White River Pit: 145 citaciones de la MSHA Metal/Non-Metal

Employee States on 12/10/24 EE was walking across the parking lot, from the Haul Truck EE had been operating, to assist with repairs on a front-end loader, when EE slipped on ice and fell/twisted Right Knee. Employee Went to ER on 12/19/24, and reported the injury to management on 12/19/24.

Employee was cleaning up around main crushing plant with a skid steer. Went to dump the full skid steer bucket and a 7" rock fell out of the back of the bucket, striking the main frame of skid steer, and then fell into the cab, striking the employee's right knee cap.

Employee strained back while lifting / holding belting on a conveyor, as they were putting new belting on.

Employee stepped up on a 7" platform to check water level in the water tank, completed the check, and as EE stepped back, EE tripped and fell. EE tried to catch self when EE fell, resulting in a left distal fracture to EE's left wrist

Employee was cutting a conveyor belt with a utility knife, when the knife slipped and lacerated EE's left thumb, resulting in three stitches to the thumb.

Employee states on 6/15/20, while operating our haul truck, employee felt "muscle spasms", but continued doing job. On 6/22/20 employee went to the emergency room to get checked out after still experiencing muscle spasms in left ribs.

Employee was changing v-belt on a conveyor, as EE was attempting to roll new belt onto the pulley, EE's right index finger was pinched between the belt and pulley. Employee decided to have it checked out on 11/2/18 as the fingernail was showing bruising.

Employee was welding, or around welding operations, employee went home at the end of the day, and had trouble falling asleep that night due to eyes bothering EE, and went to hospital the following day(10/21) to have them looked at.

Employee States he was assisting with changing the screens on JCI screening plant, when he felt discomfort in his back.

Employee was changing a liner for a crusher, utilizing a hammer and chisel, when a piece of the chisel broke off, and embedded in the Right arm, requiring 3 stitches

A loader operator was feeding a portable screen plant, the loader operator dumped his load into the screen, and started backing up, not realizing another employee in a company pickup had pulled into the area. The loader operator did not see the company truck and backed into it. This resulted in the truck door receiving damage. No Injuries were sustained from this accident.

Employee was performing routine maintenence on crusher, pushing on piece of steel so that it could be bolted into place. Employee felt his back pop and experienced pain. Employee was transported to the emergency room by crusher foreman.

Employee was operating haul trk when he hit an obsticle in road, jarring the haul truck and causing the pulled muscle in lower back.

Employee was removing bucket from excavator, when pin that other employee was hammering out suddenly came out, crushing the tip of employee's middle finger, of his left hand.