Buscar en el registro

EE WAS WORKING UNDER THE FLOOR PLATE OF A D11 DOZER, BREAKING A FITTING LOOSE ON THE HYDRAULIC CONTROL VALVE. WHEN THE FITTING BROKE LOOSE, HIS HEAD HIT A CLIP HOLDING AN ELECTRICAL CONNECTION , CUTTING THE BACK OF HIS HEAD. HE WENT TO THE ER ABD 3 STAPLES WERE USED TO CLOSE THE LACERATION. THE COMPANY WAS NOT AWARE THAT THE EMPLOYEE RECEIVED STAPLES UNTIL 3/5/01.

EE WAS PUTTING RAILS ON THE BUCKETWHEEL CONVEYOR SYSTEM. HE WAS HOLDING A PIN WITH ONE HAND & HITTING IT WITH THE OTHER. THE HAND HOLDING THE PIN SLIPPED DOWN AS HE WAS SWINGING, THE PIN TURNE D AND HE HIT HIS FINGER CUTTING IT. 4 STITCHES.

EE WAS GOUGING KEEPERS OFF OF A DRAGLINE BUCKET. A BALL OF HOT METAL GOT INTO A CREASE OF HIS JEANS, BURNED THROUGH AND FELL INTO HIS BOOT, BURNING HIS LEFT FOOT. THE BURN GOT INFECTED AND HE WAS TREATED FOR THE INFECTION.

EE WAS PUTTING A STARTER ON D907. HE HAD BEEN BRUSHING DIRT OFF THE EQUALIZER BAR & GOT DIRT IN HIS EYE. HE WASHED HIS EYE OUT BUT IT CONTINUED TO ITCH. HE REPORTED THIS ON 9-23-99 & WENT TO T HE EMERGENCY ROOM & THEY WASHED IT OUT. ON 9-24-99, HE SAW A SPECIALIST. HE WAS GIVEN A PRESCRIPTION FOR TOBRADEX EYE DROPS.

EE WAS HITTING A BUCKETWHEEL ROLLER (ONE ON A SHIFTING HEAD) WITH A 3 LB HAMMER. (HE WAS IN THE SHOP). A PIECE OF METAL CAME OFF THE ROLLER AND HIT HIM IN THE CHEST. THE DR AT THE ER MADE AN I NCISION (APPROX 1/4") TO TRY TO REMOVE IT. HE DID NOT REMOVE THE PIECE OF METAL AND DID NOT STITCH UP THE WOUND.

EMPLOYEE WAS REMOVING A TOOTH ADAPTOR TO INSTALLA NEW ONE. WHILE TRYING TO BEAT THE ADAPTOR OFF WITH A SLEDGE HAMMER, A PIECE OF STEEL FLEW OFF THE ADAPTOR AND LODGED IN HIS LEFT FOREARM. EMPL OYEE WAS SEEN AT THE E.R., WHERE HE RECEIVED A FEW STITCHES. ON 02/19/99, THE PIECE OF METAL WASSURGICALLY REMOVED.

EE WAS USING A POCKETKNIFE TO CUT A PLASTIC TIE WRAP OFF OF SEVERAL HYDRAULIC HOSES WHICH WERE WRAPPED TOGETHER. INSTEAD OF CUTTING AWAY FROM HIMSELF, HE CUT TOWARD HIMSELF AND AFTER CUTTING T HE TIE WRAP, ALSO PUNCTURED HIS LEFT LOWER ARM. TWO STITCHES WERE REQUIRED.

EE WAS WORKING ON A DOZER IN THE SHOP. HE WAS USING A 10 LBS SLEDGE HAMMER TO DRIVE BOGIE PINS OUT. THE HAMMER SLIPPED AND HE MISSED THE PIN. HIS FINGER HIT THE TRACK GUIDE, FRACTURING THE END OF HIS RIGHT INDEX FINGER.

WHILE CUTTING REPAIR MATERIAL WITH UTILITY KNIFE, CUT THE TIP OF LEFT RING FINGER, AT THE #2 CONVEYOR BELT BEHIND CRUSHER BETWEEN CONTROL ROOM AND DUMP. WAS TOLD BY DR TO KEEP WOUND CLEAN AND CHANGE BANDAGE NIGHTLY FOR 1 WEEK.

EMPLOYEE WAS HELPING TO REMOVE A GEAR COVER ON DRAGLINE 28 AND ANOTHER EMPLOYEE HIT THE COVER WITH A HAMMER & KNOCKED PAINT CHIPS OFF. THE CHIPS HIT HIM IN THE FACE AND A CHIP GOT UNDER HIS SA FETY GLASSES & INTO HIS LEFT EYE. HE WENT TO THEDOCTOR ON 11-30-97 & GOT PRSCRIPTION MEDICATION FOR THIS EYE INJURY.

EMPLOYEE STATES WHILE DRIVING BEARING INTO FRAME OF TRUCK, A PIECE OF BEARING BROKE OFF AND LODGED IN HIS THIGH.

EE CUT LEFT RING FINGER WHILE REMOVING UTILITY KNIFE BLADES FROM PACKAGE.

EE WAS JACKING UP AN UPPER RAIL PAD WHEN THE JACK SLIPPED OUT & HIT THE EE IN THE LEG.

KELLY WAS USING A 16PD SLEDGE HAMMER TO DRIVE INTHE LEFT HAND HITCH PIN. HE HIT THE PIN 3 TIMESAND EACH TIME MOVED IT.WITHT HE 4TH HIT, THE PINWENT COMPLETELY IN & SMASHED HIS FINGER BETWEEN THE WOODEN HANDLE & THE BOTTOM PIN PLATE BOLT ONTHE HAULER. 3 STITCHES WERE REQUIRED FOR THE LACERATION

AS EMPLOYEE WAS SWINGING A SLEDGE HAMMER OVERHEAD, HE FELT A SHARP PAIN IN THE RIGHT SHOULDER.

EMP WAS CUTTING RUBBER COVER OFF OF CONVEYOR BELT WHEN HIS HAND SLIPPED CAUSING HIM TO CUT HIMSELF IN THE LEG. THE LACERATION REQUIRED FOUR STITCHES.

EE WAS TIGHTENING ROLLER CAP BOLTS ON THE UNDERCARRIAGE OF A BACKHOE USING A 8 LB HAMMER AND A HAMMER IN HIS RIGHT HAND. ABOUT THEE 4TH HIT, THE WRENCH SLIPPED AND HE HELD ONTO THE WRENCH, HI TTING AND CUTTING HIS LITTLE FINGER. STITCHES WERE REQUIRED FOR THE LACERATION AND HIS FINGERNAIL ALSO HAD TO BE REMOVED. IT IS UNKNOWN EXACTLY WHAT HE HIT HIS FINGER ON OR AGAINST.

THE TIRE HAND BROKE WHILE INFLATING TIRE. BRUISED LEFT SHOULDER AND TWISTED RIGHT KNEE. BE ON LIGHT DUTY FOR APPROX. 1 WEEK.

HE WAS SETTING A JACK IN PLACE TO CHANGE A TIRE OUT ON A WATER WAGON WHEN HIS HAND WAS CAUGHT BETWEEN THE MACHINE AND THE JACK HANDLE CUTTING THE BACK OF HIS RIGHT HAND. THE CUT REQUIRED STITC HES.

WHILE PRYING ON A PINION GEAR THE PRYBAR SLIPPED CAUSING EE TO HIT A FIRE SPRINKLER WITH HIS LEFT SHOULDER. THIS CAUSED A CUT 1-1\2" LONG ON HIS SHOULDER.

WHILE USING A UTILITY KNIFE TO CUT AND STRIP RUBBER OFF OF BELT CABLE, THE KNIFE SLIPPED AND STRUCK THE INSIDE OF HIS LEFT KNEE CUTTING IT APPROX 1/2". THE LACERATION REQUIRED 5 STITCHES.

WHILE REMOVING WEDGE BAND OFF DRIVE AXLE TIRE, WEDGE BAND BROKE LOOSE WHEN PULLING DOWN ON TIRE BAR AND JAMMED LEFT SHOULDER, UPPER BACK, AN NECK.

EE WAS CLEANING THE DIRT OFF THE DECK OF THE BUCKETWHEEL USING A SHOVEL AND SOMETHING GOT IN HIS LEFT EYE. HIS EYE WAS FLUSHED OUT BUT CONTINUED TO BOTHER HIM. HE SAW A DR. THAT NIGHT AND A PR ESCRIPTION WAS ISSUED TO EE FOR PAIN.

INJURED WAS INSTALLING THE SWING PINION ON THE SWING SHAFT. HE HAD STARTED TWO BOLTS THROUGH THE RETAINER. HE WAS WORKING IN A TIGHT SPACE AND WAS REPOSITIONING HIMSELF TO START ADDITIONAL B OLS WHEN ONE OF THE BOLTS DROPPED OUT AND HIT HIM BETWEEN THE EYES, CUTTING HIM. THREE STITCHES WERE REQUIRED TO CLOSE HTE LACERATION.

WHILE CUTTING BRASS NUT OFF SPUD WITH HAMMER AND CHISEL THE CHISEL SLIPPED CUTTING THE EMPLOYEES LITTLE FINGER BY THE MIDDLE KNUCKLE REQUIRED 3 STITCHES.

INJURED WAS REMOVING A LINE FROM A FOUR SPOOL VALVE ON AN O&K BACKHOE. HE WAS USING A HAMEMR WRENCH AND A 4 POUND SLEDGE HAMMER. WHEN HE STRUCK THE WRENCH WITH THE HAMMER, HE HIT HIS LEFT IND EX FINGER, CUTTING IT. STITCHES WRERE REQUIRED.

EE & EE WERE WORKING ON A WATER TRUCK BRAKE JOB EE WAS TAKING THE DRUM OFF & EE WAS USING A HAMMER & PUNCH TO KNOCK OUT THE RACE BEARING AS EE HIT THE PUNCH A PIECE OF METAL BROKE OFF OF THE B EARING & HIT EE ON THE RT SIDE OF HIS NECK STITCHES WERE REQUIRED AFTER THE METAL WAS REMOVED BY A PHYSICIAN

INJURED WAS USING A CHIPPING HAMMER TO CHIP EXCESS MATERIAL OFF OF A BUCKETWHEEL BUCKET. A PIECE OF METAL CAME OFF, WENT THROUGH HIS GLOVE AND EMBEDDED IN HIS RIGHT THUMB. THE DOCTOR ATTEMPT ED TO REMOVE THE FOREIGN BODY, BUT LEFT IT IN. TWO STITCHES WERE REQUIRED DURING THIS PROCEDURE.

INJURED HIT A RIPPER TOOTH WITH A 10 POUND HAMMER AND A PIECE OF METAL FROMT HE TOOTH CAME OFF AND EMBEDDED IN HIS ARM. STITCHES REQUIRED.

INJURED WAS HITTING A PIN ON AFRONT END LOADER AND A PIECE OF METAL CAME OFF THE SLEDGE HAMMER HE WAS USING AND EMBEDDED IN HIS THIGH. STITCHES WERE REQUIRED AFTER THE REMOVAL OF THE METAL ON SEPT 8, 1992.

INJURED WAS HOLDING A HAMEMR AGAINST A KEY (LOGN PIECE OF METAL) AS ANTOHER EMPLOYEE WAS HTTING INJURED'S HAMMER WITH A 12# SLEDGE HAMMER TOKNOCK KEY INTO ARMATURE SHAFT. A PIECE OF METAL CHI PED OFF OF HIS HAMEMR AND EMBEDDED IN HIS RIGHT HAND. STITCHES WERE REQUIRED AFTER REMOVAL OF PIECE OF METAL.

RIGHT THUMB CAUGHT BETWEEN PIPE WRENCH & RIG WHILE BREAKING BIT LOOSE.CUT OPEN END OF RIGHT THUMB.

USING JACK TO PRESS ON BEARINGS ON SHAFT. JACK SLIPPED AND HIT HAND.

DRIVING PIN WITH HAMMER, IT CAME OFF STRUCK CHIN 4 STITCHES

I.NAME CUTTING DOWN A FENCE.BENT OVER TO PICK UP HAMMER WHICH WAS UNDER THE FENCE.LIFTED THE FENCE WITH ONE HAND AND PULLED HAMMER OUT WITH THE OTHER HAND AND THEN FELT PAIN IN LOWER BACK.STAR TED TO LOSE TIME DUE TO THIS INJURY 2-18-92.

EMPL SUSTAINED A 2" CUTE ABOVE RIGHT KNEE REQ 4 INTERNAL AND 5 EXTERNAL STITCHES AFTER A UTILITY KNIFE SLIPPED WHILE CUTTING RUBBER AWAY FROM STEEL CABLES ON THE FACE CONVEYOR BELT.

INJURED WAS USING A SLEDGE HAMMER TO BEAT OUT A FITTING .IN THE PROCESS HE PINCHED HIS FINGER BETWEEN THE HANDLE AND THE FITTING.THE IMPACT FRACTURED THE END OF HIS FINGER.

REMOVING BOLTS FROM OIL PAN SUPPORT BAR-BAR FELL MASHING LEFT INDEX FINGER.

EE WAS USING A MACHETE TO CUT SMALL UNDERBRUSH TO CLEAR AN AREA FOR SURVEYING. WHILE CUTTING, A THORN, APPROX. 1/2 INCH LONG, ENTERED THE KNUCKLE AREA OF HIS RIGHT MIDDLE FINGER. SINCE IT WAS FLUSH WITH THE SKIN, HE WAS TAKEN TO A PHYSICIANTO REMOVE THE THORN. SUTURES WERE REQUIRED TO CLOSE THE INCISION MADE BY THE PHYSICIAN.

HE WAS USING A PIECE OF PIPE TO REMOVE A TRANSMISSION MOUNT BOLT. THE PIPE SLIPPED, CAUSING THE END TO HIT HIM IN THE FOREHEAD ABOVE HIS LEFT EYE. THE PIPE CUT THE SKIN IN THE SHAPE OF A SEMI- CIRCLE, REQUIRING THREE STITCHES TO CLOSE TO PREVENT A SCAR. NO OTHER INJURIES WERE SUSTAINED.

EMPLOYEE WAS REMOVING MASKING TAPE AND PAPER FROM ELECTRICAL CONDUIT WITH RAZOR BLADE. EMPLOYEE SLICED THROUGH TAPE AND INTO LEFT HAND.

USING 20 LB SELDGE HAMMER TO DRIVE BUCKET PIN. IN PROCESS FELT LOWER BACK PAIN ATER MORE THAN TWO WEEKS WENT TO DR FORM DIAGNOSIS. EXAM REVEALED LOWER BACK SPRAIN. MED PRESCRIB

I NAME WAS USING A SLEDGE HAMMER TO DRIVE IN A KEEPER ON A BUCKET TOOTH WHILE POUNDING THE KEEPER A PIECE OF METAL CAME OFF THE KEEPER AND STRUCK I NAME IN THE R ARM THE WOUND REQUIRED TWO STI TCHES

INJURED WAS USING A JACK TO POSITION A ROLLER FOR INSTALLATION TO THE ROLLER FRAME. THE ROLLER WAS IN A LIFTING BRACKE BUT WITH A LOOSE FIT. THE ROLLER SLIPPED FROM THE LIFTING BRACKET AND F ELL ON HIS LEFT INDEX FINGER, CAUSING A FRACTURE AND LACERATION. THE FINGER REQUIRED SUTURES ADN SPLINTING.

EMPLOYEE WAS STRIPPING INSULATION OFF ELECTRICAL WIRE WITH POCKET KNIFE & SLIPPED & STABBED HIMSELF IN LEFT FOREARM

LOWERING ROLLER IN PLACE MAN ATCHING TENSION ON COME A LONG ROLLER EASED DOWN SET ON L FT. STEEL TOE BOOT TRAPPED PRESSURE FORM LOWER ROLLER MASHED FT BEFORE COUD SIGNAL MENT OT HAVE ROLLER R AISED

I.NAME WAS ATTEMPTING TO REMOVE A RETAINER PLATE FROM A SLEW GEAR WHICH WAS ALLEGED TO HAVE BEEN FROZE FIT TO THE SHAFT. AFTER TAKING THE BOLT OUT OF THE PLATE, HE TAPPED THE GEAR WITH A SLEDG E HAMMER AND THE GEAR FELL APPROX. 34" ONTO A PLATFORM WHICH I.NAME WAS KNEELING ON AND THE GEAR MOMENTARILY PINCHED HIS HAND BETWEEN IT AND THE PLATFORM.

I,NAME ATTEMTPING TO DRIVE A 9" FLANGED PIN INTO A BUSHING. WHILE DRIVING THE PIN IN WITH A SLEDGE HAMMER, HE CAUGHT TWO FINGERS BETWEEN THE FLANGE AND THE FACE AROUND THE BUSHING. HE BRUISED HIS FIRST AND MIDDLE FINGERS ON HIS LEFT HAND AND SUSTAINED A HAIRLINE CRACK ON HIS FIRST FINGER.

EMPLOYEE WAS HOLDING A WRENCH UNSCREWING DRILL STRING PIPE HE INADVERTENTLY PLACED HIS FINGER BETWEEN THE WRENCH HANDLE AND DERRICK LEG THUS SMASHING HIS LEFT INDEX FINGER.

I.NAME WAS PUTTING BELLY PAN ON A 631 SCRAPER WHEN THE CABLE HOLDING IT BROKE THE BELLY PAN HIT HIS LEFT KNEE