Sun City Pit Metal/Non-Metal

While pulling a clump of polymer out of a clogged chemical mixing tank. Clump was solid on outside, center was powder and it blew into employees face and eyes.

Driving haul truck, hit a bump and jarred his back.

Employee fell off the catwalk of the excavator.

Employee was tightening a bolt when his glove was caught in between the washer and the frame.

Employee was using a pry bar and strained his shoulder.

Employee was lifting a one inch impact above his head, twisted wrong and strained his chest.

The conditions at the plant were all clean and in good shape. The problem happened when the employee slipped while putting in a bolt on the motor mount at the cone and was not wearing his fall protection equipment.

Employee was exiting crawl space area and stood up going forward striking his head on beam jamming his neck. Employee broke his hard hat when he struck beam. He worked for 3 weeks after accident until pain was only getting worse and he decided he better see a doctor.

JOSTLING IN HAUL TRUCK IN MINE PIT RESULTED IN CHATTERING OF TEETH WHICH CAUSED TOOTH TO FRACTURE

STEPPED OFF LADDER ON LOADER & FELT BACK POP. PULLED LOWER BACK MUSCLE.

Ee stated he was swinging sledge hammer to break up rocks. On one swing he missed hitting the rock causing his body to twist oddly causing strain.

SCREEN CHANGE ON BOTTOM DECK. SPRAIN OCCURRED WHEN HE PUSHED UP WHILE LYING ON HIS BACK. NOTE: 10/17 (FRIDAY) - DOCTOR TOLD HIM TO REST OVER THE WEEKEND & RETURN FOR FOLLOW-UP ON TUES 10/21/03 . PRESCP. MEDS GIVEN, PUT ON RESTRICTED DUTY & PHYSICAL THERAPY ON 10/21/03.

NEITHER OPERATOR NOR LABORER FOLLOWED PROPER LOCK-OUT PROCEDURE WHICH LEAD TO UNIT ACTIVATING. INJURED EE WENT IN TO FEEDER TO CLEAR ROCKS. OPERATOR SAW LABORER CLIMB OUT & LEANED OVER TO YEL L AT LOADER OPERATOR ON RADIO NOT TO DROP BUCKET OF MATERIALS. AS HE LEANED OVER, OPERATOR HIT FEEDER BUTTON & LABORER FELL ONTO BELT.

EE STATES "COULD ONLY USE RIGHT HAND TO PULL HIMSELF UP ONTO THE TRUCK. PUT RIGHT FOOT IN STEP ON FUEL TANK, REACHED UP AND GRABBED BAR. AS HE WAS PULLING HIMSELF UP, HIS FOOT SLIPPED & HIS WHOLE BODY SHIFTEDTO THE RIGHT & HE FELL ACROSS THE FUEL TANK.

LOADING OUT PIT RUN, BANK COLLAPSED, NO ONE AT FAULT.

EE WAS GRADING ROADS. HE WAS LETTING THE BLADE DOWN & WHEN THE BLADE TOUCHED THE ROAD, THE CONTROL LEVER KICKED BACK CAUSING WRIST TO BE JAMMED.

A/C BLOWER FAN ON 988 LOADER WAS STUCK. EE PUT HAND IN TO SPIN THE FAN AND IT STARTED UP AND UPLLED HIS FINGERS INTO IT. THE SWITCH HAD BEEN LEFT IN THE "ON" POSITION BY MISTAKE.

EMPLOYEE WAS ADJUSTING TAIL ROLL AT CRUSHING SITE WHEN WRENCH GOT CAUGHT CAUSING FINGERS TO BE SMASHED.

FLYING ROCK STRUCK EE'S LEFT EYE. (FLEW OVER 50 FEET).

AS REPORTED BY EMPLOYEE (NEXT DAY, DID NOT REPORT TO SUPERVISORS OR WORKERS ON DATE OF ACCIDENT>

WAS HAMMERING A ROCK OUT OF A VGF FEEDER GRIZZLY BARS WHEN A PIECE OF METAL FLEW UP, AND HIT ARM, CUTTING IT ABOUT 1/2" LONG.

WAS PLACING A PIECE OF STEEL IN VGF FEEDER IT FELL AGAINST HIM AS IT WAS LOWERED IN TO PLACE.

WAS TRYING TO GET TRANSFER TRAILER TO TRANSFER INTO TRUCK. HE WAS HOLDING UP SOEM PART OF TAIL GATE, WHEN BOX HIT HIS HAND, AS IT.

WAS WORKING ON ELECTRICAL SYSTEM OF GENERATOR WHEN FELL AND HIT ARM ON BOLT EDGE AND CUT ARM.

WAS GETTING OFF D-9 DOZER AND SLIPPED AND FELL TO GROUND HITTING LEFT SIDE AND BACK ON SERVICE TRAILER.

WAS SHOVELING SAND FROM UNDER FEEDER AND BACK STARTED HURTING.

GETTING ROCK OU7 OF JAW AND ANOTHER ROCK SLIPPED AND HIT FINGER.

WAS WELDING & H9 KNOCKED THE TIP, TO KNOCK SLAG OFF & THE TORCH BACK FIRED & BURNED HAND.

LIFTED SCREEN T2 CARRY IT ON HIS BACK.

HAMMERING ON HE5D PULLEY SHAFT WHEN PIECE OF METAL FLEW INTO EYE.

CUTTING PIECE O0 STEEL PLATE LOOSE OFF OF HANGING SCREEN WITH TORCH AND WHEN IT CAME LOOSE IT FLEW OF AND HIT HIM IN THE FACE.