Fredericksburg Quarry Metal/Non-Metal

EE was performing start of shift maintenance on KPI 4250 (Rock Crusher) attempting to add anti-freeze to the radiator the EE fell approx 5ft from the position where they were standing to the crusher deck. EE was treated in the local ER diagnosed with a right AC joint separation, Non displacement fracture to C4, and two broken ribs. The EE was treated and released from the ER.

A Leak was found in a 500 gal propane tank outside the office building. All personal were evacuated to the quarry main gate. The gate is about 1/4 mile from the office. Once the propane company had check and repaired the tank the all clear was given.

Employee repairing lubrication system, climbing off machine to get more parts, hung ring on step while descending to ground level.

driller closed hand in door of drill rig and received 7 stitches on middle finger

EE was exiting heavy equipment (rock breaker Komatsu 200) at the end of his shift on Tuesday May 22nd around 6:30p.m. EE stepped from the tread of the equipment onto the step when the step broke causing the EE to contact the tread/broken step with his lower right leg. EE did not report injury to supervision until Wednesday May 30th.

Primary crusher truck dump bridged and had to throw chain under/over large rocks to break bridge. Employee proceeded to climb into the hopper to break the jam, while doing so employee stood on a rock instead of a flat surface. The rock slipped out from under the employee which caused the employee to fall striking his tailbone on a rock. Employee suffered a bruised tailbone.

Employee was looking for a survey marker on a joining lease property fence line, when he tripped on a small rock causing him to fall and twist his left knee.

Employee was trying to loosen a nut on a Euclid R-35 Haul Truck. Wrench slipped knocked safety glasses off and struck employee's right eye.

EMPLOYEES WERE ROLLING A VEE BELT BETWEEN A HAMMER MILL AND ELECTRIC MOTOR. EMPLOYEE WAS PULLING ON VEE BELT AND PINCHED 4TH AND 5TH DIGITS OF LEFT HAND BETWEEN VEE BELT AND SHEEVE.

WHILE PUTTING A NEW VBELT ON THE CRUSHER, EE WASUSING A SCREWDRIVER TO ROLL THE BELT FROM ONE GROVE TO THE NEXT TO GET IT IN ALIGNMENT ON THE PULLEYE. THE SCREWDRIVER FLIPPED OUT WHEN EE ROL LED THE BELT STRIKING HIM ON THE CHIN CAUSING A LACERATION REQUIRING 6 STITCHES

EMPLOYEE WAS REMOVING CATWALK AND STOOD UP AND HIT HIS HEAD ON A PIECE OF PERTRUDING ANGLE IRON CAUSING A SMALL LACERATION. TWO STITCHES WERE REQUIRED.