Registro de la MSHA sobre MOLINE #330 (ID de mina 1400115). Muertes, incidentes no mortales agrupados por año, operador y controlador actuales, y contexto de la mina.
Avísenme cuando se presente un nuevo incidente de la MSHA en MOLINE #330.
A EMPLOYEE WAS REMOVIGN APRT OF A DRIVELINE (DRIVESHAFT) TO INSTALL IT IN ANOTHER TRUCK. THE EMPLOYEE HAD TO USE A TORCH BECAUSE THE UNIVERSAL JOINT WAS FROZEN. WHILE USING THE TORCH, A PIECE OF STEEL WENT INTO THE EMPLOYEES LEFT EAR.
EE WAS REMOVING A HOSE AND SPOUT FROM A 55 GAL DRUM. THE HOSE BECAME TWISTED AND KNIKED AS IT WAS UNSCREWED. WHEN THE HOSE DISENGAGED FROM THE DRIVER, THE METAL END UNTWISTED, RAPIDLY, STRIKIN G THE EE IN THE MOUTH. EE WAS TWISTING DRUM HOT HOSE.
THE EE WAS WALKINAG WITH A PROPANE TORCH. HE LOST HIS FOOTING ON SOME ICE & FELL. AS HE FELL HISLEG TWISTED OUT UNNATURALLY & HE BROKE HIS ANKLE.
EE WAS USING A SLEDGE TO REMOVE SEGMENTS FROM IDLER. A METAL FRAGMENT FROM A SEGMENT WAS PROJECTED INTO HIS FOOT.
EE BELIEVES HE HURT HIS BACK WHILE LIFTING A SCREEN DECK TWO OTHER EE WERE ASSISTING WHEN HE CORNER STUCK HE JERKED ON HIS END TO FACE IT CAUSING AN INURY TO HIS BACK.
EMPL UNHOOKING CABLE FROM LOADER.IT CAME BACK AND HIT EMPL IN MOUTH BUSTING LIP AND CHIPPING FRONT TOOTH.
EE WAS HAULING STRIPPED OVERBURDEN AND DUMPING INTO THE OLD PIT BRAKES FAILED AND BERM DIDNOT HOLD TRUCK HAUL TRUCK ROLLED OVER EMBANKMENT AND LANDED ON SIDE. OPERATOR WAS WEARING SEAT BELT.
EMPL REMOVING PULLEY ON SCREEN.CHISLE FLEW OUT OF TAPOR LOCK ON PULLEY WHEN HIT WITH HAMMER STRIKING EMPL IN CHIN REQ 7 STITCHES.
EMPL GRINDING WELD ON ROLLER FRAME UNDER DOZER AND GOT METAL CHIP IN EYE.WASNT WEARING GOGGLES OR FACE SHIELD.
EMPLOYEE WAS CHANGING AN AIR VALVE ON A 33-07 TEREX HAUL TRUCK, STANDING ON A FOUR FOOT LADDER LEANING AGAINST THE FRAME OF THE TRUCK WHEN HIS FOOTING SLIPPED, CATCHING HIS RIGHT UPPER ARM ON THE TOP OF THE LADDER CAUSING A CUT REQUIRING 13 STITCHES.
EMPLOYEE WAS ST9PPING DOWN FROM A RAILROAD CAR AND ACCIDENTLY STEPPED ONTO THE RAIL PULLING LIGAMENTS IN FOOT.
EMPLOYEE WAS UNDER MINING & TOUCHED THE END OF THE SHART WITH HIS RIGHT HAND THE CHAIN CAME UNHOODED CAUSIED THE GEAR & SHAFT TO DRO TO THE GROUND CATCHING RIGHT HAND BETWEEN THE END OF SHAFT GROUND CUTTING RIGHT HAND AT THE BASE OF THE THUMB REQUIRING EIGHT STITCHES.