Buscar en el registro

Employee was removing a fuse from the panel, to check it. The fuse grounded to the panel and exploded. The panel was energized and the electrician was not wearing gloves. THIS EMPLOYEE WORKS AT THE CENTRAL SHOP BUT WAS INJURED AT CENTRAL SUPPLY.

While the electrician was checking a phase protector device, he accidentally touched & shorted 2 phases with his voltmeter. A contributing factor is the fact that he had not removed the alligator clips from the end of the probes. As a result, he got minor burns to his arms & face and loss some facial hair.

Was building concrete block wall over hoist drive cabinet. Dropped conduit through cable tray into circuit breaker cabinet landing across 2 phases of breaker causing an electrical arc which burned him.

While trouble shooting a power center, EE touched ice cube relay with screwdriver.

CIRCUIT STRUCK IN CLOSEDD POSIITON, EE PLUGGED UP AIR COMPRESSOR WITH SWITCH IN ON POSITION.

CIRCUIT STUCK IN CLOSED POSITION, EE PLUGGED UP AIR COMPRESSOR WITH SWITCH IN ON POSITION

EMPLOYEE WS TROUBLESHOOTING IN SWITCHGEAR ON #1 LONGWALL AND ENCOUNTERED 2300 VOLTS THAT FLASH BURNED HIS ARM RESULTING IN A SECOND DEGREE BURN.SKIN HAD TO BE DEBRIDED.

BREAKER ARCHED AND BURN HAND. 2ND DEGREE BURNS.

WHILE CHEKCING VOLTAGE ON BELT POWER CENTER, VOLTAGE METER BLEW UP BURNING HIS HANDS.

THUMPING TRAILING CABLE ON THE SHEARER, EE HAD ONE HAND ON A PHASE AND HIS LEG GROUNDED TO THE PANLINE, CAUSING ELECTRIC SHOCK.

APPARENTLY THE BATTERY CABLE GROUNDED AGAINST THE METAL JACKE TON TRANSMISSION HOSE AND BURNED A HOLE IN THE HOSE. THIS STARTED THE FIRE.

EMPLOYEE WAS TROUBLE SHOOTING THE POWER CENTER. HE WAS CHECKING THE BREAKER FOR THE MINER WHEN IT FLASHED UP, BURNING HIS HANDS.

EMPLOYEE WAS TROUBLE SHOOTING ON THE MINER WHEN HE CHECKED THE POWER LEADS WITH METER. AS HE DID, HE WAS SHOCKED. THE METER LEADS HAD A BAD PLACE IN THEM AND HE WAS NOT WEARING HIS RUBBER GLOVES. EMPLOYEES ACCIDENT WAS BEING QUESTIONED ABOUT TIME MISSED.

EE WAS REMOVING ELEPHANT BOLTS FROM THE PANLINE . HE LAID HIS ARM ACROSS THE PANLINE AND CAME IN CONTACT WITH A BARE CONDUCTOR OF THE PUMP CABLE. NOTE: EE HOSPITALIZED FOR OBSERVATION 1 DAY.

WHEN EMPLOYEE TURNED BREAKER ON FOR THE WELDING MACHINE, THE RECEPTICLE FLASHED, CAUSING ABURN TO EMPLOYEE'S RIGHT HAND.

EMPLOYEE WAS WORKING ON LONGWALL PUMPING STATION IN THE SURFACE SHOP. HE WAS ATTEMPTING TO CLEAR UP A PROBLEM WITH THE CONTROL CIRCUIT IN THE MAIN PANEL AND CAME IN CONTACT WITH AN ENERGIZED P ART OF A 575V CIRCUIT.

LEADS GOING TO ELECT MOTOR ON LOCOMOTIVE WERE GROUNDED & HAD BEEN BURNED EMPLOYEE REACHED DOWN TO SEPARATE LEADS BREAKER WAS OFF ONE LEAD GROUNDED AGAINST FRAME & BURNED HIS FINGER

EMPLOYEE WAS ATTEMPTING TO SET BREAKER TO VERSA TRAC CHARGER; COULD NOT GET IT SET, TOOK THE CHARGER PLUG AND ATTEMPTED TO PULG IT INTO THE RECEPTABCLE. WHEN EMPLOYEE WAS LOCKING PLUG INTO R ECEPTACLE, IT ARCHED CAUSING 3RD DEGREE BURNS TO HAND.

WHILE CHECKING VOLTAGE IN FEEDER METER BLEW UP.

WHEN EMPLOYEE TURNED THE BREAKER TO THE BATTERY CHARGER ON, THE POWER CENTER FLARED UP BURNING EMPLOYEE ON RIGHT HAND.

AFTER INSTALLING A NEW 325 AMP BREAKER ON THE POWER CENTER, WHEN THE BREAKER WAS TURNED ON, IT ARCED INSIDE AND FLAMES CAME OUT THE FRONT COVER, BURNING BOTH HAND AND LEGS.

WHILE HANGING UP MINER CABLE IN SAME HANGER WITH TRICKLE DUSTER CABLE EMPLOYEE'S HAND CAME INTO CONTACT WITH EXPOSED LEADS RESULTING IN ELECTRICAL SHOCK.

EMPLOYEE WAS PLUGGING UP A SMALL HOIST UNIT TO OPERATE. AS EMPLOYEE ALIGNED PLUG EITHER A PHASE TO PHASE CONNECTION OR A PHASE TO GROUND CONNECTION WAS MADE AND AN ELECTRIC ARC BURNED FINGER ON HIS LEFT HAND.

EMPLOYEE WAS OPERATING LOCOMOTIVE HE REACHED OVER THE TOP OF MACHNE & CAME IN CONTACT WITH BATTERY CABLES THE CABLES HAD INSULATION CUT OFF CABLE CAME IN CONTACT WITH THE FRAME OF MACHINE GROU NDED OUT & CAUGHT ON FIRE & DAUSED 2ND & 3RD DEGBURN TO LEFT FOREARM

DRIVING TROBLE SHOOTING POWER WAS REAPPLIED TO THE HOIST TO ALLOW VOLTAGE READINGS. TO BE TAKEN. INJURED WAS STANDING IN FRONT OF THE CONTROLS READING A VOLTMETOR WHEN ONE OF THE DOORS WAS B LOWN CLOSED BY THE INTERNAL COOLING FAN AND CONTACTED LIVE PARTS. THE RESULTING FLASH BURNED TO EMPLOYEES ELBOW.

CHECKING POWER ON MSAIN BREAKER IN BELT STA\TER. TOOK GLOVES OFF TO GET METER OUT OF CASE. BREAKER FLASHED UP AS HE WAS HOLDING METER LEADS ON POWER CON NECTIONS ON STARTER BREAKER.

INJURED WAS ATTEMPTING TO REPAIR A BUS CHARGING UNIT. HIS RIGHT HAND BECAME ENTANGLED WITH WIRING AND CONTACTED THE PRIMARY SIDE OF THE TRANSFOARMER LOCATED WITHIN THE CHARGER. THIS RESULTED IN APPROX. 380 VOLTS PASSING THROUGH HIS BODY.

EMPLOYEE WAS PULLING PLUG OUT OF RECEPTACLES ON RAM CA BATTERY AND THERE WAS AN ARCH WHICH BURNED EMPLOYEE LEFT HAND. IT WAS 2ND DEGREE BURN.

EMPLOYEE WAS CHECKING VOLTAGE ON CUTTER BREAKER HE CHECKED ON WRONG SIDE OF THE BREAKER & METER WAS ON WRONG SETTING IT SHORT ED 995V PHASE TO PHASE CAUSING A LARGE ELEC.ARC WHICH BURNED EMPL OYEES HANDS

WHILE CHANGING AMP & VOLTAGE GAUGE ON SCOOP CHARGER VICTIM RECEIVED ELECTRICAL BURNS DUE TO FAILING TO UNPLUG BATTERY LED FROM CHARGER.

EMPLOYEE WAS UN1LUGGING RAM CAR BATTERY AND PLUG GOT AGAINST BATTERY, CAUSING IT TO ARC RESULTING IN A BURN ON THE LEFT HAND. EMPLOYEE WAS VIOLATING SAFETY RULES BY NOT DE-ENERGIZING EQUIPMENT BEFORE UNPLUGG3NG EQUIPMENT.

EMP WAS ENGERIZ3NG START BUTTON ON A D.C. AIR COMPRESSOR. THE SWITCH WHEN PRESSED SHORTED CAUSING BURN TO THUMB

EMP WAS TAKING 5 BATTTERY OFF CHARGE WHEN THE CHARGER CABLE CAME INTO CONTACT WITH A TERMINAL CAUSING THE BATTERY TO BLOW ACID INTO HIS FACE AND EYES

THE #2 SHUTTLE 7AR ON #3 SECTION HAD PULLED ITS POWER CABLE IN TWO. EMPLOYEE IS AN ELECTRICIAN, AND HE WENT TO THE POWER CENTER TO DE-ENERGIZE THE CABLE. AT THE POWER CENTER HE FOUND TWO PLUGS . ONE WAS TAGGE8 #3 S/C, THE OTHER HAD NO TAG. EMPLOYEE ASSUMED THAT THE PLUG WITH NO TAG WAS FOR THE DISABLED #2 S/C, AND LOCKED THIS PLUG OUT. HE DID NOT TEST TO SEE IF LOCKING OUT THE PLUG

SUPEVISOR WAS T9OUBLE SHOOTING DEFECTIVE MOTOR MOTOR WAS GROUNDED RESULTING IN ELECTRICAL BURN

AS A 225 AMP BR9AKER SERVING THE LEE NORSE BOLTER WAS SET THE B REAKER BLEW CAUSING 2ND DEGREE BURNS TO RIGHT HAND.

HE WAS CHECKING BREAKING ON POWER CENTER WHEN IT ARCED AND BURNED BOTH HANDS.

EMPLOYEE WAS CHANGING BATTERIES ON A MOTOR. AS HE WAS CONNECTING THE LEADS, ONE GOT GROUNDED AGAINST THE FRAME OF THE MOTOR. THE ARC BURNED HIS RIGHT ARM AND HAND.

EMP WAS WORKING ON BLOWN MINER CABLE - HE WENT TO POWER CENTER TO SEE IF BREAKER WAS OFF - HE RETURNED TO WORK ON CABLE - HE WAS HOLDING CABLE & WAS CUTTING OUTER JACKET OFF CABLE HE ATTEMPTED TO SEPARATE LEADS & CABLE FIRED UP AGAIN

EMPLOYEE STATES HE WAS CHECKING A BATTERY WITH TEST METER WHEN HE GOT A LEAD AGAINST METAL FRAME & GROUNDED BATTERY CAUSING ELECTRICAL ARC BURNING HIS FINGERS ON HIS RIGHT HAND

EMPLOYEE WAS WORKING ON ELECTRICAL PANEL ON AIR COMPRESSOR WHEN A SCREWDRIVER ARC BURNED BOTH EYES.

EE WAS CHECKING LEADS ON BATTERY CHARGER WHEN THE BATTERY CAUGHT FIRE IN THE BREAKER BOX.

BREAKER ON POWER CENTER FOR UN-A-TRAC WAS GROUNDED. WHEN EMPLOYEE ATTEMPTED TO UNPLUG IT, IT FIRED UP BURNING HIS LEFT HAND

EE WAS ATEEMPTING TO HOOK UP SECONDARY SIDE OF 4160/480V TRANSFORMER BANK FROM BOOM OF AUGER TRUCK. LINE FUSES WERE PULLED & TRANSFORMER DE-ENERGIZED. EE MOVED POSITION & IN DOING SO ELEVATED HIMSELF TO A LEVEL OF CONTACT W/ ENERGIZED SIDE OF LINE FUSES. IN AN ATTEMPT TO FREE HIMSELF OF ELECTRICAL CONTACT HE LOST BALANCE & FELL APPROX 12\ TO GROUND.

WHILE WORKING ON A RAM CAR BATTERY CHARGE THE PLUG WAS TAGGED OAT AT PWOER CENTER, BUT CHARGER WAS NOT UNPLUGGED FROM BATTERY. HE REACHED INSIDE CHARGE AND HIS WATCHBAND GROUND OUT ACROSS THE LEADS ON THE AMPMETER BURNING HIS WRIST.

EMPLOYEE PUT JUMPERS ON RECPT. & PLUG, WHEN HE SET BREAKER THE BREAKER FLASHED UP BURNING BOTH HANDS.

WHILE CHECKING PHASE TO GROUND ON POWER CENTER 1ST & 2ND DEGREE BURNS TO HANDS

EMP WAS SETTING BREAKER UP ON RAM CAR CHARGER. WHEN EMP ENERGIZED BREAKER PLUG BLEW UP IN FACE CAUSING FIRST DEGREE BURNS ON RIGHT ARM AND FACE

WHILE REPLACING POWER BOARD ON LOCOMOTIVE BRAKE CAR WITH TROLLEY POLE CONNECTED TO TROLLEY WIRE,ELECTRICAL FLASH OCCURRED CAUSING BURN.

EE STATES THAT HE WAS TAKING A BATTERY OUT OF THE MOTOR & THE BATTERY FRAME GOT INTO A LEAD & CAUSED IT TO SHORT OUT & BURN INTO. WHEN IT FLAMED IT BURNT HIS RIGHT HAND.