Buscar en el registro

Miner step on a hoe which came forward and struck them in the left elbow. Miner complains of soreness of the left elbow.

EE WAS SWEEPING, REMOVING DIRT FROM UNDER TABLE WITH A BROOM, WHEN HE FELT SOMETHING IN HIS EYE.

KNOCKER WRENCH FELL FROM LEDGE OF EXPADSHION JOINT AND DOWN ONTO TOP OF FOOT.

EMPLOYEE WAS USING A PIPE WRENCH & STRAINED HIS BACK. EMPLOYEE DID NOT REPORT INCIDENT TO SUPERVISOR UNTIL 7/25/00 & DID NOT REQUEST TREATMENT UNTIL 7/28/00.

USING A WRENCH TO TIGHTEN BOLTS. THE WRENCH SLIPPED, CUTTING HIS RIGHT RING FINGER.

EE WAS USING A WRENCH WHEN IT SLIPPED AND HIS HAND HIT A PIECE OF SHEET METAL WHICH CUT HIS RIGHT INDEX FINGER.

EE WAS CLEANING HOPPER WITH A ROD WHEN THE MATERIAL SHIFTED AND HE HIT HIS RIBS ALONG THE HANDRAIL.

EE WAS SPLICING A BELT (CONVEYOR) AND FELT HIS RIGHT SHOULDER POP

EMPLOYEE WAS STRIPPING WIRE WITH A POCKET KNIFE HOLDING CABLE WITH LEFT HAND RIGHT HAND SLIPPED CUTTING LEFT PALM.

ADJUSTING GRATING ON TOP OF GRIZZLEY WHEN HAND WAS STRUCK BY OTHER EMPLOYEE WITH A HAMMER

EMPLOYEE WAS CLEANING SUBMERGED CHAIN CONVEYOR BOTTOM OF BOILER, STANDING ON FLOOR HOLDING LADDER, WHILE COWORKER ON LADDER WAS HAMMERING ON BOILER TO LOOSEN MATERIAL. SUDDEN DISLODGE OF MATER IAL CAME DOWN. IMMENSE CLOUD OF LIME DUST/WATER ENGULFING EMPLOYEE. EMPLOYEE WAS WEARING ALL REQUIRED SAFETY GEAR.

EMPLOYEE WAS CLEANING SUBMERGED CHAIN CONVEYOR BOTTOM OF BOILER, STANDING ON LADDER USING HAMMER BANGING ON THE SIDE OF THE BOILER TO LOOSEN MATERIAL ON TRANSITION CHUTE. SUDDEN DISCHARGE OF M ATERIAL CAME DOWN CAUSING IMMENSE CLOUD OF LIME.LIME/LIME WATER ENGULFED EMPLOYEE. EMPLOYEE WAS WEARING ALL REQUIRED SAFETY GEAR.

WORKER WAS CLIPPING OF WELD WHEN A SMALL PIECE OF METAL HIT HIS ARM AND BECAME IMBEDED IN HIS RIGHT FORARM.

HOLDING A PRYBAR ON A CHAIN WHEN THE CHAIN BROKE & HIT THE EMPLOYEES FINGER

EMPLOYEE WAS CUTTING TAPE FROM A VACUUM HOSE WHEN THE KNIFE SLIPPED, CUTTING HIM ON THE FOREARM. INJURY BECAME INFECTED ON 3-6-89 AND WAS UNABLE TO WORK.

PRYING PC OF STEEL FORM CYCLONE WHEN IT CAME LOOSE PINCHED THUMB AGAISNT PC OF ANGLE IRON CUTTING TENDON IN HIS THUMB

EMPLOYEE WAS DRIVING A BEARING RACE OFF WITH A HARD FACED HAMMER THE BEARING RACE SPLIT AND A PIECE OF IT FLEW OFF AND IMBEDDED IN HIS ARM

EMPLOYEE WAS UTILIZING A CHIPPING HAMMER AS A DRIFT PIN TO LINE UP A BOLT HOLE ON A COVER PLATE HE STRUCK THE CHIPPING HAMMER WITH A BALLPEEN HAMMER WHICH CAUSED THE WEDGE END OF THE CHIPPING HAMMER TO FRAGMENT OFF AND IMBEDD IN HIS LEFT FOREARM

EMPLOYEE WAS STRIPPING ELECTRICAL CABLE WITH A POCKET KNIFE. HIS STROKES WERE TOWARD HIS LEFT HAND WHICH WAS HOLDING THE CABLE. UPON HIS LAST STROKE, THE KNIFE CAME INTO CONTACT WITH HIS LEFT THUMB THUS CAUSING THE LACERATION.

WAS WORKING WITH CHAIN WHEN IT JERKED AND PULLED HIS SPINE AND CHEST WALL.

HITTING WEDGES 4ITH HAMMER TO BREAK STONE WHEN WEDGE BROKE STRIKING EMPL ON LOWER LEG.WEDGE WAS 12''LONG X 1''DIA.

USING RATCHET W9ENCH REASSEMBLING PUMP CASING-FELT PAIN IN RIGHT SHOULDER.

THE EMPLOYEE WA8 STANDING BELOW AND TO THE SIDE OF A BURNER PIPE FOR A KILN THAT WAS BEING LOWERED TO THE GROUND FOR REPAIRS. THE HOISTING DEVICE/COME-A-LONG FAILED TO HOLD THE LOAD AND THE PI PE FELL TO THE 1ROUND STRIKING THE EMPLOYEE ON THE LEFT SHOULDER AND RIB AREA.

THE DRAGLINE OP9RATOR HAD A PISTOL ON THE DRAGLINE IT ACCIDENTLY WENT OFF AND HIT THE OILER IN THE LEG

EMPLOYEE WAS CH5NGING SCREENS ON TOP OF THE PLANT, AND THE BAR SLIPPED AND FELL ON HIS THUMB.

EMPLOYEE WAS ON TOP OF DRAGLINE ADJUSTING DRAG BRAKES THE WRENCH HE WAS USING SLIPPED AND EMPLOYEE FELL FROM THGE TOP OF DRAGLINE AND LANDED ON THE DRAGLINE TRACK ON HIS BACK