Buscar en el registro

Associate took a bar to close the bottom gate of a rail car and associate felt a tinge in their back. Stopped what they were doing and asked another associate to close the gate on the car.

Splicing a belt on the McCloskey. Associate was cutting the belt to splice it and the knife slipped and the associate cut the pointer finger on left hand.

Lifting a chain fall from floor grating, chain got stuck in the grating when pulling up and associate felt pain in their right elbow. Right elbow was sprained or strained.

Changing out face shield from clear to tinted using a leatherman multitool knife to pry it off. The blade wasn't locked open so it flipped shut causing a laceration on little finger of left hand.

Changing the head section of the telestacker, associate was tightening a bolt, the wrench slipped off the bolt and caused the associate to hit right elbow against the side of the head section.

Associate was cutting a rubber hose and knife slipped and cut palm on left hand. 1 cm laceration to left palm. Received stitches and tetanus shot.

Finger pinched between steel and crescent wrench. Pushing on the wrench and EE was pushing on the wrench. Trying to tighten the belt on the conveyor.

Miner was using a ¾ inch ratchet to operate a gate on the S3 structure. When the miner pushed down on the ratchet, their pinky finger was around the end of the ratchet handle and the ratchet slipped out of the modified shaft end causing their finger to be caught between the guard and the handle.

The miner was using a Leatherman to cut plastic pipe. The Leatherman slipped and cut the inside of the miner's left thigh. The miner received a cut resulting in five stitches.

Associate was washing his dump truck with a water hose and brush. Bent or twisted wrong and felt a pain in his lower back.

Associate was removing the tip assembly from the 988H loader bucket. Associate was using a 2 pound hammer and pry bar. Part of the tip assembly broke and hit the associate's left forearm.

Associate was removing a short piece of hose off a barbed end on a floc skid. He was using a utility knife to cut the hose loose from the barb, and the knife slipped and cut his finger.

The associate was using an utility knife to remove the outer coating of an electrical cable. The knife slipped and it cut his left index finger.

Associate was using a 3"x3"x8' long post to pry over an 8 inch plastic pipe line in soft muddy conditions when he hit his finger on the clamp of the pipe when jamming the post under the pipe.

ASSOCIATES WERE PRYING ON A BEARING IN AN ATTEMPT TO MOVE IT FAR ENOUGH ALONG SHAFT GOT GET A PULLER ON IT. WHILE PRYING THE BEARING MOVED FUTHER THAN EXPECTED & THE ASSOCIATES RIGHT LITTLE FI NGER WAS PINCHED BETWEEN THE BAR (LEVER) & ANOTHER PIECE OF STEEL

EE CUT HIS LEFT HAND WHEN CUTTING OFF TAPE ON ELECRIC WIRES TO MOTOR.

WHILE OPENING THE BOTTOM DOOR OF A RAIL CAR FOR CLEANING THE BAR USED TO OPEN THE DOOR SLIPPED AND HIT LEFT KNEE CAUSING A DEEP BRUISE.

EMPLOYEE WAS CLEANING OUT THE HOPPERS IN THE PIT TUNNEL. HE WAS USING A LARGE SLEDGE HAMMER TO RAP ON THE CHUTE TO GET THE SAND TO DROP (NORMAL PROCEDURE). HE HAD TO CONTINUE THIS FOR SOME TI ME TO GET THE SAND TO DROP ON BOTH THE EAST AND MIDDLE HOPPERS. HE FELT A SHARP PAIN UNDER RIGHTSHOULDER BLADE. EMPLOYEE REPORTED THIS ON 10-28-97. ON NOV. 11 HE SAW DR: MEDICATION & REEVALUAT

EE WAS WORKING ON THE PIPELINE TO UNPLUG THE +30 STOCKPILE PIPE LINE. AS HE WAS REMOVING THE BOLTS, THE PIPE FLANGE JUMPED UP & HIT HIM NEAR HIS RIGHT EYE CAUSING A DEEP INCISION. HE RECEIVED SEVERAL STITCHES. THE TENSION IN THE PLASTIC PIPELINE CAUSED IT TO PULL BACK ENOUGH TO BE ABLE TO PULL UP.

BOLTS ARE TIGHTENED TO 150 LBX OF TORQUE. EE WAS ATTEMTING TO LOOSEN BOLTS WHEN HE FELT THE PULL TO LOWER GROIN AREA. PLEASE REFER BACK TO THE 70001 FORM DATED 8-26-95. HE RETURNED TO WORK ON 9-25-95, WHICH RESULTED IN 12 LOST DAYS. THE DRFELT THIS STRAIN RESULTED FROM THIS PREVIOUS INJURY.

EMPLOYEE CUT DOWN #1 TREE WHICH FELL BACKWARD ONTO A STANDING TREE. EMPLOYEE LEFT TREE #1 AND CUT DOWN TREE #2 WHICH FELL TO THE GROUND WITHOUT INCIDENT. EMPLOYEE STARTED TO REMOVE THE LIMBS F ROM TREE #2 AND WHILE DOING SO WIND CAUSED TREE #1 TO MOVE OFF IT'S PERCH AND FALL TO THE GROUND AND ONTO EMPLOYEE.

INJURED WAS USING A CHAIN AND COME ALONG ON A PIPE. AS THE PIPE MOVED, IT DRAGGED THE COME A LONG ACROSS THE TOP OF INJURED'S FOOT.

INJURED WAS POUNDING WITH A HAMMER ONTHE BACK OF SAND HOPPER TO HELP LOOSEN UP FROZEN SAND. ON THE BACK-SWING, HE HIT HIS FOREFINGER ON AN ANGLE IRON. IT BCAME SWOLLEN AND STIFF. FINGER EVE NTUALLY BECAME INFECTED AND NEEDED MEDICAL ATT .

INJURED WAS REMOVING SHRINKWRAP FROM A CHECKVALVE WITH A JACKKNIFE, THE KNIFE SLIPPED CAUSING A INCH CUT IN HIS RIGHT LEG, HE RECEIVED TWO STITCHES.

HE WAS ATTEMPTING TO CUT RUBBER CHANNELS WITH A UTILITY KNIFE FOR A BACKUP SCREEN SURFACE THAT PROTECTS THE PIONEER VIBRATING SCREENS. THE KNIFE SLIPPED LACERATING HIS LEFT INDEX FINGER CAUSIN G HIM TO RECEIVE 3 STITCHES. HE IS NOW ON ALTERNATE DUTY- NO LOST TIME.

AS I NAME WAS IN THE PROCESS OF DISASSEDMBLING A METAL CEMENT FORM ON A FIVEFOOT REFRACTOR THE FORM RELEASED & THE EDGE OF THE FORM CUT I NAME RT EAR CAUSING SIX STITCHES

WE WERE CHANGING A SHEAVE ON THE TOP MOTOR ON THE PRODUCT TANK. A PIPE WAS USED TO HOLD THE MOTOR UP WHILE I,NAME WAS ADJUSTING A 2 1/2" NUT ON THE MOTOR TIGHTER. THE PIPE SLIPPED AND THE MOTO R MOUNT PLATE FELL DOWN PINCHING AND MAKING A LACERATION TO HIS PALM BELOW HIS LITTLE FINGER OF HIS LEFT HAND.

I.NAME INSIDE CRUSHER JAW-SPACE TRYING TO BREAK LARGE ROCK PLUGGING CRUSHER.USING MAUL,ON DOWN SWING,END OF MAUL HANDLE STRUCK LEFT ANKLE.HANDLE AS SINCE BEEN SHORTENED TO PREVENT THIS.

I.NAME WAS PULL3NG HARD ON A WRTENCH WHEN HE FELT A DISCOMFORTING PAIN IN HIS BACK