Buscar en el registro

Caught hand between 150 pound hammer and cone nut wrench.

Moving large rock with loader & log chain. Chain broke hitting man in knee

Employee was replacing adhesive belt lagging on conveyor head. Pulley caught arm and pulled employee. Injury was right side of face and right arm.

Years of driving cause of numbness w hand carpal tunnel syndrome.

Dismounting excavator slipped off step had hold of hand hold pulled shoulder

EE was tightening bolt, the bolt broke and the EE dropped the wrench on his hand.

Using hydralic ram to pull gear box off head pully, jack slipped off shaft, striking worker on shoulder/chest area. Caused small cut and bruising on shoulder/chest area.

EE was helping do ground fault check on plant, turned to step off walkway, twisted knee.

Removing logs from new stockpile site slipped on loose dirt and fell.

Employee was checking for air leak on left rear when plunger moved to set position lacerating right index finger.

WAS HIT IN FACE WITH FLY ROCK UNDER RIGHT EYE SMALL CUT ON FACE COMPLAINED OF EYE DISCOMFORT WENT TO DOCTOR.

BIG ROCKS IN ROCK PILE EE WAS PICKING UP THE BIGROCKS OUT OF PILE: SLIPPED ON ROCK & WENT DOWN ON PILE HIT HIS SHOULDER ON PILE OF ROCKS

CAT WALK WAS WET, SLIPPED AND HIT HIS LEG, CUTTING HIS RIGHT SHIN.

LOADING SHOT ROCK WITH A 980 F FRONT END LOADER WHEN OPERATOR HIT A LEDGE IN THE FLOOR THAT WAS COVERED UP WITH ROCK WHICH CAUSED LOADER TO COME TO A VERY HARD STOP WHICH JAMMED OPERATOR'S LOW ER BACK.

HE HAS BEEN DIAGNOSED WITH SILICOSIS WHICH IS A DEGENERATING LUNG DISEASE WHICH OCCURRED AND WORSENED OVER A PERIOD OF TIME RUNNING GRAVEL PLANT.

CLAIMANT HAS BEEN DIAGNOSED WITH SILICOSIS WHICHIS A DEGENERATING LUNG DISEASE. ONSET 12/09/81 AT DIFFERENT LOCATION GRAVEL PLANT (DISCONTINUED

ALLEGES STRAIN TO BACK AND WRIST RUNNING BACKHOE.

GETTING OUT OF EUC HIS FOOT SLIPPED AND FELL HURTING HIS BACK.

ATTEMPTING TO START A SLIPPING BELT. EMPLOYEE GRABBED HOLD OF V-BELT CAUSING TENSION SO AS TO STOP IT FROM SLIPPING AND IT CAUGHT AND ROLLED HIS HAND AROUND THE MOTOR PULLEY. CUT ONE FINGER TI P OFF AND BADLY CUT AND BROKE 3 OTHER FINGERS.

GETTING ROCK OUT OF TAIL PULLEY WITH A BAR.

WRENCH SLIPPED OFF BOLT ON PLANT CAUSING EMPLOYEE TO FALL BACK ON BRACE POLE ON PLANT BUILDING. EMPLOYEE STATED THIS IS A REOCCURRANCE OF ACCIDENT A YEAR AGO. REPORTED TO ME ON 3-27-95 WASN'T REPORTABLE UNTIL 5-5-95.

LOADER OPERATOR STEPPED OFF LAST STEP OF LOADER ON TO GROUND LEVEL AND TWISTED KNEE. OPERATOR REPORTED ACCIDENT TO SUPERVISOR BUT FELT HE DIDN'T NEED MEDICAL ATTENTION BUT SIX WEEKS LATER DECI DED HE NEEDED TO BE SEEN BY A DOCTOR. SAW DOCTOR 3-29-94.

INJURED HAD UNLOADED 50# ANFO BAGS FROM AUSTIN TRUCK INTO TRAILER. FINISHED WAS GETTING OUT OF TRAILER ONTO TRUCK, SLIPPED ON WET TRAILER, STARTED TO FALL, CAUGHT HIMSELF BY HIS RIGHT HAND ON SIDE OF TRAILER.

I WAS REPLACING OXYGEN BOTTLE FOR CUTTING TORCH CARRY BOTTLE FROM PICKUP TRUCK TO DREDGE WHILE MOVING BOTTLE I SLIP & FELL DOWN THE BANK WITH BOTTLE HERNIATING 2 DISC IN MY BACK

GOT OUT OF TRUCK AND SLIPPED.

ACCIDENT HAPPENED WHEN LOADER OPERATOR TRIED MOVE FEED CONVEYOR BY HAND AFTER ORDER HAD BEEN GIVEN TO CRUSHER OPERATOR TO ENERGISE PLANT & MOVE CONVEYOR WITH MOTOR DRIVE NOT KNOWING LOADER OPE RATOR WAS IN AREA OF BELT. CAUSING TWO FINGERS ON LEFT HAND TO BE CUT IN DRIVE BELT.

THE EMPLOYEE WAS TIGHTENING BOLTS TO SECURE THE LID SHUT ON A WILLIAM HAMMER MILL AND THE WRENCH SLIPPED OFF OF THE BOLT HURTING HIS LOWER BACK.

LIFTING HEAVY PIECE OF METAL MASHED A DISC IN BAK PINCED NERVE SO 2 COULD NOT PUT WEIGHT ON LEFT LEG.

THE RALLAUTOR BILT RAN OFF THE PULLEYS AND I WAS ROLLING IT BACK.

WAS WORKING ON STOCKPILE TRUCK WHEN A PIECE OF STEEL STRUCK HIM IN THE EYE HE WAS UNABLE TO REMOVE THE STEEL HIMSELF & SOUGHT MEDICAL ATTENTION

DRIVING REDIMIX TRUCK OUT ON HIGHWAY AND TURNED IT OVER.

WELDING AND GOT STEEL IN EYE.

HIT HEAD ON OVERHEAD DOORS.

STEPPED OFF TRUCK TURNING HIS ANKLE.

WORKING BESIDE WELDER & BURNED EYES.

WELDING AND GOT PIECE OF STEEL IN EYE.