Lindbergh Coal

While traveling down the steps of the PC2000 with a hydraulic pump hose in his hand the hose became hung. Injury pulled on the hose. When the hose was free it caused the reel to release and pull the hose causing him to loose his balance. His right leg lodged between the track and step. He has a bruised knee and sprained ankle.

While pulling the fuel hose down off a machine, the hose caught left wrist causing a sprain.

The injured employee was operating a motorgrader along a repair/parking lot and stopped and manually moved an old metal ladder weighing approximately 80 lbs. He stated he felt a "tingling sensation" in his right arm.

Employee was stepping down from a bulldozer when he missed the bottom step, located on the pusharm, and pulled muscles in his lower back.

The employee parked the bulldozer that he had been operating in the equipment parking area at the end of his work shift. He then got out of the cab of the machine and either jumped or fell to the ground. He was taken to the hospital where he was examined and released, but claims his back is hurting too much to come to work.

Employee was traveling on haul road, missed gear and lost control of water truck and rolled truck over on side.

Employee had finished shift, parked drill and was climbing down from machine. When he stepped on ground and released grip on ladder, he twisted right leg. Employee did not insure proper footing before releasing grip on ladder.

He was climbing down off dozer, when he slipped and fell to ground, landing on knees and hands. He is complaining of a left leg hurting.

Removing filters from scale house porch, went to walk off and he tried to miss something that was on the ground. He shifted all his weight and lost balance and fell.

EE stepped off of D11 carry dozer backwards and landed on the rail of service truck and hurt his back.

Motor grader tire exploded and employee nearby was hit by an air blast and debris.

Motor grader tire exploded and employee nearby was hit by an airblast and debris.

Stepped off left side of dozer onto window rock rolled and twisted left ankle.

Slipped on push arm getting off machine, straddled arm when he fell.

EE was repalcing area differential in service truck and when he stretched to guide a part into place he strained his neck and upper back. He did not lose any time and did not seek medical treatment. He did not report injury to mine mgt. until 1/3/06. On 5/3/06 He notified mgt he would be off work beginning 5/4/06 with surgery for 2 pinched nerves and one disk replacement.

EE WAS ENTERING MOTORGRADER WHEN THE WIND BLEW THE DOOR SHUT ON RIGHT HAND

EE WAS STEPPING FROM LOADER ONTO A CRUSHER. EE FELT RIGHT KNEE POP

EE JUMPED DOWN FROM HIS LOADER AND TWISTED HIS ANKLE.

FOREMAN WAS REPLACING A BELT ON A DUMP TRUCK, WHNE HE STEPPED OFF THE TRUCK HE STEPPED IN A HOLE.

EE WAS TRYING TO PUSH A LOOSE PIECE OF STEEL ON HEAD MOTOR OF DRILL AND LOST HIS FOOTING AND FELL BACKWARDS AND INJURED ELBOW.

EE WAS RECLAIMING AND HAD A FERTILIZER SPREADER BEHIND TRACTOR. THE SPREADER SLID AROUND ON SOFT GROUND CAUSING HIM TO SLIDE DOWN HILL AND HIT HIS HEAD AND NECK ON THE TRACTOR, PULLING LIGAMEN TS IN HIS LEFT SHOULDER.

EE WAS RECLAIMING AND THE TRACK ON DOZER HIT A FLAT ROCK CAUSING DOZER TO SLIDE AND TWISTED HIS BACK.

HYDRAULIC HOSE BROKE ON TRACK HOE AND BLEW OUT GLASS ON THE TRACK HOE AND HIT RIGHT ARM AND BROKE IT IN TWO PLACES.

EMPLOYEE WAS WORKING UNDER THE HOIST DRUM ON THE 625 PAGE DRAGLINE HE STRUCK HIS KNEE ON THE HOIST DRUM.

WORKING ON LOADER WRENCH SLIPPEDAND HE STRUCK A SHARP PIECE OF METAL ON THE LOADER FRAME.

EMPLOYEE WAS LOADING HOLES FROM THE BULK TRUCK THE LATCH ON THE WINCH REEL BROKE CAUSING THE BOOM TO SWING AND STRIKE HIS LEFT HAND.

EMPLOYEE WAS GRINDING METAL THE GRINDER STRUCK A BRACKET AND JUMPED BACK INTO THE EMPLOYEES LEG