Buscar en el registro

While installing chain hangers in beltline, employee felt a pinch in EE's neck. Continued to work until EE was taken off for treatment.

Employee reported eye irritation from contact behind eyeglasses with tie wire. They initially refused treatment and then sought treatment a few hours later.

Employee reports strain to lower back when lifting tools to/from service ride. Continued to work until taken off for treatment/evaluation.

While driving scoop in return, employee ran over block, causing them to jar their body. The pile measured 17" x 18" x 9" tall. They continued to work until October.

Installing cable bolts in Unit 1 and while pushing bolt up, felt pop in left arm/elbow. Employee continued to work until they were taken off later in the month.

While loading bolter tray, employee felt pop in shoulder.

Employee reported eye irritation after roof bolting and the following week they sought additional medical attention, resulting in a small piece of metal removed from their right eye.

Employee felt pop in left shoulder while lifting miner cable.

While recovering belt structure at XC 69-70 Belt Entry on last Pony, a top roller fell on the contractors right foot. This resulted in a fracture.

While worker on miner, the pry bar slipped in co-workers hand causing the shear jack cylinder to slip and strike the employees fingers between the cylinder and come-along chain. This resulted in a broken right index finger.

Employee reports numbness and pain in hands. They continued to work until surgery.

While putting the rub rail pin in with a hammer, the employee caught the edge of their hand with the hammer, which required 3 stitches.

Employee was a passenger in a mantrip. While on the ME travelway @ XC 76-77 they ran over an 8" rock, causing the employee to strike their hard hat on the canopy of the mantrip causing pain in neck and top of head.

Employee reported numbness in right hand. They continued to work until surgery in August.

An area light for the continuous miner slipped out of a maintenance co-workers hand and struck this employee's left hand.

Employee reported EE's hands going numb and problems with elbows. EE continued to work until EE had surgery.

Employee felt pull in right shoulder when pulling drill steel out of roof in Unit 1 (39+60 12 R)

A roof bolter was putting glue and bolt in hole they had drilled in Unit 2, Entry 6 @ 24+60 when a piece of rock fell. This resulted in a small laceration between lip and nose that received stitches.

While walking to battery charger un Unit 2 Battery Barn XC 122 2nd Outby charger, employee tripped and fell on their right side. This resulted in 2 broken ribs.

Examiner stepped and twisted knee while walking to sign board at #2 PC (next to left side on U2 PC)

While working as a miner operator, employee reports numbness in both right and left hands up to elbows and, at times, in fingertips. Employee continued to work until January 28th.

While working as a ram car driver employee experiences that wrists and elbows hurt/have numbness. They continued to work until 1/30/2026.

Originally reported at early date, continued pain/numbness/strain. Continued to work until taken off for surgery in September 2026.

While roof bolting in 3L, employee was hitting a clogged drill steel when EE felt pain in EE's right shoulder blade. EE continued to work until EE was taken off work later in November.

While pulling down exhaust curtain with their left hand in Unit 1, Entry 12, 44+40 - 45+00. In doing so, a section of rock fell out, striking the contractor on their head and left side.

While lifting a belt crossover to back on it's legs it slipped. This caused the employee to jam their arm/elbow into the crossover legs/skirt boards on the pony drive in Unit 3.

Employee reported occasional tingling in wrists and hands. EE continued to work until surgery on 1/5/2026.

Employee reports hands going numb and tingling when performing work.

Employee was unloading a box of SCSR's off the back of a Kubota when it slipped. Employee heard pop in left arm around elbow area and felt pain/numbness. Employee continued to work until surgery on 10/31/2025.

Employee reported intermittent pain with overhead work.

While passenger in mantrip leaving Unit 1, they hit a hole causing employee to pop up and land on hammer in tool belt, striking the lower right side of back.

While carrying belt structure, employee felt pain in right arm. They tripped while carrying a top roller and felt pop in right elbow/forearm area.

An employee was bent over working on suction line when a piece of rock fell out between bolts in Unit 1, Entry 4 at 18+61, striking the employee on the lower back.

When the employee was tramming the roof bolter past the intersection in Unit 2, Entry 4 @ 8+40 to pick up hog panel, the employee bumped EE's right arm on the ATRS.

Employee felt pain in lower abdomen when loading trash and pallets in the dumpster in Unit 3.

Contractor strained shoulder while pulling down curtain in Unit 3, entry 11.

Employee reported an occupational illness prior to shift start. They continued to work until they went out for surgery the following month.

After cutting bands on a stack of curtain boards outby U2, xc 108, supply entry 5, some boards fell on the employees leg, causing a strain and small abrasion to the outer side of their left knee.

While pulling down curtain employee felt pop in upper right arm/shoulder.

While stacking a box of miner bits on supply tractor, employee felt a pop in upper arm by right shoulder.

When turning to speak with supervisor, employee bumped their mouth on the canopy of the roof bolter.

Employee changing out link on conveyor chain in Unit 4, Entry 10. While driving link back together a small piece of metal chipped off and imbedded in upper thigh. It was removed and stitched closed.

Ram car driver in Unit 1, #10 entry 29+40 between XC 29+40 - 30+00 reached out of the ram car to get drops out of the way to better see miner operator and caught middle and ring finger of right hand between the rib and canopy of the ram car.

Struck in mouth by a steel for boring holes in 2x4. After finishing making a hole in 2x4, when removing steel, employee punched self in the face with steel, resulting in a chipped front tooth.

While walking around maintenance sled employee stated they tripped and tried to catch themself then stepped in a hole at the same time. Felt sharp pain in shoulder.

Employee was shoveling on the 1ME belt at XC35 when they felt a sharp pain in the lower right abdomen.

Employee slipped on ladder while taking down drops in Unit 1 for a belt and power move. EE was using a 4' ladder and stepped on the 3rd step when EE slipped. EE landed on EE's left foot and stated EE rolled EE's foot and twisted EE's left knee.

Employee was pulling down on a piece of curtain attached to hog panel. They fell to the ground on their right shoulder.

While roof bolter was hanging cable in Entry 10 XC in Unit 3, a cable reel from 416 RB struck the employee, causing employee to fall down.

Employee had just finished drilling top steel, and inserted bottom steel into the top steel, started bringing the pod (pot) to the bottom steel and missed inserting into the pod, causing the steel to flex away and pop back to their hand. This resulted in a small break at base of thumb.