Central Shop: 2 citaciones de la MSHA Coal

EMPLOYEE WORKED 11-12-93, WENT HOME, OVER WEEKEND, HIS EYE STARTED BOTHERING HIM. WENT TO DOCTOR & HAD FOREIGN BODY REMOVED FROM HIS EYE. RETURNED TO WORK 11-15-93 & REPORTED.

EMPLOYEE WAS STANDING BEHIND HIS VEHICLE RUNNING PH ON A WATER SAMPLE WHEN A COAL TRUCK DROVE BY FROM BEHIND. COAL DUST BLEW OFF OF TRUCK BED & ENTERED HIS LEFT EYE.

EMPLOYEE STEPPED BACK FROM LATHE TO AVOID CHIPS STOPPING SLIGHTLY OVER EDTGE OF WORK PLATFORM CAUSING HIS ANKLE TO WRIST & CAUSE INJURY

EMPLOYEE WAS SHARPENING BOLTS ON A STATIONARY GRINDER. THE BOLT WAS RESTING ON THE TOOL REST WHICH WAS SET AS CLOSE AS PRACTICAL TO THE WHEEL. AS THE TAPER ON THE BOLT BECAME LONGER, THE END O F THE BOLT WAS ROLLED DOWNWARD JERKING THE BOLT DOWN BETWEEN THE TOOL REST AND THE GRINDING WHEEL CATCHING THE END OF THE MIDDLE FINGER BETWEEN THE BOLT AND GRINDING WHEEL.

EMPLOYEE WAS RAISING THE HINGED PARTION OF THE GATHERING PAN OF A JOY MIENR WITH A 10 TON OVER HEAD HOIST. IN ORDER TO REMOVE THE PINS AN EYE HAD BEEN WELDED IN THE THOAT OF THE PAN WELD BROK E, HOIST HOOK KNOCKED HAT OFF. HOOK STRUCK EMPLOYEE ON TOP OF HEAD ON TEH WAY BACK DOWN.

EMPLOYEE WAS RETURNING TO DANTE OFFICE. THERE WAS A BEE INT HE TRUCK. HE WAS STUNG IN RIGHT SHOULDER.

EMPLOYEE STATED THAT HE WAS DOWN ON ONE KNEE INSTALLING CONVEYOR FLIGHT, FLIGHT WENT THROUGH, BELOW CHAIN, EMPLOYE WAS PULLING FLIGHT BACK INTO PLACE, FELT BURNING PAIN IN LOWER BACK.

HE WAS BACKING UP STEEP GRADE HIS SEAT BELT WAS NOT FUSTENED GOOD. IT CAME LOOSE LETTING HIS KNEE STRIKE DASH OF DOZER. SEAT BELT WORK GOOD WHEN FASTENED GOOD.

WHILE DIRECTING LOAD ON TRAILER EMPLOYEE FELL THROUGH HOLE IN FLOOR OF TRAILER, THE RIGHT ARM WENT THROUGH A DIFFERENT HOLE AND WAS CUT.

HE WAS SETTING BATTERY OFF OF TRUCK TO GROUND STRAINED HIS BACK

WALKED INTO WASP NEST WAS STUNG MID ABDOMEN.

EMPL HAD REMOVED JACKS FROM LONGWALL SHIELD AND SUBSTITUTED CRIB BLOCKS TO SUPPORT CANOPY. SHIELD WAS BEING TRANSPORTED TO STORAGE AREA WHEN CRIB BLOCK CAME LOOSE. EMPL RESET BLOCK,CANOPY SHIV TED CATCHING FINGER BETWEEN BLOCK AND FRAME OF SHIELD.

A PHYSICIAN HAS DETERMINED THAT THE EMPLOYEE HAS DEVELOPED SYNOVITIS AS A RESULT OF THE REPETITIOUS USE OF VIBRATORY TOOLS

DRIVING HAULER,SMOKE FROM ENGINE GOT INTO CAB.EMPL GOT SICK AT STOMACH SPIT UP BLOOD GOT LIGHT-HEADED AND NERVOUS.A LITTL DIFFICULTY BREATHING AND TIGHTNESS IN CHEST.

WHILE INSTALLING PACKING CUP IN A HYD JACK,THE SCREWDRIVER BEING USED BY THE EMPLOYEE SLIPPED AND PUNCTURED HIS MIDDLE FINGER AT THE FIRST JOINT ON HIS LEFT HAND.

AFTER COMPLETING JOB ON END BELL, INJURED LOOSENED SIDE JAWS COMPLETELY, THEN LOOSENED TOP JAW CENOUGH TO RELEASE AND BELL. AS HE ATTEMPTED TO LIFT IT AT HIS FELT A STRAIN IN LEFT LOWER BACK.

WHILE LAYING ON HIS SIDE & DISCONNECTING A 2IN PIPE TEC WITH A 14 IN PIPE WRENCH EMPLOYEE STRAINED HIS LEFT ELBOW CAUSING A LARGE BUMP TO APPEAR ON THE BACK SIDE OF HIS ELBOW

EMPLOYEE WAS CUTTING TAKE UP FROM END OF TRUSS, WHEN TAKE UP CAME LOOSE, TRUSS RAISED UP, THROWING MINER FROM CAT WALK.

THE EMPLOYEE WENT TO A PHYSICIAN ON 07-19-91 WITH AN ILLNESS IT WAS NOT DETERMINED THAT HE WAS ALSO BEING TREATED FOR A BACK STRAIN UNTIL 07-25-91.INJURED WAS LIFTING A D8L DOZER ARM AND STRAI NED HIS BACK.

INSTALLING CUTTING EDGE ON LOADER BUCKET,EMPL BLEW SOME DIRT OFF AND GOT SOMETHING IN EYE(OR,PUT CUTTING GOGGLES ON AND SOMETHING GOT IN EYE).WENT TO DR 8-21-91.

EMPL CHECKING BRAKES ON 966 END LOADER AND CUT FINGER ON LEFT HAND.

INJURED WAS CLEANING SCALE AND RUST FROM AN ELECTRICAL ENCBSURE WITH AN AIR GRINDER, A FOREIGN PARTICLE ENTERED THE RIGHT EYE FROM UNDERNEATH THE SAFETY GLASSES.

WHILE PUSHING DOWN HARD ON A SCREWDRIVER TO REMOVE A TIGHT SCREW EE FELT A SHARP PAIN IN THE BACK OF HIS NECK AND SHOULDERS RECEIVED PHYSICIANS REPORT 11-29-90.

EMPLOYEE WAS UPON THE WORK TABLE WHILE INSTALLING A BEARING ON A SHAFT. AFTER THE BEARING WAS INSTALLED, HE JUMPED OFF THE TABLE ONTO THE FLOOR CAUSING PAIN IN THE RIGHT HIP AREA. DID NOT MISS WORK UNTIL 11-2-90.

WHILE REMOVING A HAMMER FROM THE BOTTOM OF EE TOOL CABINET HE SCRAPED HIS LITTLE FINGER ON A SHARP EDGE ON THE UNDERSIDE OF THE ABOVE SHELF SEVERING THE NAIL.

WHILE BACKING DOWN LADDER EMPLOYEE BUMP0ED ELBOW ON HOIST FRAME THIS ACCIDENT WAS NOT REPORTED UNTIL 09-27-90

WHILE EE WAS POURING POWDERED FLUX FROM A BUCKET INTO A BARREL A CLOUD OF DUST CAME FROM THE BARREL BACK INT. HIS FACE.

WHILE GRINDING A JEEP WHEEL WITH AN AIRGRINDERS A PARTICLE OF DUST ENTERED EE S EYE.

WHILE TWO MEN WERE LIFTING A LONGWALL SUPPORT JACK FOR ASSEMBLING, THE PACKING GLAND SLIPPED AND CAUGHT EMPLOYEE'S LITTLE FINGER IN THE EYE OF THE ROD.

EMPLOYEE WAS USING AN EASY OUT OT REMOVE A BROKEN BOLT FROM A MOTOR END BELL. THE EASY-OUT BROKE AND HIS HAND STRUCK SURFACE OF END-BELL REQUIRING TWO STITCHES ON EACH FINGER.

WHILE REMOVING PINION FROM POT USING PIECE OF KEY STEEL AS DRIVER HAMMER GLANCED OFF & HIT HAND HOLDING KEY STEEL AS PINION BROKE LOOSE.

EMPLOYEE BURNED A PLATE OFF THE EMPLOYEE WAS HOLDING IT WITH A PAIR OF VISE-GRIPS. THE EMPLOYEE WAS OUT OF POSTION AND THE WEIGHT CAUSED A STRAIN.

WHILE GRINDING A PINNER FRAME,A FOREIGN PARTICLE GOT INTO HIS EYE.EMPLOYEE THOUGHT IT WAS OUT,BUT IT GOT IRRITATED LATER.

TESTING AIR PUMP LACED 2 INCH JPUMP INTO OPEN TOP BARREL FILLED WITH WATER TO RUN TEST PUMP. AIR VALVE TURNED ON JPUMP ROTATED DISCHARGED WATER ONTO EMP CAUSING HM OT FALL ON PAVEMENT.

WELDIGN BIT BLOCK S ON MINER URM WHEN PC OF SLG ENTERD LEFT EYE.

EMPLOYEE WAS DRIVING BEARING OUT OF DRILL HOUSING BY USING A PIECE OF KEY STOCK AND HIT HIS LEFT THUMB NAIL WITH THE HAMMER.

EMPLOYEE WAS SORTING PARTS FOR A JOY 14 CM CMINER HEAD, PICKED UP SOME BEARING SHIMS ONE SHIM HOOKED ONTO A STAPLE ON THE BOX TOP AND A .005" SHIM SLICED INTO HIS LITTLE FINGER.

WHILE WELDING UP BOLT HOLES ON LONGWALL CONVEYOR PAN A BALL OF HOT STELL FELL ONTO MINERS LEFT FOOT CAUGHT BEHIND STOCK LACE AND BURNED TOP OF FOOT.

WHILE USING BAR TO PRY A GEAR OUT OF GEAR CASE THE BAR SLIPPED AND CAUGHT FINGER AGAINST WORK TABLE

EMPL WAS GRINDING BITS AND PARTICLE FLEW UNDER SAFETY GLASSES AND ENTERED L EYE

EMPL LIFTING VALVE BLOCK AND FELT PAIN IN LEFT GROIN AREA.

EMPL ATTACHING OVERHEAD HOSIT HOOK INTO EYE BOLT ON MOTOR TO LIFT IT ONTO WORK TABLE FELT PAIN IN LOWER LEFT BACK.

EMPLOYEE STRUCK WRIST AGAINST A RAGGED PIECE OF METAL WHEN WRENCH SLIPPED WHILE REMOVING A SOCKET HEAD BOLT.

WHILE HAMMERING WITH A 5 LB. MALLET ON MOTOR END BELL, THE SHOCK CAUSED TENDONS TO PULL IN RIGHT WRIST. THE PERSON DID NOT MISS WORK UNTIL 8-30-88.

WHILE REMOVING SLAG AFTER BURNING BOSSES FROM EICKHOFF SHEAR BASE PLATE FORIEGN PARTICLE ENTERED UNDER SAFETY GLASSES LEFT EYE

EMPLOYEE WAS CUTTING BANDS ON 3 PIECES OF PIPE.WHEN LAST BAND WAS CUT,EMPLOYEE STEPPED BACK TO AVOID PIPE.HE UNEXPECTEDLY STEPPED OFF CONCRETE CAUSING HIS KNEE TO TWIST.

WHILE LOADING A3TRUCK, PICKED UP A 5 GALLON BUCKET CONTAINING 403 ROOF BITS, APPROX. 90 LBS. TOOK 3 STEPS AND FELL TO HIS KNEES.

WITH BELT ROLLE9 LYING ON STEEL WORK HORSES, EMPLOYEE WAS TRYING TO PUSH SHAFT FROM ROLLER TO REMOVE IT. ROLLER SLIPPED FROM ONE HORSE ALLOWING SHAFT AND ROLLER TO DROP. EMPLOYEES RT WRIST WAS PINNED BETWEEN3SHAFT AND WORK HORSE.

WHILE REARRANGI3G MOTOR STORAGE EMPLOYEE STRAINED HIMSELF WHILE PUSHING AND PULLING ON MOTOR.

EMP WAS APPLYIN1 COOLANT TO DRILL BIT WHILE DRILLING AND A LARGE CHIP CAUGHT ON HIS FINGER

EMPLOYEE WAS SH2VELING SLIMY MATERIAL FROM PIT IN WASH BAY CAUSING PAIN IN LOWER BACK.

WHILE EE WAS U3LOADING TRUCK HE ACCIDENTLY BUMPED LEFT ELBOW AGAINST TRUCK BED.

WHILE RISING FR2M DEST CHAIR EE BUMPED RT KNEE ON DESK DRAWER HANDLE.

VIBRATION MOVING JACK HEAD ON WORK TABLE CAUSED IT TO FALL ON EMPLOYEE RIGHT FOOT.

EES HAND WAS CAUGHT BETWEEN A WATER PUMP THE SIDE RAILINF OF HIS TRUCK. PUMP WAS BEING LOADED USING A MOBILE CRANE. EE WAS TRYING TO GUIDE THE PUMP INTO POSITION TO AVOID HITTING OTHER PARTS ON THE TRUCK.

EMPLOYEE STRAINED HIMSELF WHILE LIFTING COVERS TO INSTALL ON LONGWALL SHEARING MACHINE.

WHILE PRESSING BEARING OFF STAMLER FEEDER SHAFT, CAST IRON HOUSING BROKE AND PIECE STRUCK EMPLOYEE ON CHIN AND LEFT SHOULDER

EMPLOYEE TRIED TO MOVE WOOD BLOCK WITH FOOT RATHER THAN HIS HANDS

PULLED MUSCLE IN LOWER BACK WHILE DRIVING PULLEY ON MOTOR SHAFT WITH RUBBER MALLET

ELECTRIC MOTOR INSTALLING BEARING ON ROTOR SHAFT WITH HAMMER EMP HIT LITTLE FINGER ON LEFT HAND WITH HAMMER

GATHING MATERIAL TO DELIVING TO MINE SHAFT ROLLED AND PINCHED FINGERS BREAKING BEYOND LAST JOINT.