OPERATOR WAS ENTERING OUR STOCKPILE AREA AND CROSSED A DRAINAGE DITCH. HE HAD BEEN THERE EARLIER IN THE DAY TO DRAIN WATER FROM THE STOCKPILE AREA. HE WAS TRAVELING APPROXIMATELY 15 MPH WH EN HE ENTERED THE DITCH. AT THAT TIME THE WEIGHT OF THE LOADER SHIFTED FROM LEFT TO RIGHT WHICH FORCED HIS BACK TO SHIFT LEFT TO RIGHT THEREFORE CAUSING A MUSCLE STRAIN IN THE LOWER BACK.

ON MONDAY DEC. 22, EE WAS PERFORMING MAINTENANCEAT DREDGE. HE WAS HELPING CO-WORKER DO OIL CHANGE ON 3406 AND CLEANING UP CAB OF DREDGE, AND TEARING OUT OLD FLOOR SO NEW ONE COULD BE INSTALLE D. EE HELPED CARRY SOME CONCRETE BOARD USED TO REPAIR FLOOR. THE BOARD WAS CARRIED APPROX. 40 YDS DOWN A RAMP. EE CONTINUED TO WORK ON FLOOR PROJECT UNTIL COMPLETED... (1/13/04-HAD SURGERY)

EE WAS HELPING HOLD A TAIL PULLEY GUARD WHEN WELDING WAS GOING ON. HE RECEIVED FLASH BURNS TO HIS EYES.

EMPLOYEE WAS CHECKING HYDRAULIC PRESSURE ON CLASSIFIER, WHILE COMING DOWN THE STAIRS HE SAID HIS LEG LOCKED UP AND GAVE HIM A JAR. HE CONTINUED TO WORK, AS THE NIGHT WENT ON HIS BACK STARTED T O HURT. EE LEFT WORK AROUND 3:00 AM AND HE COULDHARDLY WALK.

EE WAS ALIGNING 2 PIECES OF FLANGED PIPE WHICH WERE FLOATING ON PONTOONS ON THE DREDGE POND. THEY WERE USING AN OUTBOARD BOAT TO LINE UP THE PIPE BECAUSE OF HIGH WIND. INJURED WAS ON THE PIPEL INE. THE BOAT WAS AT HIGH THROTTLE TO COMPENSATEFOR THE WIND.INJURED STEPPED ONTO THE BOAT & THEFRONT OF BOAT SLIPPED UNDER PIPELINE. THE BOAT SHOT FORWARD CATCHING LEG BETWEEN BOAT & PIPELIN

EE SLID A HYDRAULIC MOTOR WHICH WAS UNDER A SHELF TO A POSITION WHEN HE COULD LIFT IT TO A TABLE FOR EXAMINATION. THE PUMP WAS ON THE SHOP FLOOR. HE SQUATTED OVER IT AND LIFTED IT TO A WORK TA BLE. AS HE WAS LIFTING HE FELT A TEARING SENSATION & PAIN IN HIS GROIN. HE WENT TO THE DR. AND WAS TOLD THAT HE HAD A HERNIA. HE RETURNED TO WORK WITH NO HEAVY LIFTING FOR 48 HRS. RESTRICTION

EE WAS WALKING INTO THE SHOP AT THE BEGINNING OF HIS SHIFT (6:00 AM) AND AN INSCECT FLEW INTO HIS LEFT EYE. WE FLUSHED HIS EYE WITH EYE SOLUTION ALL MORNING & SENT HIM TO THE DOCTOR THE A.M. O F THE 6TH. HE PRESCRIBED DROPS & COVERED IT FOR THE DAY. NO FOLLOW UP NECESSARY, PRECAUTIONARY DR VISIT ONLY.

EMPLOYEE WAS PLACING SECTIONS OF PIPE 4' X 8" ON THE FLAT BED TRUCK. HE FELT A SLIGHT STRAIN BUT CONTINUED TO WORK. SATURDAY AM HE WOKE UP WITH PAIN. HE SAID HIS BACK HAD BEEN BOTHERING HIM FO R TWO WEEKS.

EMPLOYEE WAS OPERATING A JOHN DEERE FRONT END LOADER, ALLEDGES THAT THE SEAT DID NOT ADJUST FOR HIM, THUS CAUSING HIM BACK PAIN.

EE WAS LOADING RAIL CAR IN A 980G LOADER HE PULLED OFF OF THE PAVED CROSSING ONTO THE LOADING PAD. THE UNEVEN AREA CAUSED THE LOADER TO JERK IT JARRED EE CAUSING BACK PAIN

EE WAS WELDING WEARING SAFETY GLASS BUT BURNT SLAG/ASH GOT AROUND LENSE & STUCK TO HIS LEFT CORNEA. DID NOT MISS ANY TIME

STEERING WHEEL JERKED LEFT WHILE VEHICLE WAS BEING TOWED.

EMPLOYEE WAS SQUATTED DOWN WASHING OUT UNDER THE TAIL PULLEY & HE FELT HIS BACK POP, HE PULLED HIMSEL FUP ON THE FRAMEWORK, STOOD FOR A MINUTE & WALKED TO THE SHOP. THE PAIN SUBSIDED INSIDE A N HOUR.

EE WAS USING HIS POCKET KNIFE TO CUT RUBBER HOSE AND THE KNIFE CLOSED ON HIS FINGER.

WHILE WORKING ON A DREDGE PUMP WITH AN AIR CHISEL, A METAL FRAGMENT STRUCK HIM IN THE FOREHEAD. A DOCTOR REMOVED THE FRAGMENT.

THE EE WAS USING A BOX KNIFE TO CUT SKIRT BOARD RUBBER. THE KNIFE SLIPPED & HE PUNCTURED HIS LEFT THUMB - HEEL OF THE THUMB.

WHILE UNBOLTING & STACKING GROUSERS SHOES

EMPLOYEE WAS CHECKING A THROUGH IDLER FOR A BAD BEARING. EMPLOYEE PLACED GLOVED HAND ON IDLER, THE BELT PULLED HIS HAND & ARM UNDER THE LOADED BELT AND OVER THE IDLER. THE EMPLOYEE WAS ABLE TO PULL HIMSELF FREE.

EE HAD A LOWER LUMBAR STRAIN EMPLOYEE STATED HE WAS WASHING 980C WHEEL LOADER WITH A 3000 PS1 WASHER THE FATIGUE FROM HOLDING THE WASHER CAUSED A STRAIN 3 WEEKS LATER IT WAS REPORTED EMPLOYEE SAID HE HAD BEEN TO THE DOC & IT WAS REQUESTED HE TAKE THE REST OF THE WEEK OFF FOR REST (03-14-95) THE DAY HE RETURNED TO WORK WE WERE INFORMED THE STRAIN WAS RELATED