Avísenme cuando se presente un nuevo incidente de la MSHA en Mine No 2.
| Trimestre | Horas trabajadas | Citaciones | S&S | Por 1M hrs |
|---|---|---|---|---|
| 2002 Q3 | 6,213 | 5 | 1 | 804.8 |
| 2002 Q2 | 18,339 | 9 | 6 | 490.8 |
| 2002 Q1 | 20,910 | 10 | 2 | 478.2 |
| 2001 Q4 | 21,680 | 7 | 4 | 322.9 |
| 2001 Q3 | 21,213 | 15 | 6 | 707.1 |
| 2001 Q2 | 21,577 | 7 | 6 | 324.4 |
| 2001 Q1 | 20,974 | 6 | 6 | 286.1 |
| 2000 Q4 | 19,610 | 8 | 4 | 408.0 |
A ROOF FALL WAS DISCOVERED IN THE NO. 2 SOUTH AREA OF THE MINE, ONE (1) BREAK INBY SURVEY STATION #1084. THE FALL WAS IN AN INTERSECTION AND MEASURE APPROXIMATELY 40'LONG X 20'WIDE X 5'THICK. THERE WERE NO INJURIED OR EQUIPMENT INVOLVED. THE FALL WILL NOT BE CLEANED UP.
THE EMPLOYEE WAS CLEANING THE SECTION FEEDER WITH A BATTERY POWERED SCOOP WHEN HE WAS STRUCK BY A PIECE OF DRAW ROCK BEHIND THE HEAD, STRAINING HIS NECK.
A ROOF FALL WAS DISCOVERED IN THE OUD A SOUTH PANEL. THE FALL WAS IN THE NO. 2 ENTRY AT SURVEYSTATION 1173 AND MEASURED 30'LONG X 20'WIDE X 5'HIGH. THERE WERE NO INJURIES OR EQUIPMENT INVOLV ED. VENTILATION WAS NOT AFFECTED.
EE WAS PULLING CAT HEAD TO LOAD IN SCOOP PAN WHEN HE SLIPPED AND FELL STRIKING HIS RT. KNEE ON THE MINE FLOOR. HE WAS WEARING KNEE PADS.
A ROOF FALL OCCURRED IN THE #6 ENTRY OF THE #1 SOUTH SECTION. THE FALL MEASURED APPROX. 40'LONGX 20'WIDE X 6'HIGH. THERE WERE NO INJURIES OF EQUIPMENT INVOLVED. THE FALL WILL NOT BE CLEANED UP.
AT APPROX. 7PM ON 4-3-02, A FALL WAS DISCOVERED IN THE #2 ENTRY OF #1 SOUTH APPROX. 2 BREAKS OUTBY THE SECTION LANDING POINT AT SURVEY STATION #1037. THE FALL WAS APPROX. 28'LONG X 20'WIDE X 6'HIGH. THE AREA WAS SUPPORTED WITH 4'RESIN BOLTS & SUPPLEMENTED WITH 6' RESIN ASSISTED ANCHOR BOLTS. THERE WAS NO EQUIPMENT INVOLVED. THERE WERE NO INJURIES.
THE SCOOP OPERATOR WAS DUSTING THE #3 ENTRY WHENHE WAS GETTING BACK IN SCOOP DECK, A ROCK FELL STRIKING HIM IN HARD HAT, AND BUSTING IT.
EE WAS WALKING IN HIGH PLACE, ENTERED LOW PLACE, KNOCKED CAP OFF, HIT HEAD ON ROOF BOLT PLATE. REQUIRED 5 SUTURES.
DURRING THE PRE-SHIFT EXAMINATION A ROOF FALL WAS DISCOVERED IN THE #3 BELT ENTRY ON #3 EAST AT SURVEY STATION 898. THE FALL WAS APPROX. 400'OUTBY THE ACTIVE SECTION AND MEASURED APPROX. 40'LONG X 20'WIDE X 6'HIGH. EXCEPT FOR CONVEYOR BELTING AND STRUCTURE, THERE WERE NO INJURIES OREQUIPMENT INVOLVED. THE FALL WILL NOT BE CLEANEDUP.
EE WAS DRIVING A PIN THROUGH SHREVE PULLEY. HE HAD HIS FINGER UNDER THE PIN AND STRUCK THE PIN WITH A HAMMER, CUTTING OFF THE FIRST JOINT OF HIS LEFT RING FINGER.
EE WAS INSTALLING ROOF BOLTS IN #2 HEADING AFTERDRILLING STARTER HOLE AND INSTALLING 2ND PIECE OF STEEL. HE SWUNG HEAD OVER TO ALIGN SECTION OF DRILL STEEL AND MASHED HIS HAND BETWEEN DRILL ST EEL AND CANOPY.
EE WAS CLEANING UP LOOSE COAL IN FRONT OF TAIL PIECE, MOVING COAL TO #1 ENTRY TO DUMP. WHEN HE CHANGED DIRECTION OF TRAVEL RETURNING TO TAILPIECE, HE HIT A ROCK, PUSHING HIM INTO TOP.
A ROOF FALL WAS DISCOVERED ~1,500' OUTBY THE ACTIVE SECTION. FALL WAS LOCATED IN THE NO. 4 ENTRYOF 6 NORTH AT SURVEY STATION 543 & MEASURED ~18'WIDE, 40' LONG, 5' HIGH. THERE WERE NO INJURIES OR EQUIPMENT INVOLVED.
AN UNPLANNED ROOF FALL WAS DISCOVERED IN THE #6 NORTH SET OF ENTRIES, LOCATED IN THE NO. 5 ENTRY~30' INBY SURREY STATION 542 & MEASURED ~20'LONG17'WIDE & 6'HIGH. NO INJURIES, EQUIP. INVOLVED.
EE WAS MOVING A PIECE OF 3/8 METAL & MASHED LEFTMIDDLE FINGER.
EMPLOYEE WAS SETTING UP BELT AND TURNED TO PICK UP A RAIL AND TWISTED HIS KNEE. HE CONTINUED TO WORK UNTIL IT WAS DETERMINED THAT HE NEEDED SURGERY.
EMPLOYEE WAS TAKING DOWN CONTINUOUS MINER CABLE, AND THE TIE CAME LOOSE HITTING HIM IN THE RIGHT EYE.
EE STATED THAT HE JUMPED OFF THE BACK OF A DIGGER TRUCK. HE DID NOT USE THE STEPS AND SAFETY RAILS PROVIDED.
EMPLOYEE WAS RUNNING ROOF BOLTER WHEN A ROCK (3FT X 4IN) FELL MASHING LEFT HAND ON PINNER.