Buscar en el registro

The employee was attempting to change the cartridge in a grease gun, and when EE went to pull the plunger back, EE felt a pop in EE's shoulder.

The employee was attempting to hook up a come-along under the feeder belt when it came unhooked and hit EE in the head.

The employee was performing service on an F-450 pickup truck, and when lowering the jack, the vehicle rolled over the employee's left foot, causing a small fracture to EE's toe.

The employee struck their finger on a piece of steel while shoveling.

Employee was tightening a bolt on a tail pulley and once EE was done, EE noticed mild pain in right shoulder. Incident was not reported to EE's supervisor until the following week. Diagnosed with right shoulder strain and given restrictions.

Employee was was working on a final drive (mobile equipment). Employee struck the housing to loosen it. A shard of metal broke off striking employee's right shin.

Employee was tightening a bolt on Crusher 2 (CR2) with a torque wrench and torque multiplier. After tightening bolt, the torque multiplier came loose and dropped. Employee reacted by attempting to catch the multiplier. The multiplier jammed employee's left hand.

Employee (mechanic) was changing cutting edge on 982M loader. Edge was on the forks of telehandler and employee was prying up edge with a bar to get the right side up. When the edge started to go over employee reached out to grab the edge to keep it from falling and felt a pull in EE's back. Reported immediately, but did not seek treatment until next day 3/21/23.

Employee was swinging a sledge hammer and struck a sharp edge on the catwalk.

Employee was pulling a piece of steel out with a come along to divert a material when the steel plate tilted and caught employee's left hand between steel and angle iron. Employee fractured left metacarpal shaft in hand.

Employee was cutting a piece of rib rubber for the MGL screen when ee inadvertently lacerated left forearm about 3 inches above wrist with utility knife. Employee received 6 internal stitches and 3 external stitches. Released back to full duty with no restrictions on same day as injury.

Employee was using a pry bar to unjam a rock from the lump kicker. The pry bar kicked back and struck him in the right side of his face causing a facial fracture.

Employee was using a sledge hammer to bend a 1/2 piece of steel. While swinging the hammer he crushed his left little finger between the wooden handle and the sand screw. Injury was an open fracture to the left little finger requiring stitches and splinting.

Employee was cutting the rubber cap off end of new electrical wire when utility knife slipped and cut his left arm above the elbow requiring stitches.

Employee was cleaning under counterweight with a shovel, when his knee gave out.

Employee was using a pry bar to dig clay out of the feeder when the pry bar gave way and smashed employees finger. Contusion to left middle finger.

Employee was using a hammer to dislodge rock from the grizzly when he developed discomfort in his left elbow. Diagnosed with an elbow strain.

EMPLOYEE WAS USING A UTILITY RAZOR KNIFE TO CUT A 1/4" CONVEYOR BELT, WHEN KNIFE SLIPPED AND SLICED HIS LEFT HAND REQUIRING STITCHES.

EE WAS USING A COME-ALONG TO MANUALLY PULL THE BEETLE DRILL [B-1] ONTO THE TRAILER [T-4] BECAUSEOF A MECHANICAL PROBLEM WITH THE DRILL. AT THE TIME EE WAS UNAWARE THAT HE HAD PULLED A MUSCLE I N HIS BACK. EACH DAY, HOWEVER, THE PAIN IN THE LOWER BACK INCREASED-ESPECIALLY WHEN HE WAS RIDING IN THE COMPRESSOR TRUCK [C-1] & EASED WHEN STANDING. ON 11/22/95 PAIN FORCE HIM TO SEEK TREAT

CUTTING WITH KNIFE IT SLIPPED PUNCTURED L FOREARM

USING PRY BAR. AT SAND CONVEYOR, BAR SLIPPED, SMASHED TIP OF PINKY FINGER LEFT HAND.

HELPING FELLOW EMPLOYEE TO REMOVE BEARING OTHER EMPLOYEE WAS USING HAMMER METAL FLEW FROM HAMMER LODGED IN LEFT EYE METAL REMAINED IN EYE FOR ABOUT A WEEK BEFORE EMPLOYEE SOUGHT MEDICAL TREATM ENT ON 01-15-91

UTILITY KNEE CUT PC OF RUBBER CUT PINKY FINGER ON L HAND

CUTTING BOARD WITH UTILITY KNIFE KNIFE SLIPPED CLACERATING L THUMB

HELPING TO LOOSEN LOCKING NUT ON BEARING .EMPLOYEE WAS SWINGING SLEDGE HAMMER-AND HIT FINGER ON PIECE OF ANGLE IRON.

SCRAPING OUT HOPPER THAT FEED SAND PLANT. USING LONG PIECE OF ANGLE IRON TO UNSTICK HOPPER.

CUTTING TAG OFF3HOSE-KNIFE SLIPPED-CUTTING LEFT FOREARM LACERRATION OF LEFT FOREARM

CHANGING BUCKET3TEETH ON LOADER-USING HAMMER-SPRAINED LEFT WRIST.

MOVING SHOVEL F9OM ONE LOCATION TO ANOTHER-DROPPED SHOVEL ON LEFT FOOT-BRUISED LEFT FOOT

WORKING ON LOAD9R-HIT LEFT HAND WITH HAMMER.

CHANGING ROLLER8 ON CONVEYOR SYSTEM AT SAND PLANT USING HAMMER TO KNOCK PINS OUT PIN BROKE HITTING GLASSES GLASSES BROKE CUTTING LEFT EYE LID AND CAUSING HIM TO GET SLIVERS OF GLASS IN HIS EYE

WORKING ON TAIL PULLEY OF SAND CONVEYOR TRYING TO PUT BEARINGS THAT HAD MOVED BACK INTO PLACE USING PRYBAR BAR SLIPPED STRIKING EMP ON NOSE BREADKING NOSE

CHANGING ON ROLLER BAR-ON CONVEYOR SYSTEM-AT SAND PLANT-LIFTING WITH BAR-BAR SLIPPED-CATCHING LITTLE FINGER OF RIGHT HAND CAUSING DEEP LACERATION-& CRUSHING OF LITTLE FINGER.

EE WAS WORKING AT CRUSHER IN STONE QUARRY A REPAIRING HOLE IN CRUSHER HAD PUT PLATE OVER HOLE WELDING WAS USING CHIPPING HAMMER PIECE OF RUST FLEW FROM METAL INTO LEFT EYE.

TRYING TO HAMMER BEARING RACE FROM SPEED REDUCER WITH HAMMER END OF DRIFT PIN BROKE PIECE OF METAL FROM DRIFT PIN WENT INTO RIGHT ARM